These transition helpers are stale for years now. Remove them.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Some irq_chips need to know the state of wakeup mode for
setting the trigger type etc. Reflect it in irq_data state.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

irq_chips, which require to mask the chip before changing the trigger
type should set this flag. So the core takes care of it and the
requirement for looking into desc->status in the chip goes away.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
Cc: Linus Walleij <linus.walleij@stericsson.com>
Cc: Lars-Peter Clausen <lars@metafoo.de>

Use wrappers to keep them away from the core code.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

That's the data structure chip functions get provided. Also allow them
to signal the core code that they updated the flags in irq_data.state
by returning IRQ_SET_MASK_OK_NOCOPY. The default is unchanged.

The type bits should be accessed via:

val = irqd_get_trigger_type(irqdata);
and
irqd_set_trigger_type(irqdata, val);

Coders who access them directly will be tracked down and slapped with
stinking trouts.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Keep status in sync until last abuser is gone.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Add a !desc check while at it.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

That's the right data structure to look at for arch code.

Accessor functions are provided.

	 irqd_is_per_cpu(irqdata);
	 irqd_can_balance(irqdata);

Coders who access them directly will be tracked down and slapped with
stinking trouts.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

The saving of this switch is minimal versus the ifdef mess it
creates. Simple enable PER_CPU unconditionally and remove the config
switch.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

chip implementations need to know about it. Keep status in sync until
all users are fixed. 

Accessor function: irqd_is_setaffinity_pending(irqdata)

Coders who access them directly will be tracked down and slapped with
stinking trouts.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

No users outside of core.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

No users outside of core.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Keep status in sync until all users are fixed.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Keep status in sync until all users are fixed.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Keep status in sync until all abusers are fixed.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

No users outside of core.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

No users outside of core.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

We need to maintain the flag for now in both fields status and istate.
Add a CONFIG_GENERIC_HARDIRQS_NO_COMPAT switch to allow testing w/o
the status one. Wrap the access to status IRQ_INPROGRESS in a inline
which can be turned of with CONFIG_GENERIC_HARDIRQS_NO_COMPAT along
with the define.

There is no reason that anything outside of core looks at this. That
needs some modifications, but we'll get there.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

No users outside.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

No users outside of core
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Handle IRQ_DISABLED consistent.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Now that everything uses the wrappers, we can remove the default
functions. None of those functions is performance critical.

That makes the IRQ_MASKED flag tracking fully consistent.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Create irq_disable/enable and use them to keep the flags consistent.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Aside of duplicated code some of the startup/shutdown sites do not
handle the MASKED/DISABLED flags and the depth field at all. Move that
to a helper function and take care of it there.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
Cc: Peter Zijlstra <peterz@infradead.org>
LKML-Reference: <20110202212551.787481468@linutronix.de>

The if (chip->irq_shutdown) check will always evaluate to true, as we
fill in chip->irq_shutdown with default_shutdown in
irq_chip_set_defaults() if the chip does not provide its own function.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
Cc: Peter Zijlstra <peterz@infradead.org>
LKML-Reference: <20110202212551.667607458@linutronix.de>

Thread affinity is already set by setup_affinity().
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

While rumaging through arch code I found that there are a few
workarounds which deal with the fact that the initial affinity setting
from request_irq() copies the mask into irq_data->affinity before the
chip code is called. In the normal path we unconditionally copy the
mask when the chip code returns 0.

Copy after the code is called and add a return code
IRQ_SET_MASK_OK_NOCOPY for the chip functions, which prevents the
copy. That way we see the real mask when the chip function decided to
truncate it further as some arches do. IRQ_SET_MASK_OK is 0, which is
the current behaviour.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

If the affinity had been set by the user, then a later request_irq()
will honour that setting. But online cpus can have changed. So apply
the online mask and for this case as well.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

IRQ_NO_BALANCING is already checked in irq_can_set_affinity() above,
no need to check it again.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

There is lot of #ifdef CONFIG_GENERIC_PENDING_IRQ along with
duplicated code in the irq core. Move the #ifdeffery into one place
and cleanup the code so it's readable. No functional change.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

