- 16 10月, 2008 40 次提交
-
-
由 Yinghai Lu 提交于
Andrew said, we don't need duplicated panic. because __alloc_bootmem already have that. Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Cyrill Gorcunov 提交于
By changing printout form we are able to shrink (and clean up) code a bit. Former printout example: init IO_APIC IRQs IO-APIC (apicid-pin) 1-1, 1-2, 1-3 not connected. IO-APIC (apicid-pin) 2-1, 2-2, 2-3 not connected. New printout example: init IO_APIC IRQs 1-1 1-2 1-3 (apicid-pin) not connected 2-1 2-2 2-3 (apicid-pin) not connected Signed-off-by: NCyrill Gorcunov <gorcunov@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
Initialize a per CPU HPET MSI timer when possible. We retain the HPET timer 0 (IRQ 0) and timer 1 (IRQ 8) as is when legacy mode is being used. We setup the remaining HPET timers as per CPU MSI based timers. This per CPU timer will eliminate the need for timer broadcasting with IRQ 0 when there is non-functional LAPIC timer across CPU deep C-states. If there are more CPUs than number of available timers, CPUs that do not find any timer to use will continue using LAPIC and IRQ 0 broadcast. Signed-off-by: NVenkatesh Pallipadi <venkatesh.pallipadi@intel.com> Signed-off-by: NShaohua Li <shaohua.li@intel.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Ingo Molnar 提交于
small style cleanups. Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
Basic HPET MSI setup code. Routines to perform basic MSI read write in HPET memory map and setting up irq_chip for HPET MSI. Signed-off-by: NVenkatesh Pallipadi <venkatesh.pallipadi@intel.com> Signed-off-by: NShaohua Li <shaohua.li@intel.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
Preparatory patch before the actual HPET MSI changes. Sets up hpet_set_mode and hpet_next_event for the MSI related changes. Just the code refactoring and should be zero functional change. Signed-off-by: NVenkatesh Pallipadi <venkatesh.pallipadi@intel.com> Signed-off-by: NShaohua Li <shaohua.li@intel.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
Change the IRQ affinity in the process context when the IRQ is disabled. Signed-off-by: NVenkatesh Pallipadi <venkatesh.pallipadi@intel.com> Signed-off-by: NShaohua Li <shaohua.li@intel.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Yinghai Lu 提交于
need to change irq to int too Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Dean Nelson 提交于
Extraneous call to irq_to_desc(). Signed-off-by: NDean Nelson <dcn@sgi.com> Cc: Yinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Dean Nelson 提交于
An error return from create_irq_nr() is 0, but an error return from create_irq() is -1. Signed-off-by: NDean Nelson <dcn@sgi.com> Cc: Yinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Cyrill Gorcunov 提交于
We use irq_cfg_lock lock in SPARSE_IRQ only context so move it under #ifdef and compiler will be happy. Signed-off-by: NCyrill Gorcunov <gorcunov@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Cyrill Gorcunov 提交于
Make the code width a bit shorter with ARRAY_SIZE macro. Signed-off-by: NCyrill Gorcunov <gorcunov@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Yinghai Lu 提交于
Andrew found the typo could break some platforms. also fix a checkpatch warning. Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Yinghai Lu 提交于
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 H. Peter Anvin 提交于
Impact: build failure on uniprocessor When compiling for !CONFIG_SMP, per_cpu_alloc_dyn_array() would fail to compile, since it uses per_cpu_offset, which is not defined for uniprocessor builds. Hence, do not compile per_cpu_alloc_dyn_array() for !CONFIG_SMP. Attempting to call this function in a uniprocessor configuration would be simply wrong in the first place. Signed-off-by: NH. Peter Anvin <hpa@zytor.com>
-
由 Suresh Siddha 提交于
It is possible that, instead of PCI endpoint/sub-hierarchy structures, only IO-APIC/HPET devices may be reported under device scope structures. Fix the devices_cnt error check, which cares about only PCI structures and removes the dma-remapping unit structure (dmaru) when the devices_cnt is zero and include_all flag is not set. Signed-off-by: NSuresh Siddha <suresh.b.siddha@intel.com> Acked-by: NYinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Suresh Siddha 提交于
