提交 409d568d 编写于 作者: A Arjan van de Ven 提交者: Dmitry Torokhov

Staging: mrst-touchscreen - fix channel allocation

The touch screen driver tries to find a range of free channels (which
are an array of bytes), by scanning for the "end of used channel" marker.
However it tries to be WAAAAY too smart and does 32 bit logic on 8 bit
quantities, and in the process completely gets it wrong
(repeatedly read the same register instead of incrementing in the loop,
assuming that if any of the 4 bytes in the 32 byte quantity is free,
all four are free, returning the channel number divided by 4 rather than
the actual first free channel number)

On the setting side, the same mistakes are made by and large; changed
this to just use the byte SCU write functions....

With these fixes we go from a completely non detected touchscreen to
something that appears to completely get detected.
(after also fixing the ordering issue that Jacobs patch should solve)
Signed-off-by: NArjan van de Ven <arjan@linux.intel.com>
Signed-off-by: NAlan Cox <alan@linux.intel.com>
Signed-off-by: NDmitry Torokhov <dtor@mail.ru>
上级 36466a1b
......@@ -498,8 +498,8 @@ static int __devinit mrstouch_read_pmic_id(uint *vendor, uint *rev)
*/
static int __devinit mrstouch_chan_parse(struct mrstouch_dev *tsdev)
{
int err, i, j, found;
u32 r32;
int err, i, found;
u8 r8;
found = -1;
......@@ -507,15 +507,13 @@ static int __devinit mrstouch_chan_parse(struct mrstouch_dev *tsdev)
if (found >= 0)
break;
err = intel_scu_ipc_ioread32(PMICADDR0, &r32);
err = intel_scu_ipc_ioread8(PMICADDR0 + i, &r8);
if (err)
return err;
for (j = 0; j < 32; j+= 8) {
if (((r32 >> j) & 0xFF) == END_OF_CHANNEL) {
found = i;
break;
}
if (r8 == END_OF_CHANNEL) {
found = i;
break;
}
}
if (found < 0)
......@@ -537,20 +535,17 @@ static int __devinit mrstouch_chan_parse(struct mrstouch_dev *tsdev)
*/
static int __devinit mrstouch_ts_chan_set(uint offset)
{
int count;
u16 chan;
u16 reg[5];
u8 data[5];
int ret, count;
chan = PMICADDR0 + offset;
for (count = 0; count <= 3; count++) {
reg[count] = chan++;
data[count] = MRST_TS_CHAN10 + count;
ret = intel_scu_ipc_iowrite8(chan++, MRST_TS_CHAN10 + count);
if (ret)
return ret;
}
reg[count] = chan;
data[count] = END_OF_CHANNEL;
return intel_scu_ipc_writev(reg, data, 5);
return intel_scu_ipc_iowrite8(chan++, END_OF_CHANNEL);
}
/* Initialize ADC */
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册