提交 65bb723c 编写于 作者: G Gerrit Renker 提交者: David S. Miller

[TCP]: Update references in two old comments

This updates references to drafts in comments which must be about 10
years old.  Internet draft draft-ietf-tcpimpl-prob-03.txt expired in 1998
and was replaced by RFC 2525 in March 1999.

Section 3.10 of the draft maps almost identically into section 2.17 of RFC
2525: both are entitled "Failure to RST on close with data pending", the
differences in text body amount to a typo and minor sentence change.
Signed-off-by: NGerrit Renker <gerrit@erg.abdn.ac.uk>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
上级 ecfd6b18
......@@ -1573,14 +1573,12 @@ void tcp_close(struct sock *sk, long timeout)
sk_stream_mem_reclaim(sk);
/* As outlined in draft-ietf-tcpimpl-prob-03.txt, section
* 3.10, we send a RST here because data was lost. To
* witness the awful effects of the old behavior of always
* doing a FIN, run an older 2.1.x kernel or 2.0.x, start
* a bulk GET in an FTP client, suspend the process, wait
* for the client to advertise a zero window, then kill -9
* the FTP client, wheee... Note: timeout is always zero
* in such a case.
/* As outlined in RFC 2525, section 2.17, we send a RST here because
* data was lost. To witness the awful effects of the old behavior of
* always doing a FIN, run an older 2.1.x kernel or 2.0.x, start a bulk
* GET in an FTP client, suspend the process, wait for the client to
* advertise a zero window, then kill -9 the FTP client, wheee...
* Note: timeout is always zero in such a case.
*/
if (data_was_unread) {
/* Unread data was tossed, zap the connection. */
......
......@@ -2035,7 +2035,7 @@ void tcp_send_fin(struct sock *sk)
/* We get here when a process closes a file descriptor (either due to
* an explicit close() or as a byproduct of exit()'ing) and there
* was unread data in the receive queue. This behavior is recommended
* by draft-ietf-tcpimpl-prob-03.txt section 3.10. -DaveM
* by RFC 2525, section 2.17. -DaveM
*/
void tcp_send_active_reset(struct sock *sk, gfp_t priority)
{
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册