sky2: ethtool speed report bug

On 100mbit versions, the driver always reports gigabit speed
available. The correct modes are already computed, then overwritten.
Signed-off-by: NStephen Hemminger <shemminger@linux-foundation.org>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

drivers/net/sky2.c

@@ -2841,13 +2841,6 @@ static int sky2_get_settings(struct net_device *dev, struct ethtool_cmd *ecmd)
 	ecmd->supported = sky2_supported_modes(hw);
 	ecmd->phy_address = PHY_ADDR_MARV;
 	if (sky2_is_copper(hw)) {
-		ecmd->supported = SUPPORTED_10baseT_Half
-		    | SUPPORTED_10baseT_Full
-		    | SUPPORTED_100baseT_Half
-		    | SUPPORTED_100baseT_Full
-		    | SUPPORTED_1000baseT_Half
-		    | SUPPORTED_1000baseT_Full
-		    | SUPPORTED_Autoneg | SUPPORTED_TP;
 		ecmd->port = PORT_TP;
 		ecmd->speed = sky2->speed;
 	} else {