提交 72b78cf7 编写于 作者: A Alexandre Pereira da Silva 提交者: Roland Stigge

ARM: LPC32xx: Remove spi chip definitions

Leave chipselect and spi devices binding to the devicetree
Signed-off-by: NAlexandre Pereira da Silva <aletes.xgr@gmail.com>
Signed-off-by: NRoland Stigge <stigge@antcom.de>
上级 c05a8b14
......@@ -162,24 +162,6 @@ static struct clcd_board lpc32xx_clcd_data = {
/*
* AMBA SSP (SPI)
*/
static void phy3250_spi_cs_set(u32 control)
{
gpio_set_value(SPI0_CS_GPIO, (int) control);
}
static struct pl022_config_chip spi0_chip_info = {
.com_mode = INTERRUPT_TRANSFER,
.iface = SSP_INTERFACE_MOTOROLA_SPI,
.hierarchy = SSP_MASTER,
.slave_tx_disable = 0,
.rx_lev_trig = SSP_RX_4_OR_MORE_ELEM,
.tx_lev_trig = SSP_TX_4_OR_MORE_EMPTY_LOC,
.ctrl_len = SSP_BITS_8,
.wait_state = SSP_MWIRE_WAIT_ZERO,
.duplex = SSP_MICROWIRE_CHANNEL_FULL_DUPLEX,
.cs_control = phy3250_spi_cs_set,
};
static struct pl022_ssp_controller lpc32xx_ssp0_data = {
.bus_id = 0,
.num_chipselect = 1,
......@@ -192,44 +174,6 @@ static struct pl022_ssp_controller lpc32xx_ssp1_data = {
.enable_dma = 0,
};
/* AT25 driver registration */
static int __init phy3250_spi_board_register(void)
{
#if defined(CONFIG_SPI_SPIDEV) || defined(CONFIG_SPI_SPIDEV_MODULE)
static struct spi_board_info info[] = {
{
.modalias = "spidev",
.max_speed_hz = 5000000,
.bus_num = 0,
.chip_select = 0,
.controller_data = &spi0_chip_info,
},
};
#else
static struct spi_eeprom eeprom = {
.name = "at25256a",
.byte_len = 0x8000,
.page_size = 64,
.flags = EE_ADDR2,
};
static struct spi_board_info info[] = {
{
.modalias = "at25",
.max_speed_hz = 5000000,
.bus_num = 0,
.chip_select = 0,
.mode = SPI_MODE_0,
.platform_data = &eeprom,
.controller_data = &spi0_chip_info,
},
};
#endif
return spi_register_board_info(info, ARRAY_SIZE(info));
}
arch_initcall(phy3250_spi_board_register);
static struct pl08x_channel_data pl08x_slave_channels[] = {
{
.bus_id = "nand-slc",
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册