The following patch adds support for the TQ Systems  TQM834x  Boards.
Verified on TQM8349L.

This is a resubmit after integrating the suggested changes.
Signed-off-by: NMarian Balakowicz <m8@semihalf.com>
Signed-off-by: NWolfgang Denk <wd@denx.de>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Fix two compile warnings that occur because of treating two
'unsigned long's as 'void *'s.
Signed-off-by: NLennert Buytenhek <buytenh@wantstofly.org>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

The assignement of a "const char *" to a "char *" variable
is emitting a warning with gcc 4.0. We cannot change
mtd->name to "const char *" as we have dynamic assignements
of the name. So casting is the correct solution here
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Nathan Roberts noticed the nand_write_ecc index into oobbuf goes out of
bounds when crossing an erase block boundary, causing incorrect OOB data
to be written and corrupting memory.  Reset the index to zero after
re-preparing oobbuf for a new erase block.
Signed-off-by: NTodd Poynor <tpoynor@mvista.com>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

In case of an odd offset, the result was shifted by 1 instead of 8
Signed-off-by: NVitaly Wool <vwool@ru.mvista.com>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

This reverts 405c829f commit.

Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Signed-off-by: NSean Young <sean@mess.org>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

While we are at it, reorder the includes and
remove the silly /* TASK */ comment
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

- Use map.virt instead of map.map_priv_1 since it has the correct type.
- Use readw/writew instead of dereferencing an ioremap'd cookie.
- Remove an unused variable.
Signed-off-by: NDavid Vrabel <dvrabel@arcom.com>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

The Sharp Zaurus akita and borzoi models are large page flash devices.
This patch adds support for them to the sharpsl MTD NAND driver but
keeps the oob layout and bad block positions compatible with the Sharp
Zaurus 2.4 kernel and ROM bootloader.
Signed-off-by: NRichard Purdie <rpurdie@rpsys.net>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Change to the extended cfi table parsing for Intel NOR flash that uses
the info in the extended table to 'walk' the table rather than using
hard coding for various primary extended query table version numbers.

From: Jared Hulbert <jaredeh@gmail.com>
Signed-off-by: NNicolas Pitre <nico@cam.org>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Spotted by basprog@mail.ru
Signed-off-by: NBen Dooks <ben-linux@fluff.org>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Signed-off-by: NBen Dooks <ben@simtec.co.uk>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Added .owner initialisation to allow the
tracking of the device_driver owners when
built as a module
Signed-off-by: NBen Dooks <ben-linux@fluff.org>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Added owner to device driver field for tracking
when loaded as a module.
Signed-off-by: NBen Dooks <ben@simtec.co.uk>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Added owner fields to the device_driver for tracking
ownership when built as a module
Signed-off-by: NBen Dooks <ben@simtec.co.uk>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Don't assume eraseblock size is power of 2.
Dataflash can have aligned eraseblock size.

From: Peter Menzebach <pm-mtd@mw-itcon.de>
Acked-by: NArtem B. Bityutskiy <dedekind@infradead.org>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Add density mask for better support of DDP chips.
Signed-off-by: NKyungmin Park <kyungmin.park@samsung.com>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Add suspend/resume
Signed-off-by: NKyungmin Park <kyungmin.park@samsung.com>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Simple bad block table source and header files
Signed-off-by: NKyungmin Park <kyungmin.park@samsung.com>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Signed-off-by: NBen Dooks <ben@simtec.co.uk>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

- cleaned up the partitions and include files
- added more flexible CS and address detection and setup

Regression tested on db1200 and db1550.
Signed-off-by: NPete Popov <ppopov@pacbell.net>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Add support for "4G Systems MTX-1 Flash device", better known as meshcube.

From: Bruno Randolf <bruno.randolf@4g-systems.biz>
Signed-off-by: NJoern Engel <joern@wohnheim.fh-wedel.de>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

The changes introduced allow to suspend/resume NAND flash.
A new state (FL_PM_SUSPENDED) is introduced, as well as
routines for mtd->suspend and mtd->resume to put the flash in
suspended state from software pov.
Signed-off-by: NVitaly Wool <vwool@ru.mvista.com>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

From: Vitaly Bordug <vbordug@ru.mvista.com>
Signed-off-by: NTodd Poynor <tpoynor@mvista.com>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Now we can use the generic platform driver
Signed-off-by: NKyungmin Park <kyungmin.park@samsung.com>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Signed-off-by: NKyungmin Park <kyungmin.park@samsung.com>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

- Intel chip driver has a reboot notifier so no need to reset the chip here.
- Don't play with chip selects (platform code should do this if necessary).
Signed-off-by: NDavid Vrabel <dvrabel@arcom.com>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Signed-off-by: NKyungmin Park <kyungmin.park@samsung.com>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

- Remove unused block, page parameters
- Add constant instead of runtime value
Signed-off-by: NKyungmin Park <kyungmin.park@samsung.com>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Signed-off-by: NKyungmin Park <kyungmin.park@samsung.com>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

- Update OMAP OneNAND mapping file using device driver model
- Remove board specific macro and values.
Signed-off-by: NKyungmin Park <kyungmin.park@samsung.com>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Based on NAND memory bad block table code
Signed-off-by: NKyungmin Park <kyungmin.park@samsung.com>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Add OneNAND Sync. Burst Read support
Tested with OMAP platform
Signed-off-by: NKyungmin Park <kyungmin.park@samsung.com>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

OneNAND is a new flash technology from Samsung with integrated SRAM
buffers and logic interface.
Signed-off-by: NKyungmin Park <kyungmin.park@samsung.com>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

The bit mask used for oob size calculation was using 2 bits instead
of one. Fortunately the next bit has been 0 all the time.

Thanks to Nathan H. for pointing this out
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Signed-off-by: NThomas Gleixner <tglx@linutronix.de>