提交 97c2803c 编写于 作者: J John Blackwood 提交者: Linus Torvalds

[PATCH] x86_64: Plug GS leak in arch_prctl()

In linux-2.6.16, we have noticed a problem where the gs base value
returned from an arch_prtcl(ARCH_GET_GS, ...) call will be incorrect if:

   - the current/calling task has NOT set its own gs base yet to a
     non-zero value,

   - some other task that ran on the same processor previously set their
     own gs base to a non-zero value.

In this situation, the ARCH_GET_GS code will read and return the
MSR_KERNEL_GS_BASE msr register.

However, since the __switch_to() code does NOT load/zero the
MSR_KERNEL_GS_BASE register when the task that is switched IN has a zero
next->gs value, the caller of arch_prctl(ARCH_GET_GS, ...) will get back
the value of some previous tasks's gs base value instead of 0.

    Change the arch_prctl() ARCH_GET_GS code to only read and return
    the MSR_KERNEL_GS_BASE msr register if the 'gs' register of the calling
    task is non-zero.

    Side note: Since in addition to using arch_prctl(ARCH_SET_GS, ...),
    a task can also setup a gs base value by using modify_ldt() and write
    an index value into 'gs' from user space, the patch below reads
    'gs' instead of using thread.gs, since in the modify_ldt() case,
    the thread.gs value will be 0, and incorrect value would be returned
    (the task->thread.gs value).

    When the user has not set its own gs base value and the 'gs'
    register is zero, then the MSR_KERNEL_GS_BASE register will not be
    read and a value of zero will be returned by reading and returning
    'task->thread.gs'.

    The first patch shown below is an attempt at implementing this
    approach.
Signed-off-by: NAndi Kleen <ak@suse.de>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
上级 e48c4729
......@@ -781,10 +781,16 @@ long do_arch_prctl(struct task_struct *task, int code, unsigned long addr)
}
case ARCH_GET_GS: {
unsigned long base;
unsigned gsindex;
if (task->thread.gsindex == GS_TLS_SEL)
base = read_32bit_tls(task, GS_TLS);
else if (doit)
rdmsrl(MSR_KERNEL_GS_BASE, base);
else if (doit) {
asm("movl %%gs,%0" : "=r" (gsindex));
if (gsindex)
rdmsrl(MSR_KERNEL_GS_BASE, base);
else
base = task->thread.gs;
}
else
base = task->thread.gs;
ret = put_user(base, (unsigned long __user *)addr);
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册