- 27 7月, 2009 11 次提交
-
-
由 Sam Ravnborg 提交于
Reviewed the Makefile on request by Michal and this is the resulting changes. o Use ':=' for assignmnet so we do not re-evaluate for each use o Use $(shell echo xxx) to remove "" o Replaced CFLAGS_KERNEL with KBUILD_CFLAGS The settings are equally relevant for modules and the linked kernel o Dropped LDFLAGS_BLOB - it is no longer used o Refactored assignmnets to libs-y and core-y o Use MMU for the MMU specific extension. "MMUEXT" was hurting my eyes and I did not wanted it spread to m68k Signed-off-by: NSam Ravnborg <sam@ravnborg.org> Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Michal Simek 提交于
Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Michal Simek 提交于
For example reiserfs use this relocation type. Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 John Williams 提交于
New reloc type R_MICROBLAZE_32_PCREL_LO requires a null handler (no work to do). Remove legacy hack for broken linker pre gcc-4.1.1, that required us to extract an offset from the code, add it to the addend, then rewrite the instruction. Fixup the invalid reloc type error output. Boot tested with the xilinx_emaclite ethernet driver. Signed-off-by: NJohn Williams <john.williams@petalogix.com> Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Arnd Bergmann 提交于
The ipc system call is now unused in microblaze, as the system call table points directly to the indidual system calls for IPC. Signed-off-by: NArnd Bergmann <arnd@arndb.de> Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Michal Simek 提交于
This patch add support for cases where load/store instruction in put/get_user macro gets unaligned pointer to data and this address is not valid. I prevent all cases which can failed. I had to disable first stage of unaligned handler which is used only for noMMU kernel and the whole work is done when interrupt is enabled. You have enable HW support for detect unaligned access in Microblaze. This patch fixed three LTP tests: getpeername01, getsockname01, socketpair01 Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Michal Simek 提交于
Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Michal Simek 提交于
It is necessary to zeroed r7 when r7 points to bad dtb - this caused that we have correct messages about compiled-in dtb or passing via r7 Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Michal Simek 提交于
I can't clear r7 because if I do it I lose information where DTB come from. Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Michal Simek 提交于
Print accurate message about place where FDT blob is. Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 John Williams 提交于
If r7 is zero at kernel boot, or does not point to a valid DTB, then we fall back to a DTB (assumed to be) linked statically in the kernel, instead of blindly copying bogus cruft into the kernel DTB memory region Signed-off-by: NJohn Williams <john.williams@petalogix.com> Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
- 13 7月, 2009 1 次提交
-
-
由 Alexey Dobriyan 提交于
* Remove smp_lock.h from files which don't need it (including some headers!) * Add smp_lock.h to files which do need it * Make smp_lock.h include conditional in hardirq.h It's needed only for one kernel_locked() usage which is under CONFIG_PREEMPT This will make hardirq.h inclusion cheaper for every PREEMPT=n config (which includes allmodconfig/allyesconfig, BTW) Signed-off-by: NAlexey Dobriyan <adobriyan@gmail.com> Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
-
- 06 7月, 2009 3 次提交
-
-
由 Michal Simek 提交于
Wire up new syscalls rt_tgsigqueueinfo and perf_counter_open. Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Arnd Bergmann 提交于
The prototypes in syscalls.h all make sense for microblaze, but for some of them, the actual implementation in sys_microblaze.c needs to be adapted. Signed-off-by: NArnd Bergmann <arnd@arndb.de> Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Arnd Bergmann 提交于
When legacy signal handling is disabled, the arch/microblaze/kernel/signal.c implementation can be much simpler, as most of it is handled generically from kernel/signal.c. This is also a prerequisite for using the generic asm/unistd.h, which does not provide __NR_sigreturn, because this macro is referenced by the current signal.c implementation. Signed-off-by: NArnd Bergmann <arnd@arndb.de> Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
- 20 6月, 2009 2 次提交
-
-
由 Michal Simek 提交于
