candle， 维宏雕刻机 50mm高度内对刀命令 : G90G21G38.2Z-50F100; G92Z1.6; G0Z20

GCode 移动到任意坐标点: G00 X0.0 Y0.0 Z2.0 : 移动到坐标点(0,0,2)

#以下内容是cncjs 刚连接上雕刻机 给出的输出
CNCjs 1.10.3 [Grbl]
已连接端口COM4，波特率115200
Grbl 1.1f ['$' for help]
client> $$
$0=10 (Step pulse time, microseconds)
$1=25 (Step idle delay, milliseconds)
$2=0 (Step pulse invert, mask)
$3=6 (Step direction invert, mask)
$4=0 (Invert step enable pin, boolean)
$5=0 (Invert limit pins, boolean)
$6=0 (Invert probe pin, boolean)
$10=1 (Status report options, mask)
$11=0.010 (Junction deviation, millimeters)
$12=0.002 (Arc tolerance, millimeters)
$13=0 (Report in inches, boolean)
$20=0 (Soft limits enable, boolean)
$21=0 (Hard limits enable, boolean)
$22=0 (Homing cycle enable, boolean)
$23=0 (Homing direction invert, mask)
$24=25.000 (Homing locate feed rate, mm/min)
$25=500.000 (Homing search seek rate, mm/min)
$26=250 (Homing switch debounce delay, milliseconds)
$27=1.000 (Homing switch pull-off distance, millimeters)
$30=1000 (Maximum spindle speed, RPM)
$31=0 (Minimum spindle speed, RPM)
$32=0 (Laser-mode enable, boolean)
$100=800.000 (X-axis travel resolution, step/mm)
$101=800.000 (Y-axis travel resolution, step/mm)
$102=800.000 (Z-axis travel resolution, step/mm)
$110=1000.000 (X-axis maximum rate, mm/min)  #这说明 $110=100 应该是降低y轴移动速率
$111=1000.000 (Y-axis maximum rate, mm/min)  #这说明 $111=100 应该是降低y轴移动速率
$112=600.000 (Z-axis maximum rate, mm/min)   #执行语句 $112=100 确实能降低z轴移动速率
$120=30.000 (X-axis acceleration, mm/sec^2)
$121=30.000 (Y-axis acceleration, mm/sec^2)
$122=30.000 (Z-axis acceleration, mm/sec^2)
$130=200.000 (X-axis maximum travel, millimeters)
$131=200.000 (Y-axis maximum travel, millimeters)
$132=200.000 (Z-axis maximum travel, millimeters)

猜测:

• z轴移动速率设置为100mm/min: $112=100, 原值是600mm/min
• y轴移动速率设置为100mm/min: $111=100, 原值是1000mm/min
• x轴移动速率设置为100mm/min: $110=100, 原值是1000mm/min