- 19 8月, 2008 11 次提交
-
-
由 Yoshihiro Shimoda 提交于
This patch fixes a problem that RTL8110SCL started transfer with an incorrect memory address. Signed-off-by: NYoshihiro Shimoda <shimoda.yoshihiro@renesas.com> Signed-off-by: NBen Warren <biggerbadderben@gmail.com>
-
由 TsiChung Liew 提交于
The received status and len was in little endian format and caused the ethernet unable to proceed further. Add __le16_to_cpu() in dm9000_rx_status_8/16/32bit(). Signed-off-by: NTsiChung Liew <Tsi-Chung.Liew@freescale.com> Signed-off-by: NBen Warren <biggerbadderben@gmail.com>
-
由 Kumar Gala 提交于
There is no point in disabling the icache on 7xx/74xx/86xx parts and not also flushing the icache. All callers of invalidate_l1_instruction_cache() call icache_disable() right after. Make it so icache_disable() calls invalidate_l1_instruction_cache() for us. Also, dcache_disable() already calls dcache_flush() so there is no point in the explicit calls of dcache_flush(). Signed-off-by: NKumar Gala <galak@kernel.crashing.org>
-
由 Kumar Gala 提交于
The ePAPR spec has some subtle differences from the current device tree based boot interface to the powerpc linux kernel. The powerpc linux kernel currently ignores the differences that ePAPR specifies. Signed-off-by: NKumar Gala <galak@kernel.crashing.org>
-
由 Wolfgang Denk 提交于
Signed-off-by: NWolfgang Denk <wd@denx.de>
-
由 Ricardo Ribalda Delgado 提交于
Signed-off-by: NRicardo Ribalda Delgado <ricardo.ribalda@uam.es>
-
由 Michal Simek 提交于
Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Michal Simek 提交于
Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Michal Simek 提交于
Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Harald Welte 提交于
The 'license' command includes the U-Boot license (GPLv2) into the actual bootloader binary. The license text can be shown interactively at the U-Boot commandline. For products where the commandline can actually be accessed by the end user, this helps to prevent inadvertent GPL violations, since the GPLv2 license text can no longer be 'forgotten' to be included into the product. The 'license' command can be enabled by CONFIG_CMD_LICENSE. Signed-off-by: NHarald Welte <laforge@openmoko.org>
-
由 Harald Welte 提交于
[PATCH] add new 'unzip' command to u-boot commandline common/cmd_mem.c: new command "unzip srcaddr dstaddr [dstsize]" to unzip from memory to memory, and option CONFIG_CMD_UNZIP to enable it Signed-off-by: NWerner Almesberger <werner@openmoko.org> Signed-off-by: NHarald Welte <laforge@openmoko.org>
-
- 15 8月, 2008 13 次提交
-
-
由 TsiChung Liew 提交于
The CFG_ENV_SIZE is not suitable used for SPI flash erase sector size if CFG_ENV_SIZE is less than CFG_ENV_SECT_SIZE. Add condition check if CFG_ENV_SIZE is larger than CFG_ENV_SECT_SIZE, calculate the right number of sectors for erasing. Signed-off-by: NTsiChung Liew <Tsi-Chung.Liew@freescale.com>
-
由 TsiChung Liew 提交于
Incorrect CFG_HZ value, change 1000000 to 1000. Rename #waring to #warning. RAMBAR1 uses twice in start.S, rename the later to FLASHBAR. Insert nop for DRAM setup. And, env_offset in linker file. Signed-off-by: NTsiChung Liew <Tsi-Chung.Liew@freescale.com>
-
由 TsiChung Liew 提交于
Signed-off-by: NTsiChung Liew <Tsi-Chung.Liew@freescale.com>
-
由 TsiChung Liew 提交于
Signed-off-by: NTsiChung Liew <Tsi-Chung.Liew@freescale.com>
-
由 TsiChung Liew 提交于
Signed-off-by: NTsiChung Liew <Tsi-Chung.Liew@freescale.com>
-
由 TsiChung Liew 提交于
Signed-off-by: NTsiChung Liew <Tsi-Chung.Liew@freescale.com>
-
由 TsiChung Liew 提交于
Signed-off-by: NTsiChung Liew <Tsi-Chung.Liew@freescale.com>
-
由 TsiChung Liew 提交于
Signed-off-by: NTsiChung Liew <Tsi-Chung.Liew@freescale.com>
-
由 TsiChung Liew 提交于
Signed-off-by: NTsiChung Liew <Tsi-Chung.Liew@freescale.com>
-
由 TsiChung Liew 提交于
Remove non-common flash driver in board/freescale/m54455evb/flash.c. The non-cfi flash will use CONFIG_FLASH_CFI_LEGACY to configure the flash attribute. Signed-off-by: NTsiChung Liew <Tsi-Chung.Liew@freescale.com>
-
由 TsiChung Liew 提交于
Signed-off-by: NTsiChung Liew <Tsi-Chung.Liew@freescale.com>
-
由 TsiChung Liew 提交于
Signed-off-by: NTsiChung Liew <Tsi-Chung.Liew@freescale.com>
-
由 TsiChung Liew 提交于
Signed-off-by: NTsiChung Liew <Tsi-Chung.Liew@freescale.com>
-
- 14 8月, 2008 11 次提交
-
-
-
由 Wolfgang Denk 提交于
Signed-off-by: NWolfgang Denk <wd@denx.de>
-
-
由 Stefan Roese 提交于
-
由 Scott Wood 提交于
Also, fix some minor formatting issues, and simplify the handling of "state" for writes. Signed-off-by: NScott Wood <scottwood@freescale.com>
-
由 Scott Wood 提交于
Signed-off-by: NScott Wood <scottwood@freescale.com>
-
由 Scott Wood 提交于
Signed-off-by: NScott Wood <scottwood@freescale.com>
-
由 Scott Wood 提交于
Signed-off-by: NScott Wood <scottwood@freescale.com>
-
-
由 Scott Wood 提交于
Signed-off-by: NScott Wood <scottwood@freescale.com>
-
由 Kyungmin Park 提交于
Since page size field is changed from oobblock to writesize. But OneNAND is not updated. - fix bufferram management at erase operation This patch includes the NAND/OneNAND state filed too. Signed-off-by: NKyungmin Park <kyungmin.park@samsung.com> Signed-off-by: NScott Wood <scottwood@freescale.com>
-
- 13 8月, 2008 5 次提交
-
-
由 Stefan Roese 提交于
-
Signed-off-by: NJean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
-
rename CFG_NAND_LEGACY to CONFIG_NAND_LEGACY Signed-off-by: NJean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
-
Signed-off-by: NJean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
-
rename CFG_FLASH_CFI_DRIVER to CONFIG_FLASH_CFI_DRIVER Signed-off-by: NJean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
-