Add a sysreset driver for the MPC83xx platform.
Reviewed-by: NSimon Glass <sjg@chromium.org>
Signed-off-by: NMario Six <mario.six@gdsys.cc>

Add a RAM driver for the MPC83xx architecture.
Reviewed-by: NSimon Glass <sjg@chromium.org>
Signed-off-by: NMario Six <mario.six@gdsys.cc>

Add support for Texas Instruments' K3 Generation Processor
families.
Signed-off-by: NLokesh Vutla <lokeshvutla@ti.com>
Reviewed-by: NTom Rini <trini@konsulko.com>

FPGA subsystem requires special care that's why it should be maintained
via one tree.
Signed-off-by: NMichal Simek <michal.simek@xilinx.com>
Reviewed-by: NSimon Glass <sjg@chromium.org>

Add support for loading U-Boot on the Broadcom 7260 SoC.  This port
assumes Broadcom's BOLT bootloader is acting as the second stage
bootloader, and U-Boot is acting as the third stage bootloader, loaded
as an ELF program by BOLT.
Signed-off-by: NThomas Fitzsimmons <fitzsim@fitzsim.org>
Reviewed-by: NFlorian Fainelli <f.fainelli@gmail.com>
Cc: Florian Fainelli <f.fainelli@gmail.com>

Add new drivers
Add Christophe Kerello and myself as maintainers
Signed-off-by: NPatrice Chotard <patrice.chotard@st.com>

Add scattered driver files around the source tree
that belongs to Snapdragon arch. Not sure why they
were not included in the first place.
Signed-off-by: NRamon Fried <ramon.fried@gmail.com>

Create separate html pages for linker lists, the serial subsystem,
and the EFI subsystem.

Add a table of content.
Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de>

Avnet Ultra96 is rebranded Xilinx zcu100 revC/D. Add new defconfig files
and point to origin internal board name.
Signed-off-by: NMichal Simek <michal.simek@xilinx.com>

Signed-off-by: NEugeniy Paltsev <Eugeniy.Paltsev@synopsys.com>
Signed-off-by: NAlexey Brodkin <abrodkin@synopsys.com>

Scott is no longer maintaining the NAND subsystem, mark as orphaned for
now.
Acked-by: NScott Wood <oss@buserror.net>
Signed-off-by: NTom Rini <trini@konsulko.com>

lib/charset.c is only used by the EFI subsystem.
Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de>
Signed-off-by: NAlexander Graf <agraf@suse.de>

The Shared Memory Manager driver implements an interface for allocating
and accessing items in the memory area shared among all of the
processors in a Qualcomm platform.

Adapted from the Linux driver (4.17)

Changes from the original Linux driver:
* Removed HW spinlock mechanism, which is irrelevant
in U-boot particualar use case, which is just reading from the smem.
* Adapted from Linux driver model to U-Boot's.

Cc: Bjorn Andersson <bjorn.andersson@linaro.org>
Signed-off-by: NRamon Fried <ramon.fried@gmail.com>
Reviewed-by: NSimon Glass <sjg@chromium.org>

The Linux kernel has binding for gpio-restart node.
This patch is adding basic support without supporting any optional
properties.
This driver was tested on Microblaze system where gpio is connected to
SoC reset logic.
Output value is handled via gpios cells values.

In gpio_reboot_request() set_value is writing 1 because
dm_gpio_set_value() is capable to changing it when it is ACTIVE_LOW.
...
	if (desc->flags & GPIOD_ACTIVE_LOW)
		value = !value;
...
Signed-off-by: NMichal Simek <michal.simek@xilinx.com>
Reviewed-by: NPhilipp Tomsich <philipp.tomsich@theobroma-systems.com>
Reviewed-by: NSimon Glass <sjg@chromium.org>

Add support for loading U-Boot on the Broadcom 7445 SoC.  This port
assumes Broadcom's BOLT bootloader is acting as the second stage
bootloader, and U-Boot is acting as the third stage bootloader, loaded
as an ELF program by BOLT.
Signed-off-by: NThomas Fitzsimmons <fitzsim@fitzsim.org>
Cc: Stefan Roese <sr@denx.de>
Cc: Tom Rini <trini@konsulko.com>
Cc: Florian Fainelli <f.fainelli@gmail.com>

Add myself as the Maintainer for Actions Semi OWL family and its
relevant board, drivers.
Signed-off-by: NManivannan Sadhasivam <manivannan.sadhasivam@linaro.org>

Replace Mateusz as Maintainer for ARM Snapdragon arch.
Signed-off-by: NRamon Fried <ramon.fried@gmail.com>
Acked-by: NMateusz Kulikowski <mateusz.kulikowski@gmail.com>

With 'make htmldocs' we can generate a documentation if the function
comments follow the DocBook conventions.

