W1: w1_io.c reset comments and msleep

w1_reset_bus, added some comments about the timing and switched to msleep
for the later delay.  I don't have the hardware to test the sleep after
reset change.  The one wire doesn't have a timing requirement between
commands so it is fine.  I do have the USB hardware and it would be in big
trouble with 10ms interrupt transfers to find that the reset completed.
Signed-off-by: NDavid Fries <david@fries.net>
Signed-off-by: NEvgeniy Polyakov <johnpol@2ka.mipt.ru>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

drivers/w1/w1_io.c

@@ -293,12 +293,24 @@ int w1_reset_bus(struct w1_master *dev)
 		result = dev->bus_master->reset_bus(dev->bus_master->data) & 0x1;
 	else {
 		dev->bus_master->write_bit(dev->bus_master->data, 0);
+		/* minimum 480, max ? us
+		 * be nice and sleep, except 18b20 spec lists 960us maximum,
+		 * so until we can sleep with microsecond accuracy, spin.
+		 * Feel free to come up with some other way to give up the
+		 * cpu for such a short amount of time AND get it back in
+		 * the maximum amount of time.
+		 */
 		w1_delay(480);
 		dev->bus_master->write_bit(dev->bus_master->data, 1);
 		w1_delay(70);
 
 		result = dev->bus_master->read_bit(dev->bus_master->data) & 0x1;
-		w1_delay(410);
+		/* minmum 70 (above) + 410 = 480 us
+		 * There aren't any timing requirements between a reset and
+		 * the following transactions.  Sleeping is safe here.
+		 */
+		/* w1_delay(410); min required time */
+		msleep(1);
 	}
 
 	return result;