Signed-off-by: NWolfgang Denk <wd@denx.de>
[trini: Fixup common/cmd_io.c]
Signed-off-by: NTom Rini <trini@ti.com>

Signed-off-by: NJean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>

            - now the Flash ST M29W040B is supported (not tested)
            - fix the "led" command
            - fix compile error, if BUILD_DIR is used
Signed-off-by: NHeiko Schocher <hs@denx.de>

                - Show on the Status LEDs, some States of the board.
                - Get the MAC addresses from the EEProm
                - use PREBOOT
                - use the CF on the board.
                - check the U-Boot image in the Flash with a SHA1
                  checksum.
                - use dynamic TLB entries generation for the SDRAM
Signed-off-by: NHeiko Schocher <hs@denx.de>

Patch by Stefan Roese, 02 Jun 2006

- Add IXP4xx NPE ethernet MAC support
- Add support for Intel IXDPG425 board
- Add support for Prodrive PDNB3 board
- Add IRQ support
Patch by Stefan Roese, 23 May 2006

[This patch does not include cpu/ixp/npe/IxNpeMicrocode.c which still
 sufferes from licensing issues. Blame Intel.]

  - remove trailing white space, trailing empty lines, C++ comments, etc.
  - split cmd_boot.c (separate cmd_bdinfo.c and cmd_load.c)

* Patches by Kenneth Johansson, 25 Jun 2003:
  - major rework of command structure
    (work done mostly by Michal Cendrowski and Joakim Kristiansen)