Handle FADT 2.0 xpmtmr address 0 case.

http://bugzilla.kernel.org/show_bug.cgi?id=5283

Signed-off-by: Shaohua Li<shaohua.li@intel.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLen Brown <len.brown@intel.com>

Needed to make the earlier use disabled CPUs for CPU hotplug patch
actually work.

Need to register disabled processors as well, so we can count them
towards cpu_possible_map as hot pluggable cpus.
Signed-off-by: NAshok Raj <ashok.raj@intel.com>
Signed-off-by: NAndi Kleen <ak@suse.de>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

We should zap the low mappings, as soon as possible, so that we can catch
kernel bugs more effectively. Previously early boot had NULL mapped
and didn't trap on NULL references.

This patch introduces boot_level4_pgt, which will always have low identity
addresses mapped.  Druing boot, all the processors will use this as their
level4 pgt.  On BP, we will switch to init_level4_pgt as soon as we enter C
code and zap the low mappings as soon as we are done with the usage of
identity low mapped addresses.  On AP's we will zap the low mappings as
soon as we jump to C code.
Signed-off-by: NSuresh Siddha <suresh.b.siddha@intel.com>
Signed-off-by: NAshok Raj <ashok.raj@intel.com>
Signed-off-by: NAndi Kleen <ak@suse.de>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Here's a patch that builds on Natalie Protasevich's IRQ compression
patch and tries to work for MPS boots as well as ACPI.  It is meant for
a 4-node IBM x460 NUMA box, which was dying because it had interrupt
pins with GSI numbers > NR_IRQS and thus overflowed irq_desc.

The problem is that this system has 270 GSIs (which are 1:1 mapped with
I/O APIC RTEs) and an 8-node box would have 540.  This is much bigger
than NR_IRQS (224 for both i386 and x86_64).  Also, there aren't enough
vectors to go around.  There are about 190 usable vectors, not counting
the reserved ones and the unused vectors at 0x20 to 0x2F.  So, my patch
attempts to compress the GSI range and share vectors by sharing IRQs.

Cc: "Protasevich, Natalie" <Natalie.Protasevich@unisys.com>
Signed-off-by: NAndi Kleen <ak@suse.de>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

I need the following patch to compile -git8 here, otherwise these
files fail to compile (asm/hw_irq.h needs definitions from
linux/irq.h and that file provides the required include ordering).

I did not do a full audit, though there looks to be many other
places that should get the same treatment, if this is  the right
way to do it.
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

	Most of these guys are simply not needed (pulled by other stuff
via asm-i386/hardirq.h).  One that is not entirely useless is hilarious -
arch/i386/oprofile/nmi_timer_int.c includes linux/irq.h... as a way to
get linux/errno.h
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

i386 generic subarchitecture requires explicit dmi strings or command line
to enable bigsmp mode.  The patch below removes that restriction, and uses
bigsmp as soon as it finds more than 8 logical CPUs, Intel processors and
xAPIC support.
Signed-off-by: NVenkatesh Pallipadi <venkatesh.pallipadi@intel.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Delete the ability to build an ACPI kernel that does
not include PCI support.  When such a machine is created
and it requires a tuned kernel, send a patch.

http://bugzilla.kernel.org/show_bug.cgi?id=1364Signed-off-by: NLen Brown <len.brown@intel.com>

it is a synonym for CONFIG_ACPI
Signed-off-by: NLen Brown <len.brown@intel.com>

it is a synonym for CONFIG_ACPI
Signed-off-by: NLen Brown <len.brown@intel.com>

Signed-off-by: NLen Brown <len.brown@intel.com>

Signed-off-by: NLen Brown <len.brown@intel.com>

Current acpi_register_gsi() function has no way to indicate errors to its
callers even though acpi_register_gsi() can fail to register gsi because of
some reasons (out of memory, lack of interrupt vectors, incorrect BIOS, and so
on).  As a result, caller of acpi_register_gsi() cannot handle the case that
acpi_register_gsi() fails.  I think failure of acpi_register_gsi() should be
handled properly.

This series of patches changes acpi_register_gsi() to return negative value on
error, and also changes callers of acpi_register_gsi() to handle failure of
acpi_register_gsi().

This patch changes the type of return value of acpi_register_gsi() from
"unsigned int" to "int" to indicate an error.  If acpi_register_gsi() fails to
register gsi, it returns negative value.
Signed-off-by: NKenji Kaneshige <kaneshige.kenji@jp.fujitsu.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLen Brown <len.brown@intel.com>

This patch is the first step in properly handling the MCFG PCI table.
It defines the structures properly, and saves off the table so that the
pci mmconfig code can access it.  It moves the parsing of the table a
little later in the boot process, but still before the information is
needed.
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>

This patch adds the following new interfaces for I/O xAPIC
hotplug. The implementation of these interfaces depends on each
architecture.

    o int acpi_register_ioapic(acpi_handle handle, u64 phys_addr,
			       u32 gsi_base);

        This new interface is to add a new I/O xAPIC specified by
        phys_addr and gsi_base pair. phys_addr is the physical address
        to which the I/O xAPIC is mapped and gsi_base is global system
        interrupt base of the I/O xAPIC. acpi_register_ioapic returns
        0 on success, or negative value on error.

    o int acpi_unregister_ioapic(acpi_handle handle, u32 gsi_base);

        This new interface is to remove a I/O xAPIC specified by
        gsi_base. acpi_unregister_ioapic returns 0 on success, or
        negative value on error.
Signed-off-by: NKenji Kaneshige <kaneshige.kenji@jp.fujitsu.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>

This patch moves ACPI sleep quirk out of dmi_scan.c
Signed-off-by: NAndrey Panin <pazke@donpac.ru>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

This patch moves ACPI boot quirks out of dmi_scan.c
Signed-off-by: NAndrey Panin <pazke@donpac.ru>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Noticed by Jakub Jermar <jermar@itbs.cz>

The recent acpi boot patch breaks for me: acpi_fadt needs CONFIG_ACPI_BUS.
Signed-off-By: NChris Wedgwood <cw@f00f.org>
Acked-by: NAndi Kleen <ak@suse.de>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

x86_64 genapic mechanism should be aware of machines that use physical APIC
mode regardless of how many clusters/processors are detected.

ACPI 3.0 FADT makes this determination very simple by providing a feature
flag "force_apic_physical_destination_mode" to state whether the machine
unconditionally uses physical APIC mode.

Unisys' next generation x86_64 ES7000 will need to utilize this FADT
feature flag in order to boot the x86_64 kernel in the correct APIC mode. 
This patch has been tested on both x86_64 commodity and ES7000 boxes.
Signed-off-by: NJason Davis <jason.davis@unisys.com>
Acked-by: NAndi Kleen <ak@suse.de>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.

Let it rip!