Skip to content

L
linux

xiphi1978 / linux

通知 2
Star 0
Fork 0
L
linux

体验新版 GitCode，发现更多精彩内容 >>

切换分支/标签
  1. 01 12月, 2009 23 次提交
  3. 30 11月, 2009 11 次提交
  5. 29 11月, 2009 2 次提交
    • A
      PM: fix irq enable/disable in runtime PM code · 862f89b3
      由 Alan Stern 提交于 
      This patch (as1305) fixes a bug in the irq-enable settings and removes
some related overhead in the runtime PM code.

	In __pm_runtime_resume(), within the scope of the original
	spin_lock_irq(), we know that irqs are disabled.  There's no
	reason to go through a pair of enable/disable cycles when
	acquiring and releasing the parent's lock.

	In __pm_runtime_set_status(), irqs are already disabled when
	the parent's lock is acquired, and they must remain disabled
	when it is released.
Signed-off-by: NAlan Stern <stern@rowland.harvard.edu>
Signed-off-by: NRafael J. Wysocki <rjw@sisk.pl>
      862f89b3
    • A
      sctp: on T3_RTX retransmit all the in-flight chunks · 5fdd4bae
      由 Andrei Pelinescu-Onciul 提交于 
      When retransmitting due to T3 timeout, retransmit all the
in-flight chunks for the corresponding  transport/path, including
chunks sent less then 1 rto ago.
This is the correct behaviour according to rfc4960 section 6.3.3
E3 and
"Note: Any DATA chunks that were sent to the address for which the
 T3-rtx timer expired but did not fit in one MTU (rule E3 above)
 should be marked for retransmission and sent as soon as cwnd
 allows (normally, when a SACK arrives). ".

This fixes problems when more then one path is present and the T3
retransmission of the first chunk that timeouts stops the T3 timer
for the initial active path, leaving all the other in-flight
chunks waiting forever or until a new chunk is transmitted on the
same path and timeouts (and this will happen only if the cwnd
allows sending new chunks, but since cwnd was dropped to MTU by
the timeout => it will wait until the first heartbeat).

Example: 10 packets in flight, sent at 0.1 s intervals on the
primary path. The primary path is down and the first packet
timeouts. The first packet is retransmitted on another path, the
T3 timer for the primary path is stopped and cwnd is set to MTU.
All the other 9 in-flight packets will not be retransmitted
(unless more new packets are sent on the primary path which depend
on cwnd allowing it, and even in this case the 9 packets will be
retransmitted only after a new packet timeouts which even in the
best case would be more then RTO).

This commit reverts d0ce9291 and
also removes the now unused transport->last_rto, introduced in
 b6157d8e.

p.s  The problem is not only when multiple paths are there.  It
can happen in a single homed environment.  If the application
stops sending data, it possible to have a hung association.
Signed-off-by: NAndrei Pelinescu-Onciul <andrei@iptel.org>
Signed-off-by: NVlad Yasevich <vladislav.yasevich@hp.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      5fdd4bae
  7. 28 11月, 2009 4 次提交