x86: I/O APIC: Add a 64-bit variation of replace_pin_at_irq()

When an interrupt is rerouted to a different I/O APIC pin the relevant
entry of the irq_2_pin list should get updated accordingly so that
operations are performed on the correct redirection entry.

This is already done by the 32-bit variation of the code and here is a
complementing 64-bit implementation.  Should make someone's decision less
tough when merging the two. ;)
Signed-off-by: NMaciej W. Rozycki <macro@linux-mips.org>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

arch/x86/kernel/io_apic_64.c

@@ -373,6 +373,26 @@ static void add_pin_to_irq(unsigned int irq, int apic, int pin)
 	entry->pin = pin;
 }
 
+/*
+ * Reroute an IRQ to a different pin.
+ */
+static void __init replace_pin_at_irq(unsigned int irq,
+				      int oldapic, int oldpin,
+				      int newapic, int newpin)
+{
+	struct irq_pin_list *entry = irq_2_pin + irq;
+
+	while (1) {
+		if (entry->apic == oldapic && entry->pin == oldpin) {
+			entry->apic = newapic;
+			entry->pin = newpin;
+		}
+		if (!entry->next)
+			break;
+		entry = irq_2_pin + entry->next;
+	}
+}
+
 
 #define DO_ACTION(name,R,ACTION, FINAL)					\
 									\
@@ -1735,7 +1755,7 @@ static inline void __init check_timer(void)
 		/*
 		 * legacy devices should be connected to IO APIC #0
 		 */
-		/* replace_pin_at_irq(0, apic1, pin1, apic2, pin2); */
+		replace_pin_at_irq(0, apic1, pin1, apic2, pin2);
 		setup_timer_IRQ0_pin(apic2, pin2, cfg->vector);
 		unmask_IO_APIC_irq(0);
 		enable_8259A_irq(0);