提交 3d5b6fb4 编写于 作者: R Roland Dreier 提交者: Len Brown

ACPI: Kill overly verbose "power state" log messages

I was recently lucky enough to get a 64-CPU system, so my kernel log
ends up with 64 lines like:

    ACPI: CPU0 (power states: C1[C1] C2[C3])

This is pretty useless clutter because this info is already available
after boot from both /sys/devices/system/cpu/cpu*/cpuidle/state?/ as
well as /proc/acpi/processor/CPU*/power.

So just delete the code that prints the C-states in processor_idle.c.
Signed-off-by: NRoland Dreier <rolandd@cisco.com>
Signed-off-by: NLen Brown <len.brown@intel.com>
上级 3e2ada58
......@@ -1214,13 +1214,6 @@ int __cpuinit acpi_processor_power_init(struct acpi_processor *pr,
acpi_processor_setup_cpuidle(pr);
if (cpuidle_register_device(&pr->power.dev))
return -EIO;
printk(KERN_INFO PREFIX "CPU%d (power states:", pr->id);
for (i = 1; i <= pr->power.count; i++)
if (pr->power.states[i].valid)
printk(" C%d[C%d]", i,
pr->power.states[i].type);
printk(")\n");
}
#ifdef CONFIG_ACPI_PROCFS
/* 'power' [R] */
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册