Commit b99b87f7 add CONSTRUCTOR support to Linux but Microblaze not defined KERNEL_CTORS symbols which are used with that patch. This patch fixed it. Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Arnd Bergmann 提交于
Alexey removed the definition for init_mm from all architectures but forgot microblaze, which was only recently added. This fixes the microblaze build by dropping it there as well. Cc: Alexey Dobriyan <adobriyan@gmail.com> Signed-off-by: NArnd Bergmann <arnd@arndb.de> Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
- 30 5月, 2009 1 次提交
-
-
由 Michal Simek 提交于
Problem arise when is incopatibility between kernel/dts/pvr and kernel tries to announce it. Early printk device (uartlite in our case) was in TLB 2 and when kernel extract DTB it necessary to allocate at least one TLB at the end of memory. First free TLB was number two where was early printk. But checking mechanism (kernel/dts/pvr) was after extrahing but TLB 2 was different. This caused that kernel hung up. Moving early printk device to TLB 63 solve it and we don't protect it which means that we can use early_printk messages only for initial parts of kernel then we rewrite TLB 63. Reported-by: NEdgar E. Iglesias <edgar.iglesias@gmail.com> Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
- 26 5月, 2009 13 次提交
-
-
由 Michal Simek 提交于
Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Michal Simek 提交于
Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Michal Simek 提交于
Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Michal Simek 提交于
Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Michal Simek 提交于
Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Michal Simek 提交于
Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Michal Simek 提交于
Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Michal Simek 提交于
Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Michal Simek 提交于
Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Michal Simek 提交于
Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Michal Simek 提交于
Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Michal Simek 提交于
Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Michal Simek 提交于
Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
- 21 5月, 2009 8 次提交
-
-
由 Michal Simek 提交于
__va expect 32bit value but of_read_ulong(of_read_number) returns 64bit value Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Michal Simek 提交于
This patch is based on patch from Steve Magnani. There were bug for compiled-in rootfs. We have to move moving rootfs which is in BSS section to _ebss section which is at the end of kernel and then clear bss section not vice-versa. Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Michal Simek 提交于
This patch fixed parsing early parameters because current implementation does that early parse DTS command line and then parse CMDLINE line which is compiled-in. For case that DTS doesn't contain command line is copied command line from kernel with is done in prom.c that's why I can remove it from machine_early_init. Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Michal Simek 提交于
We need to define set_restore_sigmask() in order to get pselect and ppoll. Also, the setup_frame function can not be used when __NR_sigreturn is not defined. Signed-off-by: NArnd Bergmann <arnd@arndb.de> Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Arnd Bergmann 提交于
The security subsystem has its own initcalls, which need support in vmlinux.lds.S. Signed-off-by: NArnd Bergmann <arnd@arndb.de> Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Arnd Bergmann 提交于
The whole point of the __bad_xchg declaration in system.h is to give a linker error when a variable of invalid size is passed to __xchg. The out of line definition in traps.c defeats this purpose and does not any value, so remove it here. Signed-off-by: NArnd Bergmann <arnd@arndb.de> Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Arnd Bergmann 提交于
The microblaze signal handling code gets some __user pointers wrong, as shown by sparse. This adds the annotations where appropriate and change sys_rt_sigreturn to correctly pass a user stack down to do_sigaltstack instead of a kernel structure. Signed-off-by: NArnd Bergmann <arnd@arndb.de> Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
由 Arnd Bergmann 提交于
Some device drivers require the symbols _ebss, kernel_thread, __page_offset or ___range_ok, so export them. Signed-off-by: NArnd Bergmann <arnd@arndb.de> Signed-off-by: NMichal Simek <monstr@monstr.eu>
-
- 18 5月, 2009 1 次提交
-
-
由 Michal Simek 提交于
+ Fix typographic fault. Signed-off-by: NMichal Simek <monstr@monstr.eu>
-