Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

They fixed the hardware so that ECC doesn't fail on reading an empty
block.
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Fixes http://dev.laptop.org/ticket/237Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Being a value which isn't in the table is a case we explicitly check for
in the caller. Don't BUG_ON() because it does actually happen in
practice.
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Conflicts:

	drivers/mtd/nand/Kconfig

Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Ditch the separate oobrbuf and oobwbuf fields from the chip buffers,
and use only a single buffer immediately after the data. This accommodates
NAND controllers such as the OLPC CAFÉ chip, which can't do scatter/gather
DMA so needs the OOB buffer to be contiguous with the data, for both read
and write.
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

As flash cannot do 0->1 bit transitions when programming, do not do this in
the simulator too. This makes nandsim able to accept subpage writes.
Signed-off-by: NArtem Bityutskiy <dedekind@infradead.org>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

During some testing with several samsung s3c24xx based
devices it was discovered that often the
cfi_cmdset_0001.c would not leave the chip in
read-array mode on suspend. this is an issue if the
same flash chip is used for the bootloader that needs
to be read on resume.
Signed-off-by: NDavid Anders <danders@amltd.com>
Signed-off-by: NNicolas Pitre <nico@cam.org>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NArtem Bityutskiy <dedekind@infradead.org>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Removes line break after return type in function definitions, to be
consistent with the Linux coding style.
Signed-off-by: NVijay Kumar <vijaykumar@bravegnu.org>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

For page wise allocation, an array of flash page pointers is allocated
during initialization. The flash pages are themselves allocated when a
write occurs to the page. The flash pages are deallocated when they
are erased.
Signed-off-by: NVijay Kumar <vijaykumar@bravegnu.org>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

This patch removes code that does chip mapping. The chip mapping code
is no longer used.
Signed-off-by: NVijay Kumar <vijaykumar@bravegnu.org>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

This patch has removed ITE 8172G and Globespan IVR MTD support.
These boards support have already been removed.
Signed-off-by: NYoichi Yuasa <yoichi_yuasa@tripeaks.co.jp>
Acked-by: NRalf Bächle <ralf@linux-mips.org>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

1. The ECCGETLAYOUT ioctl copy_to_user() call has a superfluous '&'
causing the resulting information to be garbage rather than the intended
mtd->ecclayout.

2. The MEMGETOOBSEL misses copying mtd->ecclayout->eccbytes so the
resulting field of the returned structure contains garbage.
Signed-off-by: NRicard Wanderlöf <ricardw@axis.com>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

This version only differs from version posted by Savin Zlobec (20 Jun
2006) in that the AT91RM9200-specific chip-select / bus setup code has
been moved from the at91_nand.c driver into the processor-specific file.

From: Savin Zlobec <savin@epico.si>
Signed-off-by: NAndrew Victor <andrew@sanpeople.com>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

typo fix: noticed this typo while reading the patch
"jffs2: fix symlink error handling"
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Fairly self explanatory.  Keep a reference initially, drop it when we free up
the driver resources.
Signed-off-by: NAlan Cox <alan@redhat.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NAlexey Dobriyan <adobriyan@gmail.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Use rb_first() and rb_last() to implement frag_first() and frag_last().
Signed-off-by: NAkinbou Mita <akinobu.mita@gmail.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Add MTD map driver for BIOS flash chips connected to the Intel ESB2
southbridge.

[akpm@osdl.org: coding-style fixes, build fix]
Signed-off-by: NRyan Jackson <rjackson@lnxi.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Add chip driver and JEDEC probe support for the SST 49LF040B flash chip.
Signed-off-by: NRyan Jackson <rjackson@lnxi.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

The 2 bits controlling the window size are often set to allow reading the
BIOS, but too small to allow writing, since the lock registers are 4MiB
lower in the address space than the data.  This is intended to prevent
flashing the bios, perhaps accidentally.

