- 25 8月, 2014 2 次提交
-
-
由 Russell King 提交于
Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk> Signed-off-by: NShawn Guo <shawn.guo@freescale.com>
-
由 Russell King 提交于
Hummingboard has no over current hardware, so disable the over current detection for both ports. Cubox-i has over current hardware, so appropriately configure this. Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk> Signed-off-by: NShawn Guo <shawn.guo@freescale.com>
-
- 17 6月, 2014 2 次提交
-
-
由 Russell King 提交于
The configuration of the USB OTG is a platform configuration decision, not a microsom decision. Move this configuration out to the platform level files. Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk> Signed-off-by: NShawn Guo <shawn.guo@freescale.com>
-
由 Russell King 提交于
The front panel LED on the Cubox-i is driven by one of the iMX6 PWM channels, and is wired between the PWM output and supply. Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk> Signed-off-by: NShawn Guo <shawn.guo@freescale.com>
-
- 16 5月, 2014 1 次提交
-
-
由 Russell King 提交于
Add the HDMI DT configuration for the SolidRun HummingBoard and Cubox-i. Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk> Signed-off-by: NShawn Guo <shawn.guo@freescale.com>
-
- 09 2月, 2014 1 次提交
-
-
由 Russell King 提交于
The spdif pinmux configuration must be connected to the spdif device to take effect, not the spdif-transmitter. Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>
-
- 27 1月, 2014 2 次提交
-
-
由 Russell King 提交于
Add support for the SolidRun Cubox-i devices. This commit adds similar basic support as the HummingBoard. Further devices will be supported in future patches. Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>
-
由 Russell King 提交于
Add support for the SolidRun HummingBoard. This commit adds support for the following interfaces on this board: - Consumer Ir receiver - S/PDIF output - Both USB interfaces - Gigabit Ethernet using AR8035 - UART port Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>
-