mtd: fix timeout in M25P80 driver

Extend erase timeout in M25P80 SPI Flash driver.

The M25P80 drivers fails erasing sectors on a M25P128 because the ready
wait timeout is too short. Change the timeout from a simple loop count to a
suitable number of seconds.
Signed-off-by: NPeter Horton <zero@colonel-panic.org>
Tested-by: NMartin Michlmayr <tbm@cyrius.com>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NDavid Woodhouse <David.Woodhouse@intel.com>

drivers/mtd/devices/m25p80.c

@@ -54,7 +54,7 @@
 #define	SR_SRWD			0x80	/* SR write protect */
 
 /* Define max times to check status register before we give up. */
-#define	MAX_READY_WAIT_COUNT	1000000
+#define	MAX_READY_WAIT_JIFFIES	(10 * HZ)	/* eg. M25P128 specs 6s max sector erase */
 #define	CMD_SIZE		4
 
 #ifdef CONFIG_M25PXX_USE_FAST_READ
@@ -139,20 +139,20 @@ static inline int write_enable(struct m25p *flash)
  */
 static int wait_till_ready(struct m25p *flash)
 {
-	int count;
+	unsigned long deadline;
 	int sr;
 
-	/* one chip guarantees max 5 msec wait here after page writes,
-	 * but potentially three seconds (!) after page erase.
-	 */
-	for (count = 0; count < MAX_READY_WAIT_COUNT; count++) {
+	deadline = jiffies + MAX_READY_WAIT_JIFFIES;
+
+	do {
 		if ((sr = read_sr(flash)) < 0)
 			break;
 		else if (!(sr & SR_WIP))
 			return 0;
 
-		/* REVISIT sometimes sleeping would be best */
-	}
+		cond_resched();
+
+	} while (!time_after_eq(jiffies, deadline));
 
 	return 1;
 }