e1000: restore netif_poll_enable call but make sure IRQs are off

This restores the previously removed netif_poll_enable call in e1000_open.
It's needed on all but the first call to e1000_open for a NIC as
e1000_close always calls netif_poll_disable.

netif_poll_enable can only be called safely if no polls have been
scheduled.  This should be the case as long as we don't enter our IRQ
handler.

In order to guarantee this we explicitly disable IRQs as early as possible
when we're probing the NIC.
Signed-off-by: NHerbert Xu <herbert@gondor.apana.org.au>
Cc: "Kok, Auke" <auke-jan.h.kok@intel.com>
Cc: Jeff Garzik <jeff@garzik.org>
Cc: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

drivers/net/e1000/e1000_main.c

@@ -1325,7 +1325,10 @@ e1000_sw_init(struct e1000_adapter *adapter)
 	spin_lock_init(&adapter->tx_queue_lock);
 #endif
 
-	atomic_set(&adapter->irq_sem, 1);
+	/* Explicitly disable IRQ since the NIC can be in any state. */
+	atomic_set(&adapter->irq_sem, 0);
+	e1000_irq_disable(adapter);
+
 	spin_lock_init(&adapter->stats_lock);
 
 	set_bit(__E1000_DOWN, &adapter->flags);
@@ -1431,6 +1434,10 @@ e1000_open(struct net_device *netdev)
 	/* From here on the code is the same as e1000_up() */
 	clear_bit(__E1000_DOWN, &adapter->flags);
 
+#ifdef CONFIG_E1000_NAPI
+	netif_poll_enable(netdev);
+#endif
+
 	e1000_irq_enable(adapter);
 
 	/* fire a link status change interrupt to start the watchdog */