Skip to content

cloud-kernel
cloud-kernel

openanolis / cloud-kernel
1 年多 前同步成功

通知 160
Star 36
Fork 7
cloud-kernel
cloud-kernel
切换分支/标签
  1. 06 10月, 2012 3 次提交
    • A
      rapidio: use device lists handling on per-net basis · a7071efc
      由 Alexandre Bounine 提交于 
      Modify handling of device lists to resolve issues caused by using single
global list of RIO devices during enumeration/discovery.  The most common
sign of existing issue is incorrect contents of switch routing tables in
systems with multiple mport controllers while single-port configuration
performs as expected.
Signed-off-by: NAlexandre Bounine <alexandre.bounine@idt.com>
Cc: Matt Porter <mporter@kernel.crashing.org>
Cc: Li Yang <leoli@freescale.com>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      a7071efc
    • A
      rapidio: fix blocking wait for discovery ready · fa3dbaa0
      由 Alexandre Bounine 提交于 
      The following set of patches provides modifications targeting support of
multiple RapidIO master port (mport) devices on a CPU-side of
RapidIO-capable board.  While the RapidIO subsystem code has definitions
suitable for multi-controller/multi-net support, the existing
implementation cannot be considered ready for multiple mport
configurations.

=========== NOTES: =============

a) The patches below do not address RapidIO side view of multiport
   processing elements defined in Part 6 of RapidIO spec Rev.2.1 (section
   6.4.1).  These devices have Base Device ID CSR (0x60) and Component Tag
   CSR (0x6C) shared by all SRIO ports.  For example, Freescale's P4080,
   P3041 and P5020 have a dual-port SRIO controller implemented according
   the specification.  Enumeration/discovery of such devices from RapidIO
   side may require device-specific fixups.

b) Devices referenced above may also require implementation specific
   code to setup a host device ID for mport device.  These operations are
   not addressed by patches in this package.

=================================

Details about provided patches:

1. Fix blocking wait for discovery ready

   While it does not happen on PowerPC based platforms, there is
   possibility of stalled CPU warning dump on x86 based platforms that run
   RapidIO discovery process if they wait too long for being enumerated.

   Currently users can avoid it by disabling the soft-lockup detector
   using "nosoftlockup" kernel parameter OR by ensuring that enumeration
   is completed before soft-lockup is detected.

   This patch eliminates blocking wait and keeps a scheduler running.
   It also is required for patch 3 below which introduces asynchronous
   discovery process.

2. Use device lists handling on per-net basis

   This patch allows to correctly support multiple RapidIO nets and
   resolves possible issues caused by using single global list of devices
   during RapidIO system enumeration/discovery.  The most common sign of
   existing issue is incorrect contents of switch routing tables in
   systems with multiple mport controllers while single-port configuration
   performs as expected.

   The patch does not eliminate the global RapidIO device list but
   changes some routines in enumeration/discovery to use per-net device
   lists instead.  This way compatibility with upper layer RIO routines is
   preserved.

3.  Run discovery as an asynchronous process

   This patch modifies RapidIO initialization routine to asynchronously
   run the discovery process for each corresponding mport.  This allows
   having an arbitrary order of enumerating and discovering mports without
   creating a deadlock situation if an enumerator port was registered
   after a discovering one.

   On boards with multiple discovering mports it also eliminates order
   dependency between mports and may reduce total time of RapidIO
   subsystem initialization.

   Making netID matching to mportID ensures consistent netID assignment
   in multiport RapidIO systems with asynchronous discovery process
   (global counter implementation is affected by race between threads).

4. Rework RIONET to support multiple RIO master ports

   In the current version of the driver rionet_probe() has comment "XXX
   Make multi-net safe".  Now it is a good time to address this comment.

   This patch makes RIONET driver multi-net safe/capable by introducing
   per-net lists of RapidIO network peers.  It also enables to register
   network adapters for all available mport devices.

5. Add destination ID allocation mechanism

   The patch replaces a single global destination ID counter with
   per-net allocation mechanism to allow independent destID management for
   each available RapidIO network.  Using bitmap based mechanism instead
   of counters allows destination ID release and reuse in systems that
   support hot-swap.

This patch:

Fix blocking wait loop in the RapidIO discovery routine to avoid warning
dumps about stalled CPU on x86 platforms.
Signed-off-by: NAlexandre Bounine <alexandre.bounine@idt.com>
Cc: Matt Porter <mporter@kernel.crashing.org>
Cc: Li Yang <leoli@freescale.com>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      fa3dbaa0
    • A
      rapidio: apply RX/TX enable to active switch ports only · 8d4630dc
      由 Alexandre Bounine 提交于 
      Apply port RX/TX enable operations only to active switch ports.

