提交 af3b8881 编写于 作者: R Russ Gorby 提交者: Greg Kroah-Hartman

ifx6x60: SPI protocol driver for Infineon 6x60 modem

Prototype driver for the IFX6x60 series of SPI attached modems by Jim
Stanley and Russ Gorby
Signed-off-by: NRuss Gorby <richardx.r.gorby@intel.com>

[Some reworking and a major cleanup]
Signed-off-by: NAlan Cox <alan@linux.intel.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>
上级 a7bcf21e
......@@ -1632,4 +1632,10 @@ config SERIAL_ALTERA_UART_CONSOLE
help
Enable a Altera UART port to be the system console.
config SERIAL_IFX6X60
tristate "SPI protocol driver for Infineon 6x60 modem (EXPERIMENTAL)"
depends on GPIOLIB && EXPERIMENTAL
help
Support for the IFX6x60 modem devices on Intel MID platforms.
endmenu
......@@ -89,3 +89,4 @@ obj-$(CONFIG_SERIAL_ALTERA_UART) += altera_uart.o
obj-$(CONFIG_SERIAL_MRST_MAX3110) += mrst_max3110.o
obj-$(CONFIG_SERIAL_MFD_HSU) += mfd.o
obj-$(CONFIG_SERIAL_OMAP) += omap-serial.o
obj-$(CONFIG_SERIAL_IFX6X60) += ifx6x60.o
此差异已折叠。
/****************************************************************************
*
* Driver for the IFX spi modem.
*
* Copyright (C) 2009, 2010 Intel Corp
* Jim Stanley <jim.stanley@intel.com>
*
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*
* You should have received a copy of the GNU General Public License
* along with this program; if not, write to the Free Software
* Foundation, Inc., 51 Franklin Street, Fifth Floor, Boston, MA 02110-1301,
* USA
*
*
*
*****************************************************************************/
#ifndef _IFX6X60_H
#define _IFX6X60_H
#define DRVNAME "ifx6x60"
#define TTYNAME "ttyIFX"
/* #define IFX_THROTTLE_CODE */
#define IFX_SPI_MAX_MINORS 1
#define IFX_SPI_TRANSFER_SIZE 2048
#define IFX_SPI_FIFO_SIZE 4096
#define IFX_SPI_HEADER_OVERHEAD 4
#define IFX_RESET_TIMEOUT msecs_to_jiffies(50)
/* device flags bitfield definitions */
#define IFX_SPI_STATE_PRESENT 0
#define IFX_SPI_STATE_IO_IN_PROGRESS 1
#define IFX_SPI_STATE_IO_READY 2
#define IFX_SPI_STATE_TIMER_PENDING 3
/* flow control bitfields */
#define IFX_SPI_DCD 0
#define IFX_SPI_CTS 1
#define IFX_SPI_DSR 2
#define IFX_SPI_RI 3
#define IFX_SPI_DTR 4
#define IFX_SPI_RTS 5
#define IFX_SPI_TX_FC 6
#define IFX_SPI_RX_FC 7
#define IFX_SPI_UPDATE 8
#define IFX_SPI_PAYLOAD_SIZE (IFX_SPI_TRANSFER_SIZE - \
IFX_SPI_HEADER_OVERHEAD)
#define IFX_SPI_IRQ_TYPE DETECT_EDGE_RISING
#define IFX_SPI_GPIO_TARGET 0
#define IFX_SPI_GPIO0 0x105
#define IFX_SPI_STATUS_TIMEOUT (2000*HZ)
/* values for bits in power status byte */
#define IFX_SPI_POWER_DATA_PENDING 1
#define IFX_SPI_POWER_SRDY 2
struct ifx_spi_device {
/* Our SPI device */
struct spi_device *spi_dev;
/* Port specific data */
struct kfifo tx_fifo;
spinlock_t fifo_lock;
unsigned long signal_state;
/* TTY Layer logic */
struct tty_port tty_port;
struct device *tty_dev;
int minor;
/* Low level I/O work */
struct tasklet_struct io_work_tasklet;
unsigned long flags;
dma_addr_t rx_dma;
dma_addr_t tx_dma;
int is_6160; /* Modem type */
spinlock_t write_lock;
int write_pending;
spinlock_t power_lock;
unsigned char power_status;
unsigned char *rx_buffer;
unsigned char *tx_buffer;
dma_addr_t rx_bus;
dma_addr_t tx_bus;
unsigned char spi_more;
unsigned char spi_slave_cts;
struct timer_list spi_timer;
struct spi_message spi_msg;
struct spi_transfer spi_xfer;
struct {
/* gpio lines */
unsigned short srdy; /* slave-ready gpio */
unsigned short mrdy; /* master-ready gpio */
unsigned short reset; /* modem-reset gpio */
unsigned short po; /* modem-on gpio */
unsigned short reset_out; /* modem-in-reset gpio */
/* state/stats */
int unack_srdy_int_nb;
} gpio;
/* modem reset */
unsigned long mdm_reset_state;
#define MR_START 0
#define MR_INPROGRESS 1
#define MR_COMPLETE 2
wait_queue_head_t mdm_reset_wait;
};
#endif /* _IFX6X60_H */
#ifndef LINUX_IFX_MODEM_H
#define LINUX_IFX_MODEM_H
struct ifx_modem_platform_data {
unsigned short rst_out; /* modem reset out */
unsigned short pwr_on; /* power on */
unsigned short rst_pmu; /* reset modem */
unsigned short tx_pwr; /* modem power threshold */
unsigned short srdy; /* SRDY */
unsigned short mrdy; /* MRDY */
unsigned short is_6160; /* Modem type */
};
#endif
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册