stmmac: fix rx checksum programming

This patch is to fix the IPC bit into the GMAC control register
that must be done after the core initialization otherwise it will
not have any effect.
Signed-off-by: NGiuseppe Cavallaro <peppe.cavallaro@st.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

drivers/net/ethernet/stmicro/stmmac/stmmac_main.c

@@ -1637,6 +1637,12 @@ static int stmmac_hw_setup(struct net_device *dev)
 	/* Initialize the MAC Core */
 	priv->hw->mac->core_init(priv->hw, dev->mtu);
 
+	ret = priv->hw->mac->rx_ipc(priv->hw);
+	if (!ret) {
+		pr_warn(" RX IPC Checksum Offload disabled\n");
+		priv->plat->rx_coe = STMMAC_RX_COE_NONE;
+	}
+
 	/* Enable the MAC Rx/Tx */
 	stmmac_set_mac(priv->ioaddr, true);
 
@@ -2592,7 +2598,6 @@ static const struct net_device_ops stmmac_netdev_ops = {
  */
 static int stmmac_hw_init(struct stmmac_priv *priv)
 {
-	int ret;
 	struct mac_device_info *mac;
 
 	/* Identify the MAC HW device */
@@ -2649,12 +2654,6 @@ static int stmmac_hw_init(struct stmmac_priv *priv)
 	/* To use alternate (extended) or normal descriptor structures */
 	stmmac_selec_desc_mode(priv);
 
-	ret = priv->hw->mac->rx_ipc(priv->hw);
-	if (!ret) {
-		pr_warn(" RX IPC Checksum Offload not configured.\n");
-		priv->plat->rx_coe = STMMAC_RX_COE_NONE;
-	}
-
 	if (priv->plat->rx_coe)
 		pr_info(" RX Checksum Offload Engine supported (type %d)\n",
 			priv->plat->rx_coe);