Merge branch 'pm-upstream/fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/khilman/linux-omap-pm into devel-stable

Signed-off-by: NKevin Hilman <khilman@deeprootsystems.com>

If IRQ triggering is enabled, it can trigger a pending interrupt
even for masked interrupts.  Any pending GPIO interrupts can
prevent the powerdomain from hitting retention.

Problem found, reported and additional review and testing by Chunquiu
Wang.
Tested-by: NChunquiu Wang <cqwang@motorola.com>
Signed-off-by: NKevin Hilman <khilman@deeprootsystems.com>

Powerdomain previous state is checked after restoring new states in
suspend. This patch fixes this problem.
Signed-off-by: NJouni Hogander <jouni.hogander@nokia.com>
Signed-off-by: NKevin Hilman <khilman@deeprootsystems.com>

Use the min/max settings from CPUfreq policy rather than
processor defined min/max settings.

Without this patch, it's possible to scale frequency outside
the current policy range.
Signed-off-by: NEero Nurkkala <ext-eero.nurkkala@nokia.com>
Signed-off-by: NKevin Hilman <khilman@deeprootsystems.com>

Use list_add_tail() when adding discovered UART ports.  This is so
traversal using list_for_each_entry() will traverse the list in the
order they were found.
Signed-off-by: NKevin Hilman <khilman@deeprootsystems.com>

This patch causes the OMAP uarts to honor the sysfs power/wakeup file
for IOPAD wakeups. Before the OMAP was always woken up from off mode
on a rs232 signal change.  This patch also creates a different
platform device for each serial port so that the wakeup properties can
be control per port.

By default, IOPAD wakeups are enabled for each UART.  To disable,

  # echo disabled > /sys/devices/platform/serial8250.0/power/wakeup

Where serial8250.0 can be replaced by .1, or .2 to control the other
ports.

Original idea and original patch from Russ Dill <russ.dill@gmail.com>

Cc: Russ Dill <russ.dill@gmail.com>
Signed-off-by: NKevin Hilman <khilman@deeprootsystems.com>

It was possible for an unhandled interrupt to occur if there was incoming
serial traffic during wakeup from suspend. This was caused by the code
in arch-arm/mach-omap2/serial.c keeping interrupt enabled all the time,
but not acking its interrupts. Applies on top of PM branch.

Use the PM begin/end hooks to ensure that the "serial idle" interrupts
are disabled during the suspend path.  Also, since begin/end hooks are
now used, use the suspend_state that is passed in the begin hook instead
of the enter hook as per the platform_suspend_ops docs.
Signed-off-by: NTero Kristo <tero.kristo@nokia.com>
Signed-off-by: NKevin Hilman <khilman@deeprootsystems.com>

Streamline the OMAP4 special IRQ assignments by putting inside
normal init loop instead of having a separate loop.
Signed-off-by: NKevin Hilman <khilman@deeprootsystems.com>

Signed-off-by: NJouni Hogander <jouni.hogander@nokia.com>
Signed-off-by: NKevin Hilman <khilman@deeprootsystems.com>

By default, prevent functional wakeups from inside a module from
waking up the IVA2.  Let DSP Bridge code handle this when loaded.
Signed-off-by: NKevin Hilman <khilman@deeprootsystems.com>

Any pending reset flags can prevent retention.  Ensure they are all
cleared during boot.
Signed-off-by: NKevin Hilman <khilman@deeprootsystems.com>

Any pending PRCM interrupts can prevent retention.  Ensure
they are cleared during boot.
Signed-off-by: NKevin Hilman <khilman@deeprootsystems.com>

Signed-off-by: NKevin Hilman <khilman@deeprootsystems.com>

Signed-off-by: NKevin Hilman <khilman@deeprootsystems.com>

Merge branch 'omap4_upstream' of git://dev.omapzoom.org/pub/scm/santosh/kernel-omap4-base into devel-stable

