- 08 3月, 2008 6 次提交
-
-
-
-
由 Heiko Schocher 提交于
initialize the UPIOx controller. Signed-off-by: NHeiko Schocher <hs@denx.de>
-
由 Heiko Schocher 提交于
add support for the config Flash. initialize the UPIOx controller. Signed-off-by: NHeiko Schocher <hs@denx.de>
-
由 Kim Phillips 提交于
the dts file basenames were updated in linux - this helps avoid inadvertently loading any old dtbs laying around. Signed-off-by: NKim Phillips <kim.phillips@freescale.com>
-
由 Kim Phillips 提交于
allow u-boot to recover (and, e.g., switch to another interface) in the case where a PHY does not report autonegotiation is complete within its two second timeout value. Signed-off-by: NKim Phillips <kim.phillips@freescale.com>
-
- 07 3月, 2008 5 次提交
-
-
由 Markus Brunner 提交于
The taihu board used gpio_read_out_bit which reads the output register and not the pin state. Signed-off-by: NMarkus Brunner <super.firetwister@gmail.com>
-
由 Stefan Roese 提交于
Signed-off-by: NStefan Roese <sr@denx.de>
-
由 Stefan Roese 提交于
-
由 Dave Liu 提交于
1. Make the CSB bus pipeline depth as 4, and enable the repeat mode; 2. Raise the eTSEC emergency priority; 3. Use the highest IP blocks clock. Signed-off-by: NDave Liu <daveliu@freescale.com>
-
由 Detlev Zundel 提交于
The latter version stops when "run load" fails for whatever reasons rendering the combination *a lot* more secure. Signed-off-by: NDetlev Zundel <dzu@denx.de>
-
- 06 3月, 2008 1 次提交
-
-
由 Stefan Roese 提交于
-
- 05 3月, 2008 6 次提交
-
-
-
由 Stefan Roese 提交于
This patch fixes a problem seen on PPC4xx boards, when no MAC address is defined. Then no ethernet interface is available but a simple "tftp" command will return without any error message which is quite confusing. Signed-off-by: NStefan Roese <sr@denx.de>
-
由 Jon Loeliger 提交于
Many of the spd.h #includers don't need it, and wanted to have spd_sdram() declared instead. Since they didn't get that, some also had open coded extern declarations of it instead or as well. Fix it all up by using spd_sdram.h where needed. Signed-off-by: NJon Loeliger <jdl@freescale.com>
-
由 Wolfgang Denk 提交于
Signed-off-by: NWolfgang Denk <wd@denx.de>
-
由 Stefan Roese 提交于
This patch fixes a problem seen on PPC4xx boards, when no MAC address is defined. Then no ethernet interface is available but a simple "tftp" command will return without any error message which is quite confusing. Signed-off-by: NStefan Roese <sr@denx.de>
-
由 Wolfgang Denk 提交于
Signed-off-by: NWolfgang Denk <wd@denx.de>
-
- 04 3月, 2008 6 次提交
-
-
由 Wolfgang Denk 提交于
Commit 5013c09f (Makefile: cleanup "clean" target) introduced a problem for out-of-tree builds which caused "make clean" to fail. Signed-off-by: NWolfgang Denk <wd@denx.de>
-
由 Wolfgang Denk 提交于
Signed-off-by: NWolfgang Denk <wd@denx.de>
-
由 Mike Nuss 提交于
Every now and then a Sequoia board (or equivalent hardware) had problems connecting to a Gigabit capable network interface. There were differences in the PHY setup between Linux and U-Boot. This patch fixes the problem. Apparently "remote fault" is being set, which signals to some devices (on the other end of the cable) that a fault has occurred, while other devices ignore it. I believe the RF bit was causing the issue, but I removed T4 also, to match up with Linux. Signed-off-by: NMike Nuss <mike@terascala.com>
-
由 Timur Tabi 提交于
