Protocols are constants. Fix arrays with const prefix.
Signed-off-by: NYork Sun <yorksun@freescale.com>
Signed-off-by: NAndy Fleming <afleming@freescale.com>

The PIR parsing algorithm we used is not only for E6500. It applies to all
SoCs with chassis 2.
Signed-off-by: NYork Sun <yorksun@freescale.com>
Signed-off-by: NAndy Fleming <afleming@freescale.com>

Use decimal and hexadecimal for protocol numbers. It helps to match with
SoC user manual.
Signed-off-by: NYork Sun <yorksun@freescale.com>
Signed-off-by: NAndy Fleming <afleming@freescale.com>

T4240 internal UTMI phy is different comparing to previous UTMI PHY
in P3041.
This patch adds USB 2.0 UTMI Dual PHY new memory map and enable it for
T4240.
The phy timing is very sensitive and moving the phy enable code to
cpu_init.c will not work.
Signed-off-by: NRoy Zang <tie-fei.zang@freescale.com>
Signed-off-by: NAndy Fleming <afleming@freescale.com>

T4240 has voltage ID fuse. Read the fuse and configure the voltage
correctly. Core voltage has higher tolerance on over side than below.
Signed-off-by: NYork Sun <yorksun@freescale.com>
Signed-off-by: NAndy Fleming <afleming@freescale.com>

Missing nodes of crypto, pme, etc in device tree is not a fatal error.
Setting up the qman portal should skip the missing node and continue
to finish the rest.
Signed-off-by: NYork Sun <yorksun@freescale.com>
Signed-off-by: NAndy Fleming <afleming@freescale.com>

Should check if interleaving is enabled before using interleaving mode.
Signed-off-by: NYork Sun <yorksun@freescale.com>
Signed-off-by: NAndy Fleming <afleming@freescale.com>

Update the timing table to support more rank density, based on the theory
that similar density DIMMs have similar clock adjust and write level start
timing. Update the timing for 1600 and 1866 MT/s. Tested with Micron
MT18JSF1G72AZ-1G9E1 DIMMs, iDIMM M3CN-4GMJ3C0C-M92.
Signed-off-by: NYork Sun <yorksun@freescale.com>
Signed-off-by: NAndy Fleming <afleming@freescale.com>

Lane H on SerDes4 should be SATA2 instead of SATA1
Signed-off-by: NJerry Huang <Chang-Ming.Huang@freescale.com>
Signed-off-by: NRoy Zang <tie-fei.zang@freescale.com>
Signed-off-by: NAndy Fleming <afleming@freescale.com>

1. fix 10G mac offset by plus 8;
2. add second 10G port info for FM1 & FM2 when init ethernet info;
3. fix 10G lanes name to match lane protocol table;
Signed-off-by: NShaohui Xie <Shaohui.Xie@freescale.com>
Signed-off-by: NRoy Zang <tie-fei.zang@freescale.com>
Signed-off-by: NAndy Fleming <afleming@freescale.com>

Signed-off-by: NShaohui Xie <Shaohui.Xie@freescale.com>
Signed-off-by: NRoy Zang <tie-fei.zang@freescale.com>
Signed-off-by: NAndy Fleming <afleming@freescale.com>

Reverse the bit sequence to set and display serdes clock frequency
correctly. The correct bit maps in BRDCFG2 are
0	1	2	3	4	5	6	7
S1RATE[1:0]	S2RATE[1:0] 	S3RATE[1:0] 	S4RATE[1:0]
Signed-off-by: NRoy Zang <tie-fei.zang@freescale.com>
Signed-off-by: NAndy Fleming <afleming@freescale.com>

The L1 D-cache on e6500 is write-through. This means that it's not
considered a good idea to have the L1 up and running if the L2 is
disabled. We don't actually *use* the L1 until after the L2 is
brought up on e6500, so go ahead and move the L1 enablement after
that code is done.
Signed-off-by: NAndy Fleming <afleming@freescale.com>

T4240QDS uses a SST instead of SPANSION SPI flash.
Signed-off-by: NShaohui Xie <Shaohui.Xie@freescale.com>
Signed-off-by: NAndy Fleming <afleming@freescale.com>

Fix ccsr_gur for corenet platform. Remove non-exist registers. Add fuse
status register.
Signed-off-by: NYork Sun <yorksun@freescale.com>
Signed-off-by: NAndy Fleming <afleming@freescale.com>

Makes it a bit easier to see if we've properly set them. While
we're in there, modify the accesses to HDBCR0 and HDBCR1  to actually
use those definitions.
Signed-off-by: NAndy Fleming <afleming@freescale.com>

The bit positions for FMAN1 freq in RCW is different for B4860.
Also addded a case when FMAN1 frewuency is equal to systembus.
Signed-off-by: NSandeep Singh <Sandeep@freescale.com>
Signed-off-by: NPoonam Aggrwal <poonam.aggrwal@freescale.com>
Signed-off-by: NAndy Fleming <afleming@freescale.com>

Add selected coreboot timestamps into bootstage to get a unified view of
the boot timings.
Signed-off-by: NSimon Glass <sjg@chromium.org>

Coreboot provides a lot of useful timing information. Provide a facility
to add this to bootstage on start-up.
Signed-off-by: NSimon Glass <sjg@chromium.org>

We don't use zlib and gzip but do use lzo, so enable this.
Signed-off-by: NSimon Glass <sjg@chromium.org>

This local variable is not used unless CONFIG_GZIP is defined. Fix it.
Signed-off-by: NSimon Glass <sjg@chromium.org>