* 'for-linus' of git://oss.sgi.com/xfs/xfs:
  xfs: bump up nr_to_write in xfs_vm_writepage
  xfs: reduce bmv_count in xfs_vn_fiemap

* 'for-linus' of git://git.kernel.dk/linux-2.6-block:
  io context: fix ref counting
  block: make the end_io functions be non-GPL exports
  block: fix improper kobject release in blk_integrity_unregister
  block: always assign default lock to queues
  mg_disk: Add missing ready status check on mg_write()
  mg_disk: fix issue with data integrity on error in mg_write()
  mg_disk: fix reading invalid status when use polling driver
  mg_disk: remove prohibited sleep operation

Merge branch 'timers-fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/linux-2.6-tip

* 'timers-fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/linux-2.6-tip:
  clocksource: Save mult_orig in clocksource_disable()

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/drzeus/mmc:
  mmc: orphan subsystem
  imxmmc: Remove unnecessary semicolons
  cb710: use SG_MITER_TO_SG/SG_MITER_FROM_SG
  sdhci: use SG_MITER_TO_SG/SG_MITER_FROM_SG
  lib/scatterlist: add a flags to signalize mapping direction

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tiwai/sound-2.6:
  ALSA: sound/aoa: Add kmalloc NULL tests
  ALSA: hda - Increase PCM stream name buf in patch_realtek.c
  sound: mpu401.c: Buffer overflow
  sound: aedsp16: Buffer overflow
  ALSA: hda: fix out-of-bound hdmi_eld.sad[] write
  ALSA: hda - Add quirk for Dell Studio 1555

To fix the common case where ->enable() does not set up
mult, make sure mult_orig is saved in mult on disable.

Also add comments to explain why we do this.
Signed-off-by: NMagnus Damm <damm@igel.co.jp>
Cc: johnstul@us.ibm.com
Cc: lethal@linux-sh.org
Cc: akpm@linux-foundation.org
LKML-Reference: <20090618152432.10136.9932.sendpatchset@rx1.opensource.se>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

I do not have the time to take care of this, so remove myself as
maintainer.
Signed-off-by: NPierre Ossman <pierre@ossman.eu>

Signed-off-by: NJoe Perches <joe@perches.com>
Acked-by: NPavel Pisa <pisa@cmp.felk.cvut.cz>
Signed-off-by: NPierre Ossman <pierre@ossman.eu>

the code allready uses flush_kernel_dcache_page(). This patch updates the
driver to the recent sg API changes which require that either SG_MITER_TO_SG
or SG_MITER_FROM_SG is set. SG_MITER_TO_SG calls flush_kernel_dcache_page()
in sg_mitter_stop()
Signed-off-by: NSebastian Andrzej Siewior <sebastian@breakpoint.cc>
Acked-by: NMichał Mirosław <mirq-linux@rere.qmqm.pl>
Signed-off-by: NPierre Ossman <pierre@ossman.eu>

so the page will be flushed on unmap on ARCH which need it.
Signed-off-by: NSebastian Andrzej Siewior <sebastian@breakpoint.cc>
Signed-off-by: NPierre Ossman <pierre@ossman.eu>

sg_miter_start() is currently unaware of the direction of the copy
process (to or from the scatter list). It is important to know the
direction because the page has to be flushed in case the data written
is seen on a different mapping in user land on cache incoherent
architectures.
Signed-off-by: NSebastian Andrzej Siewior <sebastian@breakpoint.cc>
Acked-by: NFUJITA Tomonori <fujita.tomonori@lab.ntt.co.jp>
Acked-by: NTejun Heo <tj@kernel.org>
Signed-off-by: NPierre Ossman <pierre@ossman.eu>

* fix/oss:
  sound: mpu401.c: Buffer overflow
  sound: aedsp16: Buffer overflow

* fix/misc:
  ALSA: sound/aoa: Add kmalloc NULL tests

* fix/hda:
  ALSA: hda - Increase PCM stream name buf in patch_realtek.c
  ALSA: hda: fix out-of-bound hdmi_eld.sad[] write
  ALSA: hda - Add quirk for Dell Studio 1555

Check that the result of kzalloc is not NULL before a dereference.