The bits are 6 and 7.  If both bits are set, it is a 5MiB window. If only
the 7 Bit is set, it is a 4MiB window.  Otherwise, it is a 64KiB window.

This parameter allows the driver to override the BIOS settings.
Signed-off-by: NRyan Jackson <rjackson@lnxi.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

This was apparently missed by the move to the generic IRQ code.
Signed-off-by: NNicolas Pitre <nico@cam.org>
Cc: Greg KH <greg@kroah.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Use grep instead of make during interface changes.
Signed-off-by: NOlaf Hering <olaf@aepfle.de>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

check_perm() does not drop the reference to the module when kzalloc()
failure occurs.
Signed-Off-By: NChandra Seetharaman <sekharan@us.ibm.com>
Signed-off-by: NJoel Becker <joel.becker@oracle.com>
Signed-off-by: NMark Fasheh <mark.fasheh@oracle.com>

The loop within ocfs2_zero_extend() can execute for a long time, causing
spurious soft lockup warnings.
Signed-off-by: NMark Fasheh <mark.fasheh@oracle.com>

The page zeroing code was missing the region between old i_size and new
i_size for those extends that didn't actually require a change in space
allocation.
Signed-off-by: NMark Fasheh <mark.fasheh@oracle.com>

This was causing some folks to incorrectly get -EBUSY during rename.
Signed-off-by: NSunil Mushran <sunil.mushran@oracle.com>
Signed-off-by: NMark Fasheh <mark.fasheh@oracle.com>

This patch deletes redundant memcmp() while looking up in rb tree.
Signed-off-by: NAkinbou Mita <akinobu.mita@gmail.com>
Signed-off-by: NMark Fasheh <mark.fasheh@oracle.com>

* 'upstream' of git://ftp.linux-mips.org/pub/scm/upstream-linus:
  [MIPS] Fix iounmap argument to const volatile.
  [MIPS] Reserve syscall numbers for kexec_load.
  [MIPS] Update tb0287_defconfig
  [MIPS] Update pnx8550-v2pci_defconfig
  [MIPS] Update pnx8500-jbs_defconfig
  [MIPS] More vr41xx pt_regs fixups
  [MIPS] save_context_stack fix
  [MIPS] Use compat_sys_mount.
  [MIPS] Fix O32 personality(2) call with 0xffffffff argument.
  [MIPS] A few more pt_regs fixups.
  [MIPS] Malta: Fix uninitialized regs pointer.
  [MIPS] Delete unneeded pt_regs forward declaration.
  [MIPS] Use kallsyms_lookup_size_offset() instead of kallsyms_lookup()

This reverts commit 4596c75c as
requested by Olaf Hering. It causes compile errors, and says Olaf:

  "This change is also wrong, the autoloading works perfect with 2.6.18,
   no need to add random PCI ids.

   See commit a0245f7a, platform devices
   have now a modalias entry in sysfs.  The network card is not a PCI
   device."
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

* git://git.kernel.org/pub/scm/linux/kernel/git/herbert/crypto-2.6:
  [CRYPTO] api: Select cryptomgr where needed
  [CRYPTO] api: fix crypto_alloc_base() return value

* git://git.kernel.org/pub/scm/linux/kernel/git/steve/gfs2-2.6-fixes:
  [GFS2] gfs2_dir_read_data(): fix uninitialized variable usage
  [GFS2] fs/gfs2/ops_fstype.c:fill_super_meta(): fix NULL dereference
  [GFS2] fs/gfs2/dir.c:gfs2_dir_write_data(): don't use an uninitialized variable
  [GFS2] fs/gfs2/ops_fstype.c:gfs2_get_sb_meta(): remove unused variable
  [GFS2] fs/gfs2/dir.c:gfs2_dir_write_data(): remove dead code
  [GFS2] gfs2 endianness bug: be16 assigned to be32 field
  [GFS2] Fix bmap to map extents properly
  [DLM] fix iovec length in recvmsg