This patch adjusts the comments for EFI boot services and provides the
DocBook template for the EFI subsystem.
Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de>
Signed-off-by: NAlexander Graf <agraf@suse.de>

As of today 'board/synopsys/' folder contains only Synopsys ARC
boards supported by the same people who support 'arch/arc'.
Signed-off-by: NAlexey Brodkin <abrodkin@synopsys.com>

Currently mvebu sata driver is in arch/arm/mach_mvebu directory, this
patch moves it to drivers/ata directory with renaming "sata.c" to
"ahci_mvebu.c" which is aligned to Linux.
New ahci driver's kconfig option is added as AHCI_MVEBU which selects
SCSI_AHCI and is based on AHCI.
Signed-off-by: NKen Ma <make@marvell.com>
Reviewed-by: NStefan Roese <sr@denx.de>
Reviewed-by: NSimon Glass <sjg@chromium.org>
Signed-off-by: NStefan Roese <sr@denx.de>

Add support of fuse command (read/write/program/sense)
on bank 0 to access to BSEC SAFMEM (4096 OTP bits).
Signed-off-by: NPatrick Delaunay <patrick.delaunay@st.com>
Signed-off-by: NPatrice Chotard <patrice.chotard@st.com>

Xilinx ZynqMP also contains dual Cortex R5 which can run U-Boot.
This patch is adding minimal support to get U-Boot boot.
U-Boot on R5 runs out of DDR with default configuration that's why
DDR needs to be partitioned if there is something else running on arm64.
Console is done via Cadence uart driver and the first Cadence Triple
Timer Counter is used for time.

This configuration with uart1 was tested on zcu100-revC.

U-Boot 2018.05-rc2-00021-gd058a08d907d (Apr 18 2018 - 14:11:27 +0200)

Model: Xilinx ZynqMP R5
DRAM:  512 MiB
WARNING: Caches not enabled
MMC:
In:    serial@ff010000
Out:   serial@ff010000
Err:   serial@ff010000
Net:   Net Initialization Skipped
No ethernet found.
ZynqMP r5>

There are two ways how to run this on ZynqMP.
1. Run from ZynqMP arm64
tftpb 20000000 u-boot-r5.elf
setenv autostart no && bootelf -p 20000000
cpu 4 disable && cpu 4 release 10000000 lockstep
or
cpu 4 disable && cpu 4 release 10000000 split

2. Load via jtag when directly to R5
Signed-off-by: NMichal Simek <michal.simek@xilinx.com>

The zynqmpimage.c and the new zynqmpbif.c files are all maintained by
Xilinx for the Zynq platforms. Let's match them accordingly
in the MAINTAINERS file.
Signed-off-by: NAlexander Graf <agraf@suse.de>
Signed-off-by: NMichal Simek <michal.simek@xilinx.com>

Point to Zynqmp arm64 cpu folder not to Zynq arm32.
Signed-off-by: NMichal Simek <michal.simek@xilinx.com>

This driver was tested on Xilinx ZynqMP SoC.
Signed-off-by: NMichal Simek <michal.simek@xilinx.com>

freescale.com domain is no longer reachable, so switch the
maintainers' emails to nxp.com domain instead.
Signed-off-by: NFabio Estevam <fabio.estevam@nxp.com>

Update ARC architecture maintainers and add
uboot-snps-arc@synopsys.com mailing list.
Signed-off-by: NEugeniy Paltsev <Eugeniy.Paltsev@synopsys.com>
Signed-off-by: NAlexey Brodkin <abrodkin@synopsys.com>

Provide correct file paths.
Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de>
Reviewed-by: NPatrick Delaunay <patrick.delaunay@st.com>

Replace references to non-existent file.

Cc: Michal Simek <michal.simek@xilinx.com>
Cc: Michal Simek <monstr@monstr.eu>
Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de>
Signed-off-by: NMichal Simek <michal.simek@xilinx.com>

Fix c&p error from Zynq.
Signed-off-by: NMichal Simek <michal.simek@xilinx.com>

Provides information about

- usage of the bootefi command
- overview of UEFI
- interaction between U-Boot and EFI drivers
Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de>
Reviewed-by: NLeif Lindholm <leif.lindholm@linaro.org>
Acked-by: NLeif Lindholm <leif.lindholm@linaro.org>
Signed-off-by: NAlexander Graf <agraf@suse.de>

The Rockchip-specific wrappers to the DW-MMC and the SDHCI driver
were not covