Skip to content

cloud-kernel
cloud-kernel

openanolis / cloud-kernel
1 年多 前同步成功

通知 160
Star 36
Fork 7
cloud-kernel
cloud-kernel
切换分支/标签
  1. 28 2月, 2009 1 次提交
  3. 14 11月, 2008 1 次提交
    • A
      USB: EHCI: fix handling of dead controllers · 67b2e029
      由 Alan Stern 提交于 
      This patch (as1165) makes a few small changes in the logic used by
ehci-hcd when it encounters a controller error:

	Instead of printing out the masked status, it prints the
	original status as read directly from the hardware.

	It doesn't check for the STS_HALT status bit before taking
	action.  The mere fact that the STS_FATAL bit is set means
	that something bad has happened and the controller needs to
	be reset.  With the old code this test could never succeed
	because the STS_HALT bit was masked out from the status.

I anticipate that this will prevent the occasional "irq X: nobody cared"
problem people encounter when their EHCI controllers die.
Signed-off-by: NAlan Stern <stern@rowland.harvard.edu>
Cc: David Brownell <david-b@pacbell.net>
Cc: stable <stable@kernel.org>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>
      67b2e029
  5. 21 10月, 2008 1 次提交
  7. 18 10月, 2008 5 次提交
  9. 24 9月, 2008 1 次提交
  11. 22 7月, 2008 1 次提交
    • D
      USB: ehci-hcd unlink speedups · b9638011
      由 David Brownell 提交于 
      This patch fixes some performance bugs observed with some workloads
when unlinking EHCI queue header (QH) descriptors from the async ring
(control/bulk schedule).

The mechanism intended to defer unlinking an empty QH (so there is no
penalty in common cases where it's quickly reused) was not working as
intended.  Sometimes the unlink was scheduled:

 - too quickly ... which can be a *strong* negative effect, since
   that QH becomes unavailable for immediate re-use;

 - too slowly ... wasting DMA cycles, usually a minor issue except
   for increased bus contention and power usage;

Plus there was an extreme case of "too slowly":  a logical error in the
IAA watchdog-timer conversion meant that sometimes the unlink never
got scheduled.

The fix replaces a simple counter with a timestamp derived from the
controller's 8 KHz microframe counter, and adjusts the timer usage
for some issues associated with HZ being less than 8K.

(Based on a patch originally by Alan Stern, and good troubleshooting
from  Leonid.)
Signed-off-by: NDavid Brownell <dbrownell@users.sourceforge.net>
Cc: Alan Stern <stern@rowland.harvard.edu>
Cc: Leonid <leonidv11@gmail.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>
      b9638011
  13. 30 5月, 2008 2 次提交
    • G
      Revert "USB: EHCI: fix performance regression" · bb7e6984
      由 Greg Kroah-Hartman 提交于 
      This reverts commit fa38dfcc.

It wasn't really a regression and David and Alan are still working
through the issues reported.
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>
      bb7e6984
    • A
      USB: EHCI: fix performance regression · fa38dfcc
      由 Alan Stern 提交于 
      This patch (as1099) fixes a performance regression in ehci-hcd.  The
fundamental problem is that queue headers get removed from the
schedule too quickly, since the code checks for a counter advancing
rather than making an actual time-based check.  The latency involved
in removing the queue header and then relinking it can severely
degrade certain kinds of workloads.

The patch replaces a simple counter with a timestamp derived from the
controller's uframe value.  In addition, the delay for unlinking an
idle queue header is increased from 5 ms to 10 ms; since some
controllers (nVidia) have a latency of up to 1 ms for unlinking, this
reduces the relative impact from 20% to 10%.

Finally, a logical error left over from the IAA watchdog-timer
conversion is corrected.  Now the driver will always either unlink an
idle queue header or set up a timer to unlink it later.  The old code
would sometimes fail to do either.
Signed-off-by: NAlan Stern <stern@rowland.harvard.edu>
Cc: David Brownell <david-b@pacbell.net>
Cc: Leonid <leonidv11@gmail.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>
      fa38dfcc
  15. 25 4月, 2008 5 次提交
  17. 28 3月, 2008 1 次提交
  19. 11 3月, 2008 1 次提交
    • D
      USB: fix ehci unlink regressions · e82cc128
      由 David Brownell 提交于 
      The recent EHCI driver update to split the IAA watchdog timer out from
the other timers made several things work better, but not everything;
and it created a couple new issues in bugzilla.  Ergo this patch:

  - Handle a should-be-rare SMP race between the watchdog firing
    and (very late) IAA interrupts;

  - Remove a shouldn't-have-been-added WARN_ON() test;

  - Guard against one observed OOPS;

  - If this watchdog fires during clean HC shutdown, it should act
    as a NOP instead of interfering with the shutdown sequence;

  - Guard against silicon errata hypothesized by some vendors:
      * IAA status latch broken, but IAAD cleared OK;
      * IAAD wasn't cleared when IAA status got reported;

The WARN_ON is in bugzilla as 10168; the OOPS as 10078; these are
both regressions.
Signed-off-by: NDavid Brownell <dbrownell@users.sourceforge.net>
Tested-by: NGordon Farquharson <gordonfarquharson@gmail.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>
      e82cc128
  21. 22 2月, 2008 2 次提交
  23. 02 2月, 2008 6 次提交
  25. 29 11月, 2007 1 次提交
    • D
      USB: fix up EHCI startup synchronization · 1cb52658
      由 David Brownell 提交于 
      A recent patch added software synchronization during EHCI startup,
so ports aren't switched away from the companion controllers after
resets have started.  This patch adds a short delay letting hardware
finish that port switching before any new resets begin ... so both
ends of that hardware race window are closed.
Signed-off-by: NDavid Brownell <dbrownell@users.sourceforge.net>
Cc: Dave Miller <davem@davemloft.net>
Cc: Dely Sy <dely.l.sy@intel.com>
Cc: stable <stable@kernel.org>
Cc: Alan Stern <stern@rowland.harvard.edu>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>
      1cb52658
  27. 13 10月, 2007 2 次提交
    • A
      USB: mutual exclusion for EHCI init and port resets · 32fe0198
      由 Alan Stern 提交于 
      This patch (as999) fixes a problem that sometimes shows up when host
controller driver modules are loaded in the wrong order.  If ehci-hcd
happens to initialize an EHCI controller while the companion OHCI or
UHCI controller is in the middle of a port reset, the reset can fail
and the companion may get very confused.  The patch adds an
rw-semaphore and uses it to keep EHCI initialization and port resets
mutually exclusive.
Signed-off-by: NAlan Stern <stern@rowland.harvard.edu>
Acked-by: NDavid Brownell <david-b@pacbell.net>
Cc: David Miller <davem@davemloft.net>
Cc: Dely L Sy <dely.l.sy@intel.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>
      32fe0198
    • A
      USB: make HCDs responsible for managing endpoint queues · e9df41c5
      由 Alan Stern 提交于 
      This patch (as954) implements a suggestion of David Brownell's.  Now
the host controller drivers are responsible for linking and unlinking
URBs to/from their endpoint queues.  This eliminates the possiblity of
strange situations where usbcore thinks an URB is linked but the HCD
thinks it isn't.  It also means HCDs no longer have to check for URBs
being dequeued before they were fully enqueued.

In addition to the core changes, this requires changing every host
controller driver and the root-hub URB handler.  For the most part the
required changes are fairly small; drivers have to call
usb_hcd_link_urb_to_ep() in their urb_enqueue method,
usb_hcd_check_unlink_urb() in their urb_dequeue method, and
usb_hcd_unlink_urb_from_ep() before giving URBs back.  A few HCDs make
matters more complicated by the way they split up the flow of control.

In addition some method interfaces get changed.  The endpoint argument
for urb_enqueue is now redundant so it is removed.  The unlink status
is required by usb_hcd_check_unlink_urb(), so it has been added to
urb_dequeue.
Signed-off-by: NAlan Stern <stern@rowland.harvard.edu>
CC: David Brownell <david-b@pacbell.net>
CC: Olav Kongas <ok@artecdesign.ee>
CC: Tony Olech <tony.olech@elandigitalsystems.com>
CC: Yoshihiro Shimoda <shimoda.yoshihiro@renesas.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>
      e9df41c5
  29. 21 8月, 2007 1 次提交
    • L
      Revert "USB: EHCI cpufreq fix" · 8eb891fc
      由 Linus Torvalds 提交于 
      This reverts commit 196705c9.  It was
reported to cause a regression by Daniel Exner, and Arjan van de Ven
points out that we actually already have infrastructure in place for
setting limits on acceptable DMA latency that would be the much more
correct fix for the problem with some Broadcom EHCI controllers.

Fixed up trivial conflicts due to the changes to support big-endian host
controller descriptors in drivers/usb/host/{ehci-sched.c,ehci.h}.
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      8eb891fc
  31. 13 7月, 2007 7 次提交
  33. 09 5月, 2007 1 次提交
  35. 12 4月, 2007 1 次提交
    • A
      EHCI: fix remote wakeup regression in 2.6.21-rc · 61e8b858
      由 Alan Stern 提交于 
      There is one significant difference between the behavior of root hubs
(as embodied in host controller hardware) and external hubs: When a
remote-wakeup signal is received, an external hub sends an interrupt
message at the _end_ of the resume sequence but a root hub generates
and interrupt at the _beginning_ of the resume sequence.  The host
system must poll for the end of the sequence.

When ehci-hcd was converted to interrupt-driven operation instead of
using polling, the remaining need for this particular poll was
overlooked.  This patch (as894) fixes the problem.
Signed-off-by: NAlan Stern <stern@rowland.harvard.edu>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>
      61e8b858