ALSA sequencer
The last change to reduce stack usage did not adjust the parameter to
SNDRV_SEQ_IOCTL_SET_CLIENT_IOCTL which resulted in passing the address
of the pointer instead of the structure.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

AC97 Codec
Separated ac97 registers reset for audio and modem (or both) as recommended
in AC97 spec.
Signed-off-by: NSasha Khapyorsky <sashak@smlink.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

AC97 Codec
This (especially 12000 -> 8000 sample rate replace) fix popular
'MC97 converters.. not ready' error with modem codecs initializations.
Signed-off-by: NSasha Khapyorsky <sashak@smlink.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Intel8x0-modem driver
With some intel based ac97 modems codec access semaphore is not cleared
after 0x54 AC97 register (GPIO_STATUS) reads. This may causes problems
with newly applied modem mixer (Off-hook switch) and in other cases.
Signed-off-by: NSasha Khapyorsky <sashak@smlink.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

AC97 Codec
- Added CM9780 patch
- Fix the SPDIF support on CM9761/CM9780
- Allow the generic enum callback to pass any number (not power of 2)
  as the value mask
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

AC97 Codec
Removed unused variables (the old control definitions).
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

EMU10K1/EMU10K2 driver
Check ther revision to detect non-listed audigy 2 boards.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

USB generic driver
This patch adds quirks to support 24-bit PCM I/O in the 'Advanced
Driver' mode of the BOSS GS-10.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

ALSA sequencer
The last change to reduce stack usage did not adjust the parameter to
SNDRV_SEQ_IOCTL_CREATE_PORT which resulted in passing the address of
the pointer instead of the structure.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Timer Midlevel
Signed-off-by: NJaroslav Kysela <perex@suse.cz>

USB generic driver
Added the mixer mapping for Sound Blaster MP3+
by Pavel Mihaylov <bin@bash.info>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

EMU10K1/EMU10K2 driver
This add identification of Audigy 1 model SB0090 and fixes
problems with ac97 codec (mic not working).
Signed-off-by: NPeter Zubaj <pzad@pobox.sk>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

USB generic driver
This patch reintroduces the check for endpoint numbers that are
specified explicitly in the quirk structure.
This check was accidentally dropped in the last rewrite of
snd_usbmidi_detect_endpoints().
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

EMU10K1/EMU10K2 driver
Fixed the default id string in case identical multiple cards exist.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

EMU10K1/EMU10K2 driver
Use expliciitly the old default id strings for backward compatibility.
This will make 'alsactl restore' working again.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Documentation
Not complete, or even spell checked, but in case I don't get a chance to
work on it again before 1.0.9, here is what i have so far.  It should go
in alsa-kernel/Documentation/emu10k1-jack.txt.
Signed-off-by: NLee Revell <rlrevell@joe-job.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

EMU10K1/EMU10K2 driver
This patch converts the emu10k1 driver to use the card capabilities
structure for some more things.

Not extensively tested but seems to work.
Signed-off-by: NLee Revell <rlrevell@joe-job.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

ALSA sequencer
Fixed memory leak by the last change of stack reduction.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

AC97 Codec
Fixed the detection of bit resolution of ac97 mixer controls.
This will fix the problem with TI ac97 codecs.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

EMU10K1/EMU10K2 driver
Signed-off-by: NJames Courtier-Dutton <James@superbug.co.uk>

EMU10K1/EMU10K2 driver
Signed-off-by: NJames Courtier-Dutton <James@superbug.co.uk>

EMU10K1/EMU10K2 driver
One can select which capture source, but one cannot yet set volumes.
Signed-off-by: NJames Courtier-Dutton <James@superbug.co.uk>

HDA Codec driver
The patch_cm9880.c can't play side/C/B channels from front panel jacks.
I fixed it by adding select pin.
Signed-off-by: NChenLi Tien <cltien@cmedia.com.tw>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

CA0106 driver
Skip building ac97 SPDIF controls via AC97_SCAP_NO_SPDIF.
Clean up the code.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

HDA generic driver
During debugging for cm9880 multi-channel playback, I added the * after
the currently selected widget, mixer widget doesn't need this but other
3 widget types need it.
Signed-off-by: NChenLi Tien <cltien@cmedia.com.tw>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

ALSA<-OSS emulation
The Coverity checker found this obviously dead code.