RapidIO specification (Part 6: LP-Serial Physical Layer) recommends to
keep Output Port Enable (TX) and Input Port Enable (RX) control bits in
disabled state (0b0) after device reset.  It also allows to have
implementation specific reset state for these bits.

This patch ensures that TX/RX enable action is applied only to active
switch's ports while preserving an initial state of inactive ones.

This patch is intended to keep inactive switch ports with inbound and
outbound packet transfers disabled to block unexpected packets during hot
insertion event.  While it does not fix any visible malfunction it is
intended to prevent such events in future.
Signed-off-by: NAlexandre Bounine <alexandre.bounine@idt.com>
Cc: Matt Porter <mporter@kernel.crashing.org>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      8d4630dc
  3. 03 11月, 2011 2 次提交
  5. 26 8月, 2011 1 次提交
    • A
      rapidio: fix use of non-compatible registers · 284fb68d
      由 Alexandre Bounine 提交于 
      Replace/remove use of RIO v.1.2 registers/bits that are not
forward-compatible with newer versions of RapidIO specification.

RapidIO specification v.1.3 removed Write Port CSR, Doorbell CSR,
Mailbox CSR and Mailbox and Doorbell bits of the PEF CAR.

Use of removed (since RIO v.1.3) register bits affects users of
currently available 1.3 and 2.x compliant devices who may use not so
recent kernel versions.

Removing checks for unsupported bits makes corresponding routines
compatible with all versions of RapidIO specification.  Therefore,
backporting makes stable kernel versions compliant with RIO v.1.3 and
later as well.
Signed-off-by: NAlexandre Bounine <alexandre.bounine@idt.com>
Cc: Kumar Gala <galak@kernel.crashing.org>
Cc: Matt Porter <mporter@kernel.crashing.org>
Cc: Li Yang <leoli@freescale.com>
Cc: Thomas Moll <thomas.moll@sysgo.com>
Cc: Chul Kim <chul.kim@idt.com>
Cc: <stable@kernel.org>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      284fb68d
  7. 31 3月, 2011 1 次提交
  9. 24 3月, 2011 1 次提交
  11. 23 1月, 2011 1 次提交
  13. 14 1月, 2011 4 次提交
  15. 28 10月, 2010 5 次提交
  17. 31 5月, 2010 1 次提交
    • R
      rapidio: fix new kernel-doc warnings · 97ef6f74
      由 Randy Dunlap 提交于 
      Fix a bunch of new rapidio kernel-doc warnings:

Warning(include/linux/rio.h:123): No description found for parameter 'comp_tag'
Warning(include/linux/rio.h:123): No description found for parameter 'phys_efptr'
Warning(include/linux/rio.h:123): No description found for parameter 'em_efptr'
Warning(include/linux/rio.h:123): No description found for parameter 'pwcback'
Warning(include/linux/rio.h:247): No description found for parameter 'set_domain'
Warning(include/linux/rio.h:247): No description found for parameter 'get_domain'
Warning(drivers/rapidio/rio-scan.c:1133): No description found for parameter 'rdev'
Warning(drivers/rapidio/rio-scan.c:1133): Excess function parameter 'port' description in 'rio_init_em'
Warning(drivers/rapidio/rio.c:349): No description found for parameter 'rdev'
Warning(drivers/rapidio/rio.c:349): Excess function parameter 'mport' description in 'rio_request_inb_pwrite'
Warning(drivers/rapidio/rio.c:393): No description found for parameter 'port'
Warning(drivers/rapidio/rio.c:393): No description found for parameter 'local'
Warning(drivers/rapidio/rio.c:393): No description found for parameter 'destid'
Warning(drivers/rapidio/rio.c:393): No description found for parameter 'hopcount'
Warning(drivers/rapidio/rio.c:393): Excess function parameter 'rdev' description in 'rio_mport_get_physefb'
Warning(drivers/rapidio/rio.c:845): Excess function parameter 'local' description in 'rio_std_route_clr_table'
Signed-off-by: NRandy Dunlap <randy.dunlap@oracle.com>
Cc: Alexandre Bounine <alexandre.bounine@idt.com>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      97ef6f74
  19. 28 5月, 2010 5 次提交
  21. 16 6月, 2009 1 次提交
  23. 19 5月, 2009 1 次提交
  25. 07 4月, 2009 1 次提交
  27. 16 12月, 2008 1 次提交
  29. 01 12月, 2008 1 次提交
  31. 29 4月, 2008 1 次提交
  33. 20 7月, 2007 1 次提交
  35. 12 2月, 2007 1 次提交
  37. 01 7月, 2006 1 次提交
  39. 09 1月, 2006 1 次提交
  41. 07 11月, 2005 2 次提交