So that we can set the NAND loader's relocate stack pointer
to the value other than the relocate address + 0x10000.
Signed-off-by: NMingkai Hu <Mingkai.hu@freescale.com>
Acked-by: NKim Phillips <kim.phillips@freescale.com>
Acked-by: NScott Wood <scottwood@freescale.com>
Signed-off-by: NKumar Gala <galak@kernel.crashing.org>

This patch will create a new board, SIMPC8313, from Sheldon Instruments.  This
board boots from NAND devices and is configureable for either large or small
page devices.  The board supports non-soldered DDR2, one ethernet port, a
Marvell 88E1118 PHY, and PCI host support.  The board also has a FPGA connected
to the eLBC providing glue logic to a TMS320C67xx DSP.
Signed-off-by: NRon Madrid <ron_madrid@sbcglobal.net>
Signed-off-by: NKim Phillips <kim.phillips@freescale.com>

Signed-off-by: NJean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>

Note that with older board revisions, NAND boot may only work after a
power-on reset, and not after a warm reset.  I don't have a newer board
to test on; if you have a board with a 33MHz crystal, please let me know
if it works after a warm reset.
Signed-off-by: NScott Wood <scottwood@freescale.com>

Update the MPC8349E-mITX, MPC8313E-RDB, and MPC837XE-RDB board files to upload
the Vitesse VSC7385 firmware.  Changed CONFIG_VSC7385 to CONFIG_VSC7385_ENET.
Cleaned up the board header files to make selecting the VSC7385 easier to
control.
Signed-off-by: NTimur Tabi <timur@freescale.com>
Signed-off-by: NKim Phillips <kim.phillips@freescale.com>

need to rm it from pci code, too!
Signed-off-by: NKim Phillips <kim.phillips@freescale.com>

includes build fixes.
Signed-off-by: NKim Phillips <kim.phillips@freescale.com>

this adds libfdt support code for the freescale
mpc8313erdb, mpc832xemds, mpc8349emds, mpc8349itx,
and gp boards.

Boards remain compatible with OF_FLAT_TREE.
Signed-off-by: NKim Phillips <kim.phillips@freescale.com>

Signed-off-by: NScott Wood <scottwood@freescale.com>