提交 005076a1 编写于 作者: S Shane McDonald 提交者: Ralf Baechle

MIPS: MSP71xx: Resolve use of non-existent GPIO routines in msp71xx reset

There have been a number of compile problems with the msp71xx configuration
ever since it was included in the linux-mips.org repository.  This patch
resolves compilation problems with attempting to reset the board using
non-existent GPIO routines.

This patch has been compile-tested against the current HEAD.
Signed-off-by: NShane McDonald <mcdonald.shane@gmail.com>
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>
上级 01caec83
......@@ -21,7 +21,6 @@
#if defined(CONFIG_PMC_MSP7120_GW)
#include <msp_regops.h>
#include <msp_gpio.h>
#define MSP_BOARD_RESET_GPIO 9
#endif
......@@ -88,11 +87,8 @@ void msp7120_reset(void)
* as GPIO char driver may not be enabled and it would look up
* data inRAM!
*/
set_value_reg32(GPIO_CFG3_REG,
basic_mode_mask(MSP_BOARD_RESET_GPIO),
basic_mode(MSP_GPIO_OUTPUT, MSP_BOARD_RESET_GPIO));
set_reg32(GPIO_DATA3_REG,
basic_data_mask(MSP_BOARD_RESET_GPIO));
set_value_reg32(GPIO_CFG3_REG, 0xf000, 0x8000);
set_reg32(GPIO_DATA3_REG, 8);
/*
* In case GPIO9 doesn't reset the board (jumper configurable!)
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册