It's been pointed out that output GPIOs should have an initial value, to
avoid signal glitching ...  among other things, it can be some time before
a driver is ready.  This patch corrects that oversight, fixing

 - documentation
 - platforms supporting the GPIO interface
 - users of that call (just one for now, others are pending)

There's only one user of this call for now since most platforms are still
using non-generic GPIO setup code, which in most cases already couples the
initial value with its "set output mode" request.

Note that most platforms are clear about the hardware letting the output
value be set before the pin direction is changed, but the s3c241x docs are
vague on that topic ...  so those chips might not avoid the glitches.
Signed-off-by: NDavid Brownell <dbrownell@users.sourceforge.net>
Acked-by: NAndrew Victor <andrew@sanpeople.com>
Acked-by: NMilan Svoboda <msvoboda@ra.rockwell.com>
Acked-by: NHaavard Skinnemoen <hskinnemoen@atmel.com>
Cc: Russell King <rmk@arm.linux.org.uk>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

RTLX communication is based on lock-free shared memory buffers.  It
happened to be working by luck so far but relies on the optimizer doing
certain optimizations but no reordering.

Fixed by inserting proper barriers in rtlx_read and rtlx_write, and careful
pointer dereferencing.
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NAtsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Commit 6d667106 is incomplete and misses
non-r4k CPUs.  This patch reverts the commit and fixes in other way.

 o Do FCSR checking in caller of restore_fp_context.
 o Send SIGFPE if the signal handler set any FPU exception bits.
Signed-off-by: NAtsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

We have to make sure to use base-pagesize TLB entries even during the
early transition period where we need TLB miss handling but don't have
the kernel page tables setup yet for the linear region.

Also, it is necessary therefore to not use the 4MB TSB for these
translations, and instead use the normal kernel TSB.  This allows us
to also get rid of the 4MB tsb for debug builds which shrinks the
kernel a little bit.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

This reverts commit 6ebf622b and
replaces it with one that actually works.
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Acked-by: NWilliam Irwin <wli@holomorphy.com>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Acked-by: NOlof Johansson <olof@lixom.net>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Acked-by: NOlof Johansson <olof@lixom.net>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

and no, it's not the case of "let's pull bits from underlying architecture"
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

PGALLOC_DMA is defined only if we have CONFIG_ZONE_DMA
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

A defconfig file and the 10 lines of code (including comments ...) that
are rotting since lmo commit 6516a42dc8b40c6c00010346dd51496125b16644
don't quite make proper support, so let's trash it.
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NChris Dearman <chris@mips.com>
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

These pte loops all assume the passed in address is HPAGE
aligned, make sure that is actually true.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

sys_mbind
sys_get_mempolicy
sys_set_mempolicy
sys_kexec_load
sys_move_pages
sys_getcpu
sys_epoll_pwait

This work is largely a result of David Woodhouse's most
excellent missing syscalls patch.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

From: William Lee Irwin III <wli@holomorphy.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

VMI is broken under COMPAT_VDSO, as Xen and other non hardware assisted
hypervisors will be.  I have been working on a fix for this which works
for older glibcs that panic when the new relocatable VDSO is used.

However, I believe at this time that the fix is going to be too radical
to consider at this stage in the release of 2.6.21.  We don't expect
this config option to be turned on by vendors for new distributions, so
at this point we are willing to drop support for it when VMI is compiled
in, and work on a patch for 2.6.22 which more fully addresses the
problem.
Signed-off-by: NZachary Amsden <zach@vmware.com>
Acked-by: NIngo Molnar <mingo@elte.hu>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

Only System PLL clock source is selectable by CSCR_SYSTEM_SEL
bit. MPU PLL is driven by 512*CLK32 for each case.
Signed-off-by: NPavel Pisa <pisa@cmp.felk.cvut.cz>
Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>

The minimal bus clock prescaler should be kept at value
selected by the board / boot loader designer.
Switching frequency above startup limit could
lead to the external memory/devices misbehave.
Signed-off-by: NPavel Pisa <pisa@cmp.felk.cvut.cz>
Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>

Fix atomicity of TIF update in flush_thread() for sparc64

Fixes correctly the race by using *_ti_thread_flag.

Race :

parent process executing :
sys_ptrace()
 (lock_kernel())
 (ptrace_get_task_struct(pid))
 arch_ptrace()
   ptrace_detach()
     ptrace_disable(child);
       clear_singlestep(child);
         clear_tsk_thread_flag(child, TIF_SINGLESTEP);
         (which clears the TIF_SINGLESTEP flag atomically from a different
          process)
 (put_task_struct(child))
 (unlock_kernel())

And at the same time, in the child process :
sys_execve()
 do_execve()
   search_binary_handler()
     load_elf_binary()
       flush_old_exec()
         flush_thread()
           doing a non-atomic thread flag update
Signed-off-by: NMathieu Desnoyers <mathieu.desnoyers@polymtl.ca>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NArnd Bergmann <arnd.bergmann@de.ibm.com>

Add missing checks to PS3 specific drivers ps3av and sys-manager to verify that
we are actually running on a PS3 (pointed out by Arnd).

Correct existing checks in other subsystems/drivers to return -ENODEV instead
of zero.
Signed-off-by: NGeert Uytterhoeven <Geert.Uytterhoeven@sonycom.com>
Signed-off-by: NArnd Bergmann <arnd.bergmann@de.ibm.com>

The SPU code doesn't properly invalidate SPUs SLBs when necessary,
for example when changing a segment size from the hugetlbfs code. In
addition, it saves and restores the SLB content on context switches
which makes it harder to properly handle those invalidations.

This patch removes the saving & restoring for now, something more
efficient might be found later on. It also adds a spu_flush_all_slbs(mm)
that can be used by the core mm code to flush the SLBs of all SPEs that
are running a given mm at the time of the flush.

In order to do that, it adds a spinlock to the list of all SPEs and move
some bits & pieces from spufs to spu_base.c
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>

This optimization was added recently but is still buggy,
so back it out for now.
Signed-off-by: NArnd Bergmann <arnd.bergmann@de.ibm.com>

Due to a buggy unsigned comparison, it was possible to write
beyond the end of the local store file in spufs under some
circumstances.

This rewrites the buggy function to look more like
simple_copy_from_buffer.
Signed-off-by: NArnd Bergmann <arnd.bergmann@de.ibm.com>
Cc: Ulrich Weigand <Ulrich.Weigand@de.ibm.com>

 o Fix build error.
 o Handle error returns.
 o Deal with signals received while sleeping.
 o Don't allow to be selected when we're not building the directory with
   the driver anyway.
 o Coding style cleanups.
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Register_prom_console was removed when mips was converted to early printk.
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

x86_64 nvidia_bugs() broke when we bailed out on not finding the HPET.
However, the quirk works by checking for not finding the HPET...

Delete the nvidia_hpet_detected flag and simply test for
not finding the HPET, which is simple to do now that
acpi_table_parse returns 1 on failure.
Signed-off-by: NLen Brown <len.brown@intel.com>

missing close bracket.
Signed-off-by: NDave Jones <davej@redhat.com>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

x86_64 nvidia_bugs() broke when we bailed out on not finding the HPET.
However, the quirk works by checking for _not_ finding the HPET...

Delete the nvidia_hpet_detected flag and simply test for
not finding the HPET, which is simple to do now that
acpi_table_parse returns 1 on failure.
Signed-off-by: NLen Brown <len.brown@intel.com>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>