In dmar_dev_scope_init(), functions called under for_each_drhd_unit()/ for_each_rmrr_units() can delete the list entry under some error conditions. So we should use list_for_each_entry_safe() for safe traversal. Signed-off-by: NSuresh Siddha <suresh.b.siddha@intel.com> Acked-by: NYinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Yinghai Lu 提交于
initialize the return value in dmar_parse_dev() Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NSuresh Siddha <suresh.b.siddha@intel.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Yinghai Lu 提交于
Very early detection of the DMAR tables will setup fixmap mapping. For parsing these tables later (while enabling dma and/or interrupt remapping), early fixmap mapping shouldn't be used. Fix it by calling table detection routines again, which will call generic apci_get_table() for setting up the correct mapping. Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NSuresh Siddha <suresh.b.siddha@intel.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Yinghai Lu 提交于
APIC_ARBPRI is a reserved register for XAPIC and beyond. APIC_RRR is a reserved register except for 82489DX, APIC for Pentium processors. APIC_EOI is a write only register. APIC_DFR is reserved in x2apic mode. Access to these registers in x2apic will result in #GP fault. Fix these apic register accesses. Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NSuresh Siddha <suresh.b.siddha@intel.com> Cc: Maciej W. Rozycki <macro@linux-mips.org> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Ingo Molnar 提交于
Stephen Rothwell reported such build failures on m68k/sparc/s390: > ERROR: "nr_irqs" [drivers/net/hamradio/baycom_ser_fdx.ko] undefined! > ERROR: "nr_irqs" [drivers/net/3c59x.ko] undefined! export nr_irqs on these architectures too. Reported-by: NStephen Rothwell <sfr@canb.auug.org.au> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Cyrill Gorcunov 提交于
According to entry_64.S we do pass pt_regs pointer into interrupt handlers but don't use them. So we safely may merge the declarations. Signed-off-by: NCyrill Gorcunov <gorcunov@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Yinghai Lu 提交于
fix non-sparseirq architectures. Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Yinghai Lu 提交于
Use the 32-bit APIC calibration code - it's more mature. Signed-of-by: NYinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Yinghai Lu 提交于
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Yinghai Lu 提交于
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Yinghai Lu 提交于
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Yinghai Lu 提交于
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Yinghai Lu 提交于
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Yinghai Lu 提交于
Signed-off-by: NYinghai Lu <yhlu.kernel@mgail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Yinghai Lu 提交于
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Yinghai Lu 提交于
except x2apic, detec_init_APIC, and calibrating_APIC_clock Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Yinghai Lu 提交于
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Yinghai Lu 提交于
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Yinghai Lu 提交于
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Cyrill Gorcunov 提交于
Signed-off-by: NCyrill Gorcunov <gorcunov@gmail.com> Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Cyrill Gorcunov 提交于
All callers are __init or __cpuinit so there is no need to hold this code without CPU_HOTPLUG being set. Signed-off-by: NCyrill Gorcunov <gorcunov@gmail.com> Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Cyrill Gorcunov 提交于
- remove useless read of APIC_LVR - wrap with preempt_disable/enable - check for integrated APIC just in place v2: fix by Yinghai Lu. fix lapic_is_integrated using let 64-bit too have pic_mode Signed-off-by: NCyrill Gorcunov <gorcunov@gmail.com> Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Cyrill Gorcunov 提交于
Do not check for SPUTIOUS_APIC_VECTOR definition twice. Check it once - is what we need. Signed-off-by: NCyrill Gorcunov <gorcunov@gmail.com> Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-
由 Cyrill Gorcunov 提交于
Signed-off-by: NCyrill Gorcunov <gorcunov@gmail.com> Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com> Signed-off-by: NIngo Molnar <mingo@elte.hu>
-