Skip to content

cloud-kernel
cloud-kernel

openanolis / cloud-kernel
1 年多 前同步成功

通知 160
Star 36
Fork 7
cloud-kernel
cloud-kernel
切换分支/标签
  1. 19 8月, 2014 4 次提交
    • N
      md/raid10: always initialise ->state on newly allocated r10_bio · cb8b12b5
      由 NeilBrown 提交于 
      Most places which allocate an r10_bio zero the ->state, some don't.
As the r10_bio comes from a mempool, and the allocation function uses
kzalloc it is often zero anyway.  But sometimes it isn't and it is
best to be safe.

I only noticed this because of the bug fixed by an earlier patch
where the r10_bios allocated for a reshape were left around to
be used by a subsequent resync.  In that case the R10BIO_IsReshape
flag caused problems.
Signed-off-by: NNeilBrown <neilb@suse.de>
      cb8b12b5
    • N
      md/raid10: avoid memory leak on error path during reshape. · e337aead
      由 NeilBrown 提交于 
      If raid10 reshape fails to find somewhere to read a block
from, it returns without freeing memory...
Signed-off-by: NNeilBrown <neilb@suse.de>
      e337aead
    • N
      md/raid10: Fix memory leak when raid10 reshape completes. · b3968552
      由 NeilBrown 提交于 
      When a raid10 commences a resync/recovery/reshape it allocates
some buffer space.
When a resync/recovery completes the buffer space is freed.  But not
when the reshape completes.
This can result in a small memory leak.

There is a subtle side-effect of this bug.  When a RAID10 is reshaped
to a larger array (more devices), the reshape is immediately followed
by a "resync" of the new space.  This "resync" will use the buffer
space which was allocated for "reshape".  This can cause problems
including a "BUG" in the SCSI layer.  So this is suitable for -stable.

Cc: stable@vger.kernel.org (v3.5+)
Fixes: 3ea7daa5Signed-off-by: NNeilBrown <neilb@suse.de>
      b3968552
    • N
      md/raid10: fix memory leak when reshaping a RAID10. · ce0b0a46
      由 NeilBrown 提交于 
      raid10 reshape clears unwanted bits from a bio->bi_flags using
a method which, while clumsy, worked until 3.10 when BIO_OWNS_VEC
was added.
Since then it clears that bit but shouldn't.  This results in a
memory leak.

So change to used the approved method of clearing unwanted bits.

As this causes a memory leak which can consume all of memory
the fix is suitable for -stable.

Fixes: a38352e0
Cc: stable@vger.kernel.org (v3.10+)
Reported-by: mdraid.pkoch@dfgh.net (Peter Koch)
Signed-off-by: NNeilBrown <neilb@suse.de>
      ce0b0a46
  3. 18 8月, 2014 2 次提交
    • N
      md/raid6: avoid data corruption during recovery of double-degraded RAID6 · 9c4bdf69
      由 NeilBrown 提交于 
      During recovery of a double-degraded RAID6 it is possible for
some blocks not to be recovered properly, leading to corruption.

If a write happens to one block in a stripe that would be written to a
missing device, and at the same time that stripe is recovering data
to the other missing device, then that recovered data may not be written.

This patch skips, in the double-degraded case, an optimisation that is
only safe for single-degraded arrays.

Bug was introduced in 2.6.32 and fix is suitable for any kernel since
then.  In an older kernel with separate handle_stripe5() and
handle_stripe6() functions the patch must change handle_stripe6().

Cc: stable@vger.kernel.org (2.6.32+)
Fixes: 6c0069c0
Cc: Yuri Tikhonov <yur@emcraft.com>
Cc: Dan Williams <dan.j.williams@intel.com>
Reported-by: N"Manibalan P" <pmanibalan@amiindia.co.in>
Tested-by: N"Manibalan P" <pmanibalan@amiindia.co.in>
Resolves: https://bugzilla.redhat.com/show_bug.cgi?id=1090423Signed-off-by: NNeilBrown <neilb@suse.de>
Acked-by: NDan Williams <dan.j.williams@intel.com>
      9c4bdf69
    • N
      md/raid5: avoid livelock caused by non-aligned writes. · a40687ff
      由 NeilBrown 提交于 
      If a stripe in a raid6 array received a write to each data block while
the array is degraded, and if any of these writes to a missing device
are not page-aligned, then a live-lock happens.

In this case the P and Q blocks need to be read so that the part of
the missing block which is *not* being updated by the write can be
constructed.  Due to a logic error, these blocks are not loaded, so
the update cannot proceed and the stripe is 'handled' repeatedly in an
infinite loop.

This bug is unlikely as most writes are page aligned.  However as it
can lead to a livelock it is suitable for -stable.  It was introduced
in 3.16.

Cc: stable@vger.kernel.org (v3.16)
Fixed: 67f45548Signed-off-by: NNeilBrown <neilb@suse.de>
      a40687ff
  5. 17 8月, 2014 1 次提交
  7. 16 8月, 2014 33 次提交