NIC partitioning is another flavor of multi function - having few
PCI functions share the same physical port. Unlike the currently
supported mode of multi-function which depends on the switch
configuration and uses outer-VLAN, the NPAR mode is switch independent
and uses the MAC addresses to distribute incoming packets to the different
functions. This patch adds the specific HW setting of the NPAR mode
and some distinctions between switch dependent (SD) and
switch independent (SI) multi-function (MF) modes where the configuration
is not the same.

Advance driver version to 1.60.00-6
Signed-off-by: NDmitry Kravkov <dmitry@broadcom.com>
Signed-off-by: NEilon Greenstein <eilong@broadcom.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Then we can make a completely generic tcp_remember_stamp()
that uses ->get_peer() as a helper, minimizing the AF specific
code and minimizing the eventual code duplication when we implement
the ipv6 side of TW recycling.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

They are only allowed on cached ipv6 routes.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Now that all of the infrastructure is in place, we can add
the ipv6 shorthand for peer creation.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Add the ipv6 peer tree instance, and adapt remaining
direct references to 'v4_peers' as needed.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Now v4 and v6 addresses will both work properly.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

And make an inet_getpeer_v4() helper, update callers.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Currently only the v4 aspect is used, but this will change.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Instead of directly accessing "peer", change to code to
operate using a "struct inet_peer_base *" pointer.

This will facilitate the addition of a seperate tree for
ipv6 peer entries.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Use the normal debugging functions.
Print mac address when using random_ether_addr.
Signed-off-by: NJoe Perches <joe@perches.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

These were probably just for initial driver debugging
and have not been enabled in builds in git history.
Signed-off-by: NJoe Perches <joe@perches.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Use vsprintf extension %pM for a mac address in one instance.
Signed-off-by: NJoe Perches <joe@perches.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Neaten the phy_init function by adding and calling vendor
specific functions.

object size is reduced by ~1kb:

$ size drivers/net/forcedeth.o.*
   text	   data	    bss	    dec	    hex	filename
  83475	   1848	  19304	 104627	  198b3	drivers/net/forcedeth.o.new
  84459	   1848	  19544	 105851	  19d7b	drivers/net/forcedeth.o.old
Signed-off-by: NJoe Perches <joe@perches.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Deduplicate the code use for the init/reset of this device.
Signed-off-by: NJoe Perches <joe@perches.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Use netdev_<level> when a struct net_device * is available.
Signed-off-by: NJoe Perches <joe@perches.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Convert printks to pr_<level>.
Remove "forcedeth: " from some calls as it's now added by pr_fmt.
Signed-off-by: NJoe Perches <joe@perches.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

The remaining dprintk uses are emitted as KERN_INFO.
Change these dprintk uses to netdev_dbg.
Remove the now unused dprintk macros.
Signed-off-by: NJoe Perches <joe@perches.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Use the standard code to emit hex dumps.
Signed-off-by: NJoe Perches <joe@perches.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Use the more standard macro to preface netdev->name.
Fix casting on resource use.
Signed-off-by: NJoe Perches <joe@perches.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Move the printk out of reg_delay and make
the callers emit a message on error.
Signed-off-by: NJoe Perches <joe@perches.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Merge branch 'for-davem' of git://git.kernel.org/pub/scm/linux/kernel/git/linville/wireless-next-2.6

Avoid sparse warnings : add __rcu annotations and use
rcu_dereference_protected() where necessary.
Signed-off-by: NEric Dumazet <eric.dumazet@gmail.com>
Cc: Tom Herbert <therbert@google.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

store_xps_map() allocates maps that are used by single cpu, it makes
sense to use NUMA allocations.
Signed-off-by: NEric Dumazet <eric.dumazet@gmail.com>
Cc: Tom Herbert <therbert@google.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

1. SCTP_CMD_NUM_VERBS,SCTP_CMD_MAX
These two macros have never been used for several years since v2.6.12-rc2.

2.sctp_port_rover,sctp_port_alloc_lock
The commit 063930 abandoned global variables of port_rover and port_alloc_lock,
but still keep two macros to refer to them.
So, remove them now.

commit 06393009
Author: Stephen Hemminger <shemminger@linux-foundation.org>
Date:   Wed Oct 10 17:30:18 2007 -0700

    [SCTP]: port randomization
Signed-off-by: NShan Wei <shanwei@cn.fujitsu.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

If RSS is disabled, we can ifdef out some RSS specific code. This fixes
the compile error found by Randy Dunlap.
Signed-off-by: NScott J. Goldman <scottjg@vmware.com>
Reviewed-by: NBhavesh Davda <bhavesh@vmware.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

This patch adds XPS_CONFIG option to enable and disable XPS.  This is
done in the same manner as RPS_CONFIG.  This is also fixes build
failure in XPS code when SMP is not enabled.
Signed-off-by: NTom Herbert <therbert@google.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

The tso hdr is longer then the regular l3 hdr. Fix the calculation
of the total len by accounting the size of the tso hdr.
Signed-off-by: NFrank Blaschka <frank.blaschka@de.ibm.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Device initialization of a qeth device contains a STARTLAN step.
This step may fail, if cable is not yet plugged in. The qeth device
stays in state HARDSETUP until cable is plugged in. This prevents
further preparational initialization steps of the qeth device and
its network interface. This patch makes sure initialization of qeth
device continues, even though cable is not yet plugged in.
Once carrier is available, qeth is notified, triggers a recovery
which results in a working network interface.
Signed-off-by: NUrsula Braun <ursula.braun@de.ibm.com>
Signed-off-by: NFrank Blaschka <frank.blaschka@de.ibm.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NJoe Perches <joe@perches.com>
Signed-off-by: NFrank Blaschka <frank.blaschka@de.ibm.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Commit 1d7138de
igmp: RCU conversion of in_dev->mc_list

converted rwlock to RCU.

Update the s390 network drivers(qeth & lcs) code to adapt to this change.
V2 : Changes based on suggestions given by Eric Dumazet
Signed-off-by: NSachin Sant <sachinp@in.ibm.com>
Signed-off-by: NUrsula Braun <ursula.braun@de.ibm.com>
Signed-off-by: NFrank Blaschka <frank.blaschka@de.ibm.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

The commit to convert to use the dev_pm_ops struct
introduces a bug. The shutdown flag is not yet used
because the hibernation on memory is done by using
the freeze callback.
Thanks to Vlad for having reported it.
Reported-by: NVlad Lungu <vlad.lungu@windriver.com>
Signed-off-by: NGiuseppe Cavallaro <peppe.cavallaro@st.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NSzymon Janc <szymon@janc.net.pl>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NSzymon Janc <szymon@janc.net.pl>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

forcedeth: include <linux/io.h> and <linux/uaccess.h> instead of <asm/io.h> and <asm/uaccess.h> as suggested by checkpatch
Signed-off-by: NSzymon Janc <szymon@janc.net.pl>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NSzymon Janc <szymon@janc.net.pl>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NSzymon Janc <szymon@janc.net.pl>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NJoe Perches <joe@perches.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NJoe Perches <joe@perches.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NJoe Perches <joe@perches.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NJoe Perches <joe@perches.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>