Fix a typo in qe_upload_firmware() that prevented uploading firmware on systems with more than one RISC core. Signed-off-by: NTimur Tabi <timur@freescale.com>
-
由 Bernhard Nemec 提交于
Originally pointed out by Laurent Pinchart <laurent.pinchart@tbox.biz>, see http://thread.gmane.org/gmane.comp.boot-loaders.u-boot/22846 Signed-off-by: Bernhard Nemec <bnemec <at> ganssloser.com>
-
由 Kim B. Heino 提交于
If I try to "cp.b <ram> <dataflash>", u-boot selects normal flash routines instead of dataflash. This is because it checks "if source address is not dataflash" instead of target address. Signed-off-by: NKim B. Heino <Kim.Heino@bluegiga.com>
-
- 03 3月, 2008 16 次提交
-
-
由 Wolfgang Denk 提交于
Signed-off-by: NWolfgang Denk <wd@denx.de>
-
由 Wolfgang Denk 提交于
Signed-off-by: NWolfgang Denk <wd@denx.de>
-
Signed-off-by: NJean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
-
由 michael 提交于
This fixes the cluster size tests in the FAT32 file system. The current implementation of VFAT support doesn't work if the referred cluster has an offset > 16bit representation, causing "fatload" and "fatls" commands etc. to fail. Signed-off-by: Nmichael trimarchi <trimarchi@gandalf.sssup.it>
-
由 Wolfgang Denk 提交于
Signed-off-by: NWolfgang Denk <wd@denx.de>
-
由 Stefan Roese 提交于
The 405EZ only supports 512 bytes of rx-/tx-fifo EMAC sizes. But currently 4k/2k is configured. This patch fixes this issue. Thanks to Thomas Kindler <tkindler@lenord.de> for pointing this out. Signed-off-by: NStefan Roese <sr@denx.de>
-
由 Woodruff, Richard 提交于
Fix alignment fault on ARM when running modules. With out an explicit linker file gcc4.2.1 will half word align __bss_start's value. The word dereference will crash hello_world. signed-off-by Richard Woodruff <r-woodruff2@ti.com>
-
由 Dave Liu 提交于
The ext2 aligned process will corrupt the key data struct, the patch fix this. Signed-off-by: NDave Liu <daveliu@freescale.com>
-
由 Wolfgang Denk 提交于
Make sure CDPATH settings cannot interfere. Update CHANGELOG. Signed-off-by: NWolfgang Denk <wd@denx.de>
-
由 Li Yang 提交于
Add cscope build target to generate cscope database for code browsing. Signed-off-by: NLi Yang <leoli@freescale.com>
-
由 Kim Phillips 提交于
erratum 5.6 states the autoneg completion bit is functional only if the autoneg bit is asserted. This fixes any secondarily-issued networking commands on non-gigabit links on the mpc8360 mds board. Signed-off-by: NKim Phillips <kim.phillips@freescale.com>
-
-
由 John Rigby 提交于
Adds PCI support for MPC5121 Tested with drivers/net/rtl8139.c Support is conditional since PCI on old silicon does not work. ads5121_PCI_config turns on PCI In this version, condition compilation of PCI code has been moved from ifdef in board/ads5121/pci.c to board/ads5121/Makefile as suggested by Jean-Christophe PLAGNIOL-VILLARD Signed-off-by: NJohn Rigby <jrigby@freescale.com>
-
由 Anatolij Gustschin 提交于
Fix warnings while compilation with new gcc in eldk-4.2 Signed-off-by: NAnatolij Gustschin <agust@denx.de>
-
-
由 Anatolij Gustschin 提交于
U-Boot crashes in the net loop if CONFIG_4xx_DCACHE is enabled. To reproduce the problem ensure that 'ethrotate' environment variable isn't set to "no" and then run "tftp 200000 not_existent_file". This patch tries to fix the issue. Signed-off-by: NAnatolij Gustschin <agust@denx.de>
-