intel_pstate: Avoid getting stuck in high P-states when idle

Jörg Otte reports that commit a4675fbc (cpufreq: intel_pstate:
Replace timers with utilization update callbacks) caused the CPUs in
his Haswell-based system to stay in the very high frequency region
even if the system is completely idle.

That turns out to be an existing problem in the intel_pstate driver's
P-state selection algorithm for Core processors.  Namely, all
decisions made by that algorithm are based on the average frequency
of the CPU between sampling events and on the P-state requested on
the last invocation, so it may get stuck at a very hight frequency
even if the utilization of the CPU is very low (in fact, it may get
stuck in a inadequate P-state regardless of the CPU utilization).
The only way to kick it out of that limbo is a sufficiently long idle
period (3 times longer than the prescribed sampling interval), but if
that doesn't happen often enough (eg. due to a timing change like
after the above commit), the P-state of the CPU may be inadequate
pretty much all the time.

To address the most egregious manifestations of that issue, reset the
core_busy value used to determine the next P-state to request if the
utilization of the CPU, determined with the help of the MPERF
feedback register and the TSC, is below 1%.

Link: https://bugzilla.kernel.org/show_bug.cgi?id=115771Reported-and-tested-by: NJörg Otte <jrg.otte@gmail.com>
Signed-off-by: NRafael J. Wysocki <rafael.j.wysocki@intel.com>

drivers/cpufreq/intel_pstate.c

@@ -1130,6 +1130,10 @@ static inline int32_t get_target_pstate_use_performance(struct cpudata *cpu)
 		sample_ratio = div_fp(int_tofp(pid_params.sample_rate_ns),
 				      int_tofp(duration_ns));
 		core_busy = mul_fp(core_busy, sample_ratio);
+	} else {
+		sample_ratio = div_fp(100 * cpu->sample.mperf, cpu->sample.tsc);
+		if (sample_ratio < int_tofp(1))
+			core_busy = 0;
 	}
 
 	cpu->sample.busy_scaled = core_busy;