1. 04 7月, 2011 24 次提交
  2. 02 7月, 2011 7 次提交
  3. 01 7月, 2011 1 次提交
  4. 30 6月, 2011 1 次提交
  5. 29 6月, 2011 1 次提交
    • M
      cfi_flash: reverse geometry for newer STM parts · 4c2105cb
      Mike Frysinger 提交于
      For newer STM parts where CFI >= 1.1, there is a byte in the extended
      structure that declares the flash layout type (just like the AMD parts),
      so key off of that to find out when we need to reverse the geometry.
      
      This can be seen with M29W640 parts where U-Boot does:
      Bank # 1: CFI conformant FLASH (16 x 16)  Size: 8 MB in 135 Sectors
        AMD Standard command set, Manufacturer ID: 0x20, Device ID: 0x22ED
        Erase timeout: 8192 ms, write timeout: 1 ms
        Buffer write timeout: 1 ms, buffer size: 16 bytes
      
        Sector Start Addresses:
        20000000   RO   20002000   RO   20004000   RO   20006000   RO   20008000   RO
        2000A000   RO   2000C000   RO   2000E000   RO   20010000   RO   20020000   RO
        ...
      
      But Linux does:
      physmap platform flash device: 00800000 at 20000000
      physmap-flash.0: Found 1 x16 devices at 0x0 in 16-bit bank.
                       Manufacturer ID 0x000020 Chip ID 0x0022ed
      physmap-flash.0: Swapping erase regions for top-boot CFI table.
      Signed-off-by: NMike Frysinger <vapier@gentoo.org>
      Signed-off-by: NStefan Roese <sr@denx.de>
      4c2105cb
  6. 28 6月, 2011 2 次提交
  7. 25 6月, 2011 3 次提交
  8. 23 6月, 2011 1 次提交
    • W
      Merge branch 'master' of git://git.denx.de/u-boot-arm · 9623c158
      Wolfgang Denk 提交于
      * 'master' of git://git.denx.de/u-boot-arm:
        run arm_pci_init after relocation
        IXP42x PCI rewrite
        update/fix PDNB3 board
        update/fix IXDP425 / IXDPG425 boards
        add dvlhost (dLAN 200 AV Wireless G) board
        IXP NPE: add support for fixed-speed MII ports
        update/fix AcTux4 board
        update/fix AcTux3 board
        update/fix AcTux2 board
        update/fix AcTux1 board
        use -ffunction-sections / --gc-sections on IXP42x
        support CONFIG_SYS_LDSCRIPT on ARM
        fix "depend" target in npe directory
        Fix IXP code to work after relocation was added
        trigger hardware watchdog in IXP42x serial driver
        add support for IXP42x Rev. B1 and newer
        add XScale sub architecture (IXP/PXA) to maintainer list
      
      Conflicts:
      	arch/arm/lib/board.c
      Signed-off-by: NWolfgang Denk <wd@denx.de>
      9623c158