[MIPS] Malta: Fix reading the PCI clock frequency on big-endian

The JMPRS register on Malta boards keeps a 32-bit CPU-endian
value. The readw() function assumes that the value it reads is a
little-endian 16-bit number. Therefore, using readw() to obtain
the value of the JMPRS register is a mistake. This error leads
to incorrect reading of the PCI clock frequency on big-endian
during board start-up.

Change readw() to __raw_readl().

This was tested by injecting a call to printk() and verifying
that the value of the jmpr variable was consistent with current
setting of the JP4 "PCI CLK" jumper.
Signed-off-by: NDmitri Vorobiev <dmitri.vorobiev@gmail.com>
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

arch/mips/mips-boards/malta/malta_setup.c

@@ -149,7 +149,7 @@ void __init plat_mem_setup(void)
 	/* Check PCI clock */
 	{
 		unsigned int __iomem *jmpr_p = (unsigned int *) ioremap(MALTA_JMPRS_REG, sizeof(unsigned int));
-		int jmpr = (readw(jmpr_p) >> 2) & 0x07;
+		int jmpr = (__raw_readl(jmpr_p) >> 2) & 0x07;
 		static const int pciclocks[] __initdata = {
 			33, 20, 25, 30, 12, 16, 37, 10
 		};