- 05 8月, 2013 1 次提交
-
-
由 Laurent Pinchart 提交于
The shmobile DT files available in the kernel are reference implementations intended to be used as sample code, as well as for development. As such, it makes sense to mount the root file system in read/write mode by default. Signed-off-by: NLaurent Pinchart <laurent.pinchart+renesas@ideasonboard.com> Signed-off-by: NSimon Horman <horms+renesas@verge.net.au>
-
- 23 7月, 2013 1 次提交
-
-
由 Laurent Pinchart 提交于
LED6 to LED8 are GPIO LEDs. Add corresponding DT nodes. Signed-off-by: NLaurent Pinchart <laurent.pinchart+renesas@ideasonboard.com> Signed-off-by: NSimon Horman <horms+renesas@verge.net.au>
-
- 17 7月, 2013 1 次提交
-
-
由 Simon Horman 提交于
This is sufficient to allow boot of the Lager board with a console without boards-lager.c compiled into the kernel. This is an example of a minimal but still useful initialisation of the board using DT as much as possible. As such it is the same as the boot of Lager that can be achieved without a board file. The intention of adding this file is to facilitate further work to allow board specific devices to be initialised via DT. Acked-by: NMagnus Damm <damm@opensource.se> Signed-off-by: NSimon Horman <horms+renesas@verge.net.au>
-
- 03 4月, 2013 1 次提交
-
-
由 Magnus Damm 提交于
Lager base board support making use of 2 GiB of memory, the r8a7790 SoC with the SCIF0 serial port and CA15 with ARM architected timer. Signed-off-by: NMagnus Damm <damm@opensource.se> Signed-off-by: NSimon Horman <horms+renesas@verge.net.au>
-