The irq namespace has become quite convoluted. My bad.  Clean it up
and deprecate the old functions. All new functions follow the scheme:

irq number based:
    irq_set/get/xxx/_xxx(unsigned int irq, ...)

irq_data based:
	 irq_data_set/get/xxx/_xxx(struct irq_data *d, ....)

irq_desc based:
	 irq_desc_get_xxx(struct irq_desc *desc)
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

chips behind a slow bus cannot update the chip under desc->lock, but
we miss the chip_buslock/chip_bus_sync_unlock() calls around the set
type and set wake functions.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

With CONFIG_SHIRQ_DEBUG=y we call a newly installed interrupt handler
in request_threaded_irq().

The original implementation (commit a304e1b8) called the handler
_BEFORE_ it was installed, but that caused problems with handlers
calling disable_irq_nosync(). See commit 377bf1e4.

It's braindead in the first place to call disable_irq_nosync in shared
handlers, but ....

Moving this call after we installed the handler looks innocent, but it
is very subtle broken on SMP.

Interrupt handlers rely on the fact, that the irq core prevents
reentrancy.

Now this debug call violates that promise because we run the handler
w/o the IRQ_INPROGRESS protection - which we cannot apply here because
that would result in a possibly forever masked interrupt line.

A concurrent real hardware interrupt on a different CPU results in
handler reentrancy and can lead to complete wreckage, which was
unfortunately observed in reality and took a fricking long time to
debug.

Leave the code here for now. We want this debug feature, but that's
not easy to fix. We really should get rid of those
disable_irq_nosync() abusers and remove that function completely.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
Cc: Anton Vorontsov <avorontsov@ru.mvista.com>
Cc: David Woodhouse <dwmw2@infradead.org>
Cc: Arjan van de Ven <arjan@infradead.org>
Cc: stable@kernel.org # .28 -> .37

irq_chips that supply .irq_bus_lock/.irq_bus_sync_unlock functions,
expect that the other chip methods will be called inside of calls to
the pair.  If this expectation is not met, things tend to not work.

Make setup_irq() call chip_bus_lock()/chip_bus_sync_unlock() too.

For the vast majority of irq_chips, this will be a NOP as most don't
have these bus lock functions.

[ tglx: No we don't want to call that in __setup_irq(). Way too many
  	error exit pathes. ]
Signed-off-by: NDavid Daney <ddaney@caviumnetworks.com>
LKML-Reference: <1297296265-18680-1-git-send-email-ddaney@caviumnetworks.com>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Xen needs to reenable interrupts which are marked IRQF_NO_SUSPEND in the
resume path. Add a flag to force the reenabling in the resume code.
Tested-and-acked-by: NIan Campbell <Ian.Campbell@eu.citrix.com>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

The new code of commit cd7eab44(genirq: Add IRQ affinity notifiers)
references irq_desc.affinity which fails to compile with
CONFIG_GENERIC_HARDIRQS_NO_DEPRECATED=y.

Use irq_desc.irq_data.affinity instead.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
Cc: Ben Hutchings <bhutchings@solarflare.com>

When initiating I/O on a multiqueue and multi-IRQ device, we may want
to select a queue for which the response will be handled on the same
or a nearby CPU.  This requires a reverse-map of IRQ affinity.  Add a
notification mechanism to support this.

This is based closely on work by Thomas Gleixner <tglx@linutronix.de>.
Signed-off-by: NBen Hutchings <bhutchings@solarflare.com>
Cc: linux-net-drivers@solarflare.com
Cc: Tom Herbert <therbert@google.com>
Cc: David Miller <davem@davemloft.net>
LKML-Reference: <1295470904.11126.84.camel@bwh-desktop>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Function-scope statics are discouraged because they are
easily overlooked and can cause subtle bugs/races due to
their global (non-SMP safe) nature.

Linus noticed that we did this for sched_param - at minimum
make the const.
Suggested-by: NLinus Torvalds <torvalds@linux-foundation.org>
Signed-off-by: NPeter Zijlstra <a.p.zijlstra@chello.nl>
LKML-Reference: Message-ID: <AANLkTinotRxScOHEb0HgFgSpGPkq_6jKTv5CfvnQM=ee@mail.gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>