Reviewed-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

On some nv4x cards (specifically, the ones that use an internal
PCIE->AGP bridge) the AGP controller state isn't preserved after a
suspend/resume cycle, and the AGP control registers have moved from
0x18xx to 0x100xx, so the FW check in nouveau_mem_reset_agp() doesn't
quite work. Check "dev->agp->mode" instead.
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Previously nouveau_mem_reset_agp() was only disabling AGP fast writes
when coming back from suspend. However, the "locked out of the card
because of FW" problem can also be reproduced on init if you
unload/reload nouveau.ko several times. This patch makes the AGP code
reset FW on init.
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

BIOS scripts usually make an attempt to reset the AGP controller,
however on some nv4x cards doing it properly involves switching FW off
and on: if we do that without updating the AGP bridge settings
accordingly (e.g. with the corresponding calls to agp_enable()) we
will be locking ourselves out of the card MMIO space. Do it from
nouveau_mem_reset_agp() before the init scripts are executed.
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Also collect all the PFB registers in a single place and remove some
duplicated definitions.
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

This removes the previous prepare_access() and finish_access() hooks, and
replaces it with a much simpler flush() hook.

All the chipset-specific code before nv50 has its use removed completely,
as it's not required there at all.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Luckily this had absolutely no effect whatsoever :)
Reported-by: NMarcin Slusarz <marcin.slusarz@gmail.com>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

It's far preferable to have the driver do nothing at all for "nomodeset".
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Remove the drm_resource wrappers and directly use the
actual PCI and/or platform functions in their place.

[airlied: fixup nouveau properly to build]
Signed-off-by: NJordan Crouse <jcrouse@codeaurora.org>
Reviewed-by: NMatt Turner <mattst88@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

As opposed to repeatedly reading the amount back from the GPU every
time we need to know the VRAM size.

We should now fail to load gracefully on detecting no VRAM, rather than
something potentially messy happening.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Fixes the !vbo_fifo path in the 3D driver on certain chipsets.  Still not
really any good idea of what exactly the magic achieves, but it makes
things work.

While we're at it, in the PCIEGART path, flush on unbinding also.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

This commit changes nouveau to construct PTEs which look very much like
the ones the binary driver creates.

I presume that filling multiple PTEs identically with length flags and
the physical address of the start of a block of VRAM is a hint to the
memory controller that it need not perform additional page table lookups
for that range of addresses.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

GART is handled elsewhere, no reason to have the code for it here too.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Currently, we take down the sgdma engine without evicting all buffers
from VRAM.

The TTM device release will try to evict anything in VRAM to GART
memory, but this will fail since sgdma has already been taken down.

This causes an infinite loop in kernel mode on module unload.
It usually doesn't happen because there aren't any buffer on close.
However, if the GPU is locked up, this condition is easily triggered.

This patch fixes it in the simplest way possible by cleaning VRAM
right before cleaning SGDMA memory.
Signed-off-by: NLuca Barbieri <luca@luca-barbieri.com>
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

This is to prevent things such as GART tables and other important GPU
structures being allocated there before we take over fbcon ourselves.

This is more of a workaround for the moment, a better solution will
require some more invasive changes, but it'll be done at some point.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

We don't setup PRIV0 anymore, so this is unnecessary.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

This commit has also the following 3 bugfix commits squashed into it from
the nouveau git tree:

drm/nouveau: Fix up the tiling alignment restrictions for nv1x.
drm/nouveau: Fix up the nv2x tiling alignment restrictions.
drm/nv50: fix align typo for g9x
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>

This commit has also the following 3 bugfix commits squashed into it from
the nouveau git tree:

drm/nouveau: Fix up the tiling alignment restrictions for nv1x.
drm/nouveau: Fix up the nv2x tiling alignment restrictions.
drm/nv50: fix align typo for g9x
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

This adds a drm/kms staging non-API stable driver for GPUs from NVIDIA.

This driver is a KMS-based driver and requires a compatible nouveau
userspace libdrm and nouveau X.org driver.

This driver requires firmware files not available in this kernel tree,
interested parties can find them via the nouveau project git archive.

This driver is reverse engineered, and is in no way supported by nVidia.

Support for nearly the complete range of nvidia hw from nv04->g80 (nv50)
is available, and the kms driver should support driving nearly all
output types (displayport is under development still) along with supporting
suspend/resume.

This work is all from the upstream nouveau project found at
nouveau.freedesktop.org.

The original authors list from nouveau git tree is:
Anssi Hannula <anssi.hannula@iki.fi>
Ben Skeggs <bskeggs@redhat.com>
Francisco Jerez <currojerez@riseup.net>
Maarten Maathuis <madman2003@gmail.com>
Marcin Kościelnicki <koriakin@0x04.net>
Matthew Garrett <mjg@redhat.com>
Matt Parnell <mparnell@gmail.com>
Patrice Mandin <patmandin@gmail.com>
Pekka Paalanen <pq@iki.fi>
Xavier Chantry <shiningxc@gmail.com>
along with project founder Stephane Marchesin <marchesin@icps.u-strasbg.fr>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>