I'm not sure which of the if (plugin == NULL) is correct - this patch
removes the one that couldn't be true.
Signed-off-by: NAdrian Bunk <bunk@stusta.de>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Even after the previous fix you can still set CONFIG_ACPI_BOOT
indirectly even without CONFIG_ACPI by choosing CONFIG_PCI and
CONFIG_PCI_MMCONFIG.

That doesn't build very well either.

This makes PCI_MMCONFIG depend on ACPI, fixing that hole.

[ I guess in theory Kconfig could follow the whole chain of dependencies
  for things that get selected, but that sounds insanely complicated, so
  we'll just fix up these things by hand.  --Linus ]
Signed-off-by: NAlexander Nyberg <alexn@telia.com>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Fix 2.6.12 CONFIG_ACPI=n build regression.
CONFIG_ACPI_BOOT shall be set only if CONFIG_ACPI.
Signed-off-by: NLen Brown <len.brown@intel.com>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

quirk_via_irqpic can't be __devinit for swsuspend
Signed-off-by: NAlexander Nyberg <alexn@telia.com>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Delete quirk_via_bridge(), restore quirk_via_irqpic() -- but now
improved to be invoked upon device ENABLE, and now only for VIA devices
-- not all devices behind VIA bridges.
Signed-off-by: NBjorn Helgaas <bjorn.helgaas@hp.com>
Signed-off-by: NLen Brown <len.brown@intel.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

There is a race in the kernel cpuset code, between the code
to handle notify_on_release, and the code to remove a cpuset.
The notify_on_release code can end up trying to access a
cpuset that has been removed.  In the most common case, this
causes a NULL pointer dereference from the routine cpuset_path.
However all manner of bad things are possible, in theory at least.

The existing code decrements the cpuset use count, and if the
count goes to zero, processes the notify_on_release request,
if appropriate.  However, once the count goes to zero, unless we
are holding the global cpuset_sem semaphore, there is nothing to
stop another task from immediately removing the cpuset entirely,
and recycling its memory.

The obvious fix would be to always hold the cpuset_sem
semaphore while decrementing the use count and dealing with
notify_on_release.  However we don't want to force a global
semaphore into the mainline task exit path, as that might create
a scaling problem.

The actual fix is almost as easy - since this is only an issue
for cpusets using notify_on_release, which the top level big
cpusets don't normally need to use, only take the cpuset_sem
for cpusets using notify_on_release.

This code has been run for hours without a hiccup, while running
a cpuset create/destroy stress test that could crash the existing
kernel in seconds.  This patch applies to the current -linus
git kernel.
Signed-off-by: NPaul Jackson <pj@sgi.com>
Acked-by: NSimon Derr <simon.derr@bull.net>
Acked-by: NDinakar Guniguntala <dino@in.ibm.com>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

The original pwc author raised some questions about the reverse
engineering of the decompressor algorithms used in the pwc driver.
Having done some detailed investigation it appears those concerns that
clean room policy was not followed are reasonable.  I've also had a
friendly discussion with Philips to ask their view on this.

This removes the problem items of code which reduces the pwc
functionality in the kernel a little but leaves all the framework for
setup that will be needed for decompressors in user space (where they
eventually belong).  This change set is designed to be the minimal risk
change set given that 2.6.12 is hopefully close to hand, with a view to
merging the much updated pwc code in 2.6.13 series kernels.

Someone else can then redo the decompressors properly (clean room) in
user space.

Note that while its easy to say that it should have been caught earlier,
but the violation was really only obvious to someone who had access to
both the proprietary source and the 'GPL' source.

The change to require the DMA length to be only word-aligned was not
safe.

We fixed this bug before, but it didn't take.  It may have been the case
that the problem was first noticed to occur in a CONFIG_REGPARM compile.
But it's not regparm functions that need not to make tail calls, it's
asmlinkage functions called with a user pt_regs frame on the stack
supplying their arguments.  prevent_tail_call probably doesn't do anything
at all in regparm functions (your argument registers are going to be
clobbered, period).  It was a braino to conditionalize that definition in
the first place.
Signed-off-by: NRoland McGrath <roland@redhat.com>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

A new driver bnx2 for Broadcom bcm5706 is available.

The patch also includes new 1000BASE-X advertisement bit definitions in
mii.h

Thanks to David Miller and Jeff Garzik for reviewing and their valuable
feedback.
Signed-off-by: NMichael Chan <mchan@broadcom.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

"_s" suffix is certainly of hungarian origin.
Signed-off-by: NAlexey Dobriyan <adobriyan@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>