Add a function which allows a (file, function, line number) to be marked
in bootstage.
Signed-off-by: NSimon Glass <sjg@chromium.org>
Reviewed-by: NChe-Liang Chiou <clchiou@chromium.org>

This is a convenient way of finding out where boottime is going. Enable
it for coreboot.
Signed-off-by: NSimon Glass <sjg@chromium.org>

In a previous CL we added the bootstage_relocate(), which should be
called after malloc is initted.  Now we call it on generic board.
Signed-off-by: NDoug Anderson <dianders@chromium.org>
Signed-off-by: NSimon Glass <sjg@chromium.org>
Reviewed-by: NSimon Glass <sjg@chromium.org>

Any pointers to name strings that were passed to bootstage_mark_name()
pre-relocation should be copied post-relocation so that they don't get
trashed as the original location of U-Boot is re-used for other
purposes.

This change introduces a new API call that should be called from
board_init_r() after malloc has been initted on any board that uses
bootstage.
Signed-off-by: NDoug Anderson <dianders@chromium.org>
Signed-off-by: NSimon Glass <sjg@chromium.org>
Reviewed-by: NSimon Glass <sjg@chromium.org>

Some functions don't have a stub for when CONFIG_BOOTSTAGE is not defined.
Add one to avoid #ifdefs in the code when this is used in U-Boot.
Signed-off-by: NSimon Glass <sjg@chromium.org>
Reviewed-by: NChe-Liang Chiou <clchiou@chromium.org>
Reviewed-by: NTom Wai-Hong Tam <waihong@chromium.org>

While we don't want PCAT timers for timing, we want timer 2 so that we can
still make a beep. Re-purpose the PCAT driver for this, and enable it in
coreboot.
Signed-off-by: NSimon Glass <sjg@chromium.org>

This is no longer used since we prefer the more accurate TSC timer, so
remove the dead code.
Signed-off-by: NSimon Glass <sjg@chromium.org>
Acked-by: NGraeme Russ <graeme.russ@gmail.com>

Tidy up some old broken and unneeded implementations. These are not used
by coreboot or anything else now.
Signed-off-by: NSimon Glass <sjg@chromium.org>
Reviewed-by: NGabe Black <gabeblack@chromium.org>
Reviewed-by: NMichael Spang <spang@chromium.org>
Reviewed-by: NVadim Bendebury <vbendeb@chromium.org>
Acked-by: NGraeme Russ <graeme.russ@gmail.com>

This timer runs at a rate that can be calculated, well over 100MHz. It is
ideal for accurate timing and does not need interrupt servicing.

Tidy up some old broken and unneeded implementations at the same time.

To provide a consistent view of boot time, we use the same time
base as coreboot. Use the base timestamp supplied by coreboot
as U-Boot's base time.

Signed-off-by: Simon Glass <sjg@chromium.org>base
Signed-off-by: NSimon Glass <sjg@chromium.org>

The 'Starting linux' message appears twice in the code, but both call
through the same place. Unify these and add calls to bootstage to
mark the occasion.
Signed-off-by: NSimon Glass <sjg@chromium.org>
Reviewed-by: NMichael Spang <spang@chromium.org>
Acked-by: NGraeme Russ <graeme.russ@gmail.com>

panic_puts() can be called in early boot to display a message. It might
help with early debugging.
Signed-off-by: NSimon Glass <sjg@chromium.org>
Reviewed-by: NTom Wai-Hong Tam <waihong@chromium.org>

Several files use the global_data pointer without declaring it. This works
because the declaration is currently a NOP. But still it is better to
fix this so that x86 lines up with other archs.
Signed-off-by: NSimon Glass <sjg@chromium.org>

Since we use CONFIG_SYS_GENERIC_BOARD on x86, we don't need this anymore.
Signed-off-by: NSimon Glass <sjg@chromium.org>
Acked-by: NGraeme Russ <graeme.russ@gmail.com>

Since we don't have real-mode code now, we can remove this chunk of the link
script.
Signed-off-by: NSimon Glass <sjg@chromium.org>
Acked-by: NGraeme Russ <graeme.russ@gmail.com>

Graeme Russ pointed out that this code is no longer used. Remove it.
Signed-off-by: NSimon Glass <sjg@chromium.org>
Acked-by: NGraeme Russ <graeme.russ@gmail.com>

Commit 18652864 (Introduce generic link
section.h symbol files) changed the __bss_end symbol type from char[] to
ulong. This led to wrong relocation parameters which ended up in a not working
u-boot. Unfortunately this is not clear to see cause due to RAM aliasing we
may get a 'half-working' u-boot then.

Fix this by dereferencing the __bss_end symbol where needed.
Signed-off-by: NAndreas Bießmann <andreas.devel@googlemail.com>

The define should not have been put in fdt.h originally, libfdt_env.h
is the proper place for target-specific customizations.
Signed-off-by: NGerald Van Baren <vanbaren@cideas.com>

This commit adds a license header to fdt.h and libfdt_env.h
because the license was omitted.

U-Boot note: the u-boot libfdt_env.h header portion was not applied to
the u-boot libfdt_env.h because that file was created by Gerald Van Baren
(with a license header). - gvb

Ref: DTC commit 27cdc1b1
Signed-off-by: NJustin Sobota <jsobota@ti.com>
Acked-by: NDavid Gibson <david@gibson.dropbear.id.au>
Signed-off-by: NGerald Van Baren <vanbaren@cideas.com>