Some board variant fixes (#6411)

* make work with rev C pcb

* use #define for easy testing

variants/adafruit_feather_esp32_v2/pins_arduino.h

@@ -42,20 +42,19 @@ static const uint8_t A9 = 33;
 static const uint8_t A10 = 27;
 static const uint8_t A11 = 12;
 static const uint8_t A12 = 13;
+static const uint8_t A13 = 35;
 
 // vbat measure
-static const uint8_t BATT_MONITOR = 35;
-static const uint8_t A13 = 35;
+#define BATT_MONITOR 35
 
 // internal switch
-static const uint8_t BUTTON = 38;
+#define BUTTON = 38;
 
 // Neopixel
-static const uint8_t NEOPIXEL_PIN = 0;
-static const uint8_t PIN_NEOPIXEL = 0;
+#define PIN_NEOPIXEL 0
 
 // Neopixel & I2C power
-static const uint8_t NEOPIXEL_I2C_POWER = 2;
+#define NEOPIXEL_I2C_POWER 2
 
 static const uint8_t T0 = 4;
 static const uint8_t T1 = 0;

variants/adafruit_feather_esp32s2/variant.cpp

@@ -36,10 +36,11 @@ void initVariant(void)
   pinMode(NEOPIXEL_POWER, OUTPUT);
   digitalWrite(NEOPIXEL_POWER, HIGH);
 
-  // This board has a power control pin, and we must set it to output and low
-  // in order to enable the I2C port.
+  // turn on the I2C power by setting pin to opposite of 'rest state'
+  pinMode(PIN_I2C_POWER, INPUT);
+  delay(1);
+  bool polarity = digitalRead(PIN_I2C_POWER);
   pinMode(PIN_I2C_POWER, OUTPUT);
-  digitalWrite(PIN_I2C_POWER, LOW);
+  digitalWrite(PIN_I2C_POWER, !polarity);
 }
-
 }

variants/adafruit_qtpy_esp32c3/pins_arduino.h

@@ -11,8 +11,8 @@
 #define digitalPinToInterrupt(p)    (((p)<NUM_DIGITAL_PINS)?(p):-1)
 #define digitalPinHasPWM(p)         (p < EXTERNAL_NUM_INTERRUPTS)
 
-static const uint8_t SWITCH = 9;
-static const uint8_t NEOPIXEL_PIN = 2;
+#define BUTTON 9
+#define PIN_NEOPIXEL 2
 
 static const uint8_t TX = 21;
 static const uint8_t RX = 20;