Skip to content

K
Kernel

openeuler / Kernel
接近 2 年 前同步成功

通知 8
Star 0
Fork 0
K
Kernel
切换分支/标签
  1. 22 1月, 2016 2 次提交
  3. 24 12月, 2015 11 次提交
  5. 16 11月, 2015 1 次提交
    • T
      net/mlx5e: Added self loopback prevention · 66189961
      由 Tariq Toukan 提交于 
      Prevent outgoing multicast frames from looping back to the RX queue.

By introducing new HW capability self_lb_en_modifiable, which indicates
the support to modify self_lb_en bit in modify_tir command.

When this capability is set we can prevent TIRs from sending back
loopback multicast traffic to their own RQs, by "refreshing TIRs" with
modify_tir command, on every time new channels (SQs/RQs) are created at
device open.
This is needed since TIRs are static and only allocated once on driver
load, and the loopback decision is under their responsibility.

Fixes issues of the kind:
"IPv6: eth2: IPv6 duplicate address fe80::e61d:2dff:fe5c:f2e9 detected!"
The issue is seen since the IPv6 solicitations multicast messages are
loopedback and the network stack thinks they are coming from another host.

Fixes: 5c50368f ("net/mlx5e: Light-weight netdev open/stop")
Signed-off-by: NTariq Toukan <tariqt@mellanox.com>
Signed-off-by: NSaeed Mahameed <saeedm@mellanox.com>
Signed-off-by: NOr Gerlitz <ogerlitz@mellanox.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      66189961
  7. 15 10月, 2015 3 次提交
  9. 09 10月, 2015 2 次提交
  11. 29 9月, 2015 1 次提交
  13. 25 9月, 2015 1 次提交
    • S
      IB/mlx5: Remove support for IB_DEVICE_LOCAL_DMA_LKEY · c6790aa9
      由 Sagi Grimberg 提交于 
      Commit 96249d70 ("IB/core: Guarantee that a local_dma_lkey
is available") allows ULPs that make use of the local dma key to keep
working as before by allocating a DMA MR with local permissions and
converted these consumers to use the MR associated with the PD
rather then device->local_dma_lkey.

ConnectIB has some known issues with memory registration
using the local_dma_lkey (SEND, RDMA, RECV seems to work ok).

Thus don't expose support for it (remove device->local_dma_lkey
setting), and take advantage of the above commit such that no regression
is introduced to working systems.

The local_dma_lkey support will be restored in CX4 depending on FW
capability query.
Signed-off-by: NSagi Grimberg <sagig@mellanox.com>
Signed-off-by: NDoug Ledford <dledford@redhat.com>
      c6790aa9
  15. 29 8月, 2015 1 次提交
  17. 18 8月, 2015 2 次提交
  19. 07 8月, 2015 3 次提交
  21. 27 7月, 2015 3 次提交
    • A
      net/mlx5e: TX latency optimization to save DMA reads · 88a85f99
      由 Achiad Shochat 提交于 
      A regular TX WQE execution involves two or more DMA reads -
one to fetch the WQE, and another one per WQE gather entry.

These DMA reads obviously increase the TX latency.
There are two mlx5 mechanisms to bypass these DMA reads:
1) Inline WQE
2) Blue Flame (BF)

An inline WQE contains a whole packet, thus saves the DMA read/s
of the regular WQE gather entry/s. Inline WQE support was already
added in the previous commit.

A BF WQE is written directly to the device I/O mapped memory, thus
enables saving the DMA read that fetches the WQE.

The BF WQE I/O write must be in cache line granularity, thus uses
the CPU write combining mechanism.
A BF WQE I/O write acts also as a TX doorbell for notifying the
device of new TX WQEs.
A BF WQE is written to the same I/O mapped address as the regular TX
doorbell, thus this address is being mapped twice - once by ioremap()
and once by io_mapping_map_wc().

While both mechanisms reduce the TX latency, they both consume more CPU
cycles than a regular WQE:
- A BF WQE must still be written to host memory, in addition to being
  written directly to the device I/O mapped memory.
- An inline WQE involves copying the SKB data into it.

To handle this tradeoff, we introduce here a heuristic algorithm that
strives to avoid using these two mechanisms in case the TX queue is
being back-pressured by the device, and limit their usage rate otherwise.

An inline WQE will always be "Blue Flamed" (written directly to the
device I/O mapped memory) while a BF WQE may not be inlined (may contain
gather entries).

Preliminary testing using netperf UDP_RR shows that the latency goes down
from 17.5us to 16.9us, while the message rate (tested with pktgen) stays
the same.
Signed-off-by: NAchiad Shochat <achiad@mellanox.com>
Signed-off-by: NAmir Vadai <amirv@mellanox.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      88a85f99
    • S
      net/mlx5e: Allocate DMA coherent memory on reader NUMA node · 311c7c71
      由 Saeed Mahameed 提交于 
      By affinity hints and XPS, each mlx5e channel is assigned a CPU
core.

Channel DMA coherent memory that is written by the NIC and read
by SW (e.g CQ buffer) is allocated on the NUMA node of the CPU
core assigned for the channel.

Channel DMA coherent memory that is written by SW and read by the
NIC (e.g SQ/RQ buffer) is allocated on the NUMA node of the NIC.

Doorbell record (written by SW and read by the NIC) is an
exception since it is accessed by SW more frequently.
Signed-off-by: NSaeed Mahameed <saeedm@mellanox.com>
Signed-off-by: NAmir Vadai <amirv@mellanox.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      311c7c71
    • S
      net/mlx5e: Support ETH_RSS_HASH_XOR · 2be6967c
      由 Saeed Mahameed 提交于 
      The ConnectX-4 HW implements inverted XOR8.
To make it act as XOR we re-order the HW RSS indirection table.

Set XOR to be the default RSS hash function and add ethtool API to
control it.
Signed-off-by: NSaeed Mahameed <saeedm@mellanox.com>
Signed-off-by: NAmir Vadai <amirv@mellanox.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      2be6967c
  23. 12 6月, 2015 2 次提交
  25. 08 6月, 2015 1 次提交
  27. 05 6月, 2015 7 次提交