Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>

This patch against 2.6.27-rc3 does the following changes to FSG-3 setup code:

1) Enable RTC on FSG-3 (proper name is needed). This change is needed due to a recent change in i2c.

2) i variable is only used when compiling for big endian.
So move its declaration to ARMEB ifdef to silence the warning when compiling for LE.

Mailing list link:
http://lists.arm.linux.org.uk/lurker/message/20080813.091556.cae2917e.en.htmlSigned-off-by: NTomasz Chmielewski <mangoo@wpkg.org>
Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>

The Freecom-FSG3 is a small network-attached-storage device with the
following feature set:

* Intel IXP422
* 4MB Flash (ixp4xx flash driver)
* 64MB RAM
* 4 USB 2.0 host ports (ehci and ohci drivers)
* 1 WAN (eth1) and 3 LAN (eth0) ethernet ports
  * Supported by the open source ixp4xx ethernet driver
* Via VT6421 disk controller (libata and sata-via drivers)
  * Internal hard disk (PATA supported, SATA not yet supported)
  * External SATA port (not yet supported)
* ISL1208 RTC chip
* Winbond 83782 temp sensor and fan controller
* MiniPCI slot

The ixp4xx_defconfig is also updated to support this device (the
leds-fsg driver is to be submitted separately via the leds tree after
this initial support is merged, as it depends on header gpio defines).
Signed-off-by: NRod Whitby <rod@whitby.id.au>
Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>