libata: checkpatch fixes

Signed-off-by: NJeff Garzik <jgarzik@redhat.com>

drivers/ata/libata-core.c

@@ -4374,11 +4374,11 @@ static unsigned int ata_dev_set_xfermode(struct ata_device *dev)
 	tf.flags |= ATA_TFLAG_ISADDR | ATA_TFLAG_DEVICE | ATA_TFLAG_POLLING;
 	tf.protocol = ATA_PROT_NODATA;
 	/* If we are using IORDY we must send the mode setting command */
- 	if (ata_pio_need_iordy(dev))
- 		tf.nsect = dev->xfer_mode;
+	if (ata_pio_need_iordy(dev))
+		tf.nsect = dev->xfer_mode;
 	/* If the device has IORDY and the controller does not - turn it off */
  	else if (ata_id_has_iordy(dev->id))
- 		tf.nsect = 0x01;
+		tf.nsect = 0x01;
 	else /* In the ancient relic department - skip all of this */
 		return 0;
 

drivers/ata/pata_ali.c

@@ -64,7 +64,7 @@ static int ali_cable_override(struct pci_dev *pdev)
 	if (pdev->subsystem_vendor == 0x10CF && pdev->subsystem_device == 0x10AF)
 	   	return 1;
 	/* Mitac 8317 (Winbook-A) and relatives */
-	if (pdev->subsystem_vendor == 0x1071  && pdev->subsystem_device == 0x8317)
+	if (pdev->subsystem_vendor == 0x1071 && pdev->subsystem_device == 0x8317)
 		return 1;
 	/* Systems by DMI */
 	if (dmi_check_system(cable_dmi_table))

drivers/ata/pata_ninja32.c

@@ -61,7 +61,8 @@ static void ninja32_set_piomode(struct ata_port *ap, struct ata_device *adev)
 	static u16 pio_timing[5] = {
 		0xd6, 0x85, 0x44, 0x33, 0x13
 	};
-	iowrite8(pio_timing[adev->pio_mode - XFER_PIO_0], ap->ioaddr.bmdma_addr + 0x1f);
+	iowrite8(pio_timing[adev->pio_mode - XFER_PIO_0],
+		 ap->ioaddr.bmdma_addr + 0x1f);
 	ap->private_data = adev;
 }
 
@@ -176,12 +177,13 @@ static int ninja32_init_one(struct pci_dev *dev, const struct pci_device_id *id)
 	iowrite8(0xB3, base + 0x02);	/* Burst, ?? setup */
 	iowrite8(0x00, base + 0x04);	/* WAIT0 ? */
 	/* FIXME: Should we disable them at remove ? */
-	return ata_host_activate(host, dev->irq, ata_interrupt, IRQF_SHARED, &ninja32_sht);
+	return ata_host_activate(host, dev->irq, ata_interrupt,
+				 IRQF_SHARED, &ninja32_sht);
 }
 
 static const struct pci_device_id ninja32[] = {
-	{ 0x1145, 0xf021, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0},
-	{ 0x1145, 0xf024, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0},
+	{ 0x1145, 0xf021, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0 },
+	{ 0x1145, 0xf024, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0 },
 	{ },
 };