提交 6618e478 编写于 作者: D Doug Anderson 提交者: Heiko Stuebner

ARM: dts: rockchip: bump sd card pin drive strength up on rk3288-evb

It seems that ever since (536f6b91 mmc: dw_mmc: Reset DMA before
enabling IDMAC) landed upstream that SD cards have been very unhappy
on rk3288-evb.  They were a little unhappy before that change, but
after that change they're REALLY unhappy.

It turns out that the above fix happens to fix a corruption when
reading card information during probe time.  Without the fix we didn't
detect that high speed SD cards could actually support high speed.
With the fix we suddenly detect that they're high speed and we try to
use them at 50MHz.  That doesn't work so well on EVB with the default
drive strength (maybe because there are two physical SD card slots
hooked up to the same pin?).

Fix the problem by bumping up the drive strength of the sdmmc lines.
Signed-off-by: NDoug Anderson <dianders@chromium.org>
Fixes: 536f6b91 ("mmc: dw_mmc: Reset DMA before enabling IDMAC")
Signed-off-by: NHeiko Stuebner <heiko@sntech.de>
上级 97bf6af1
......@@ -155,6 +155,15 @@ &tsadc {
};
&pinctrl {
pcfg_pull_none_drv_8ma: pcfg-pull-none-drv-8ma {
drive-strength = <8>;
};
pcfg_pull_up_drv_8ma: pcfg-pull-up-drv-8ma {
bias-pull-up;
drive-strength = <8>;
};
backlight {
bl_en: bl-en {
rockchip,pins = <7 2 RK_FUNC_GPIO &pcfg_pull_none>;
......@@ -173,6 +182,27 @@ pmic_int: pmic-int {
};
};
sdmmc {
/*
* Default drive strength isn't enough to achieve even
* high-speed mode on EVB board so bump up to 8ma.
*/
sdmmc_bus4: sdmmc-bus4 {
rockchip,pins = <6 16 RK_FUNC_1 &pcfg_pull_up_drv_8ma>,
<6 17 RK_FUNC_1 &pcfg_pull_up_drv_8ma>,
<6 18 RK_FUNC_1 &pcfg_pull_up_drv_8ma>,
<6 19 RK_FUNC_1 &pcfg_pull_up_drv_8ma>;
};
sdmmc_clk: sdmmc-clk {
rockchip,pins = <6 20 RK_FUNC_1 &pcfg_pull_none_drv_8ma>;
};
sdmmc_cmd: sdmmc-cmd {
rockchip,pins = <6 21 RK_FUNC_1 &pcfg_pull_up_drv_8ma>;
};
};
usb {
host_vbus_drv: host-vbus-drv {
rockchip,pins = <0 14 RK_FUNC_GPIO &pcfg_pull_none>;
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册