The semantic match that finds this problem is as follows:
(http://www.emn.fr/x-info/coccinelle/)

// <smpl>
@@
expression *x;
identifier f;
constant char *C;
@@

x = \(kmalloc\|kcalloc\|kzalloc\)(...);
... when != x == NULL
    when != x != NULL
    when != (x || ...)
(
kfree(x)
|
f(...,C,...,x,...)
|
*f(...,x,...)
|
*x->f
)
// </smpl>
Signed-off-by: NJulia Lawall <julia@diku.dk>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The name buf with size 16 is too short for some codec names, e.g.
truncated like "ALC861-VD Analo".  Now the size is doubled.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Commit d9c7d394
("block: prevent possible io_context->refcount overflow") mistakenly
changed atomic_inc(&ioc->nr_tasks) to atomic_long_inc(&ioc->refcount).
Signed-off-by: NLi Zefan <lizf@cn.fujitsu.com>
Acked-by: NNikanth Karthikesan <knikanth@suse.de>
Signed-off-by: NJens Axboe <jens.axboe@oracle.com>

VM calculation for nr_to_write seems off.  Bump it way
up, this gets simple streaming writes zippy again.
To be reviewed again after Jens' writeback changes.
Signed-off-by: NChristoph Hellwig <hch@infradead.org>
Signed-off-by: NEric Sandeen <sandeen@sandeen.net>
Cc: Chris Mason <chris.mason@oracle.com>
Reviewed-by: NFelix Blyakher <felixb@sgi.com>
Signed-off-by: NFelix Blyakher <felixb@sgi.com>

commit 6321e3ed caused
the full bmv_count's worth of getbmapx structures to get
allocated; telling it to do MAXEXTNUM was a bit insane,
resulting in ENOMEM every time.

Chop it down to something reasonable, the number of slots
in the caller's input buffer.  If this is too large the
caller may get ENOMEM but the reason should not be a
mystery, and they can try again with something smaller.

We add 1 to the value because in the normal getbmap
world, bmv_count includes the header and xfs_getbmap does:

        nex = bmv->bmv_count - 1;
        if (nex <= 0)
                return XFS_ERROR(EINVAL);
Signed-off-by: NEric Sandeen <sandeen@sandeen.net>
Reviewed-by: NOlaf Weber <olaf@sgi.com>
Reviewed-by: NChristoph Hellwig <hch@lst.de>
Signed-off-by: NFelix Blyakher <felixb@sgi.com>

Merge branch 'tracing-fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/linux-2.6-tip

* 'tracing-fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/linux-2.6-tip:
  tracing/stat: Fix seqfile memory leak
  function-graph: Fix seqfile memory leak
  trace_stack: Fix seqfile memory leak
  profile: Suppress warning about large allocations when profile=1 is specified

* git://git.kernel.org/pub/scm/linux/kernel/git/mason/btrfs-unstable:
  Btrfs: be more polite in the async caching threads
  Btrfs: preserve commit_root for async caching

* 'next' of git://git.kernel.org/pub/scm/linux/kernel/git/djbw/async_tx:
  dmaengine: at_hdmac: add DMA slave transfers
  dmaengine: at_hdmac: new driver for the Atmel AHB DMA Controller
  dmaengine: dmatest: correct thread_count while using multiple thread per channel
  dmaengine: dmatest: add a maximum number of test iterations
  drivers/dma: Remove unnecessary semicolons
  drivers/dma/fsldma.c: Remove unnecessary semicolons
  dmaengine: move HIGHMEM64G restriction to ASYNC_TX_DMA
  fsldma: do not clear bandwidth control bits on the 83xx controller
  fsldma: enable external start for the 83xx controller
  fsldma: use PCI Read Multiple command

* 'for_linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jack/linux-udf-2.6:
  udf: Fix loading of VAT inode when drive wrongly reports number of recorded blocks