In 2002, STMicro started producing NOR flashes with internal ECC protection
for small blocks (8 or 16 bytes).  Support for those flashes was added by me.
In 2005, Intel Sibley flashes copied this strategy and Nico added support for
those.  Merge the code for both.
Signed-off-by: NJoern Engel <joern@wh.fh-wedel.de>

At least two flashes exists that have the concept of a minimum write unit,
similar to NAND pages, but no other NAND characteristics.  Therefore, rename
the minimum write unit to "writesize" for all flashes, including NAND.
Signed-off-by: NJoern Engel <joern@wh.fh-wedel.de>

Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

The previous code wouldn't work correctly on architectures which have a
non-empty MODULE_SYMBOL_PREFIX, and this version is neater if slightly
less optimal in the built-in case.
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

The patch below adds support for the NAND device on the Amstrad Delta.
This is a 32MiB 8bit Toshiba device, with the data bus connected to the
OMAP MPUIO pins and ALE, CLE, NCE, NRE, NWE and NWP all connected to the
Delta's latch2 16bit latch.
Signed-Off-By: NJonathan McDowell <noodles@earth.li>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

WARNING: "__moddi3" [drivers/mtd/mtdconcat.ko] undefined!
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

drivers/mtd/devices/docprobe.c: In function `DoC_Probe':
drivers/mtd/devices/docprobe.c:338: warning: assignment from incompatible pointer type
drivers/mtd/devices/docprobe.c:341: warning: assignment from incompatible pointer type

Cc: David Woodhouse <dwmw2@infradead.org>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

There is a second revision of "mtdconcat NAND/Sibley" patch. I hope
the patch will not get damaged as I'm posting it from gmail account,
thanks to Jorn.

The patch adds previously missing concat_writev(),
concat_writev_ecc(), concat_block_isbad(), concat_block_markbad()
functions to make concatenation layer compatible with Sibley and NAND
chips.

Patch has been cleared from whitespaces, fixed some lines of code as
requested. Also I have added code for alignment check that should
support Jorn's "writesize" patch.
Signed-off-by: NAlexander Belyakov <alexander.belyakov@intel.com>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

The following difference was found between the mainline and linux-mips
kernel.  LASAT depends on MTD_CFI.
Signed-off-by: NMartin Michlmayr <tbm@cyrius.com>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

In an unrelated MTD commit, a description about the ms02-nv module
got removed from Kconfig.  While I personally agree with this
removal, the module maintainer (Maciej W. Rozycki) would like to
see it added back.  In the absense of any consistency regarding
Kconfig descriptions his wish should be followed.
Signed-off-by: NMartin Michlmayr <tbm@cyrius.com>
Acked-by: NMaciej W. Rozycki <macro@linux-mips.org>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NSean Young <sean@mess.org>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

'oobavail' parameter of mtd_info structure is now propagated to the MTD
partitions
Signed-off-by: NVitaly Wool <vwool@ru.mvista.com>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NSean Young <sean@mess.org>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

This allows for much better abstraction and separation of the XIP and
non-XIP cases with their own specific implementations.  This fixes the
case where a timeout was tripped on in the XIP case by the code that
was meant for the non-XIP case only.

This also makes for a nice code reduction.
Signed-off-by: NNicolas Pitre <nico@cam.org>
CC: "Alexey, Korolev" <alexey.korolev@intel.com>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

... otherwise xip_enable() won't do the right thing.
Signed-off-by: NNicolas Pitre <nico@cam.org>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

The patch below fixes a potential starvation issue that can arise when
there is contention on a chip during a period when a process is
currently writing to it.  The starvation is avoided by conditionally
rescheduling when the chip is left in a state usable by other processes.
Signed-off-by: NJosh Boyer <jdub@us.ibm.com>
Signed-off-by: NTom Gall <tom_gall@vnet.ibm.com>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

    On AMD Au1550 the static bus controller fails to keep -CE asserted during
chip ready delay on read commands and the NAND chip being used requires this.
So, the current driver allows nand_base.c to drive -CE manually during the
entire sector read. When the PCMCIA driver is enabled however, occasionally
the ECC errors occur on NAND reads. This happens because the PCMCIA driver
polls sockets periodically and reads one of the board's control/status regs
(BCSRs) which are on the same static bus as the NAND flash, and just use
another chip select (and the NOR flash also resides on that bus), so as the
NAND driver forces NAND chip select asserted and the -RE signal is shared, a
contention occurs on the static bus when BCSR or NOR flash is read while we're
reading from NAND.
    So, we either can't keep interrupts enabled during the whole NAND sector
read (which is hardly acceptable), or have to implement some interlocking
scheme between multiple drivers (which is painful, and makes me shudder :-).
    There's a third way which has proven to work: to force -CE asserted only
while we're waiting for a NAND chip to become ready after a read command,
disabling interrupts for a maximum of 25 microseconds (according to Toshiba
TC58DVM92A1FT00 datasheet -- this chip is mentioned in the board schematics);
for Samsung NAND chip which seems to be actually used this delay is even less,
12 us.
Signed-off-by: NKonstantin Baydarov <kbaidarov@ru.mvista.com>
Signed-off-by: NSergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Fix build warnings from drivers/mtd/redboot.c due to
use of `unsigned long` in `struct fis_image_desc` for
fields being passed to swab32s() which expects __u32 *

Change the entries to uint32_t to make them compatible
with the swab32s() function
Signed-off-by: NBen Dooks <ben-linux@fluff.org>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

     During the last cleanup of the AMD Au1550 NAND driver the old buglet was
reintroduced: as the MEM_STNDCTL register is write-only and seem to always
read as 0x31, read-modify-write to it done in au1xxx_nand_init() will have the
side effect of enabling -RCS0/1 pin override (via bits 4/5 of this reg.), thus
possibly causing a contention on the static bus when the NOR flash (using
-RCS0) or board control status registers (using -RCS2) are read. Luckily, this
goes away with a first NAND access, since au1550_hwcontrol() doesn't try to
read this register before writing anymore.
Signed-off-by: NSergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

We all inherited the same error from the original NAND board driver which
got copied and changed. Fix them all at once...
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

On Mon, May 15, 2006 at 12:56:37AM -0700, Andrew Morton wrote:
>...
> Changes since 2.6.17-rc3-mm1:
>...
>  git-mtd.patch
>...
>  git trees
>...

If we correct the names of the config options, the code might actually
work as intended...
Signed-off-by: NAdrian Bunk <bunk@stusta.de>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Make it work even with compilers which lack the wit to notice that
THIS_MODULE is always non-NULL. Use #ifdef MODULE instead. It's only
a temporary debugging check anyway.
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

The physmap platform driver conversion added to physmap.c an include
of asm/mach/flash.h which is 1) ARM-specific; and 2) isn't actually
necessary.  Remove it.
Signed-off-by: NLennert Buytenhek <buytenh@wantstofly.org>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

We used to calculate the number of chips to be zero, allocate an array
of that size, then nasty things would happen when we attempt to access
the first object in that zero-sized array.

Now, if the number of _full_ chips that would fit into the map is zero,
we allocate an array of one anyway, and then artificially reduce the
total size of the resulting MTD device to fit in the map.
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

There's a mem leak in drivers/mtd/devices/block2mtd.c::block2mtd_setup()

We can leak 'name' allocated with kmalloc in 'parse_name' if leave via
the 'parse_err' macro since it contains a return but doesn't do any
freeing.

Spotted by coverity checker as bug 615.
Signed-off-by: NJesper Juhl <jesper.juhl@gmail.com>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

The _board_ driver needs to be mtd->owner, and it in turn pins the
nand.ko module. Fix them all to actually do that, and fix nand.ko not to
overwrite it -- and also to check that the caller sets it, if the caller
is a module.
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

There are two code paths in drivers/mtd/devices/phram.c::phram_setup() that
will leak memory.
Memory is allocated to the variable 'name' with kmalloc() by the
parse_name() function, but if we leave by way of the parse_err() macro,
then that memory is never kfree()'d, nor is it ever used with
register_device() so it won't be freed later either - leak.

Found by the Coverity checker as #593 - simple fix below.
Signed-off-by: NJesper Juhl <jesper.juhl@gmail.com>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

It was just too painful to deal with.
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

We were scanning for 0xFF through the entire chip -- which takes a while
when it's a 512MiB device as I have on my current toy. The specs only say
we need to check certain bytes -- so do only that.
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

- Implement HW ECC support,
- Provide read_buf() and write_buf() routines using memcpy
- Use on-flash bad block table
- Fix module refcounting
- Avoid read/modify/write in hwcontrol()
- Minor cosmetic fixes

Partly based on code and ideas from Tom Sylla <tom.sylla@amd.com>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

These new chips have 128KiB blocks. Don't try to kmalloc that.
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NEgry Gábor <gaboregry@t-online.hu>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

We need to check block cmd only instead with comparing with cmd
Signed-off-by: NKyungmin Park <kyungmin.park@samsung.com>

One Block of the NAND Flash Array memory is reserved as
a One-Time Programmable Block memory area.
Also, 1st Block of NAND Flash Array can be used as OTP.

The OTP block can be read, programmed and locked using the same
operations as any other NAND Flash Array memory block.
OTP block cannot be erased.

OTP block is fully-guaranteed to be a valid block.
Signed-off-by: NKyungmin Park <kyungmin.park@samsung.com>

There's erase bug in DDP.
We need to add DDP select in erase
Signed-off-by: NKyungmin Park <kyungmin.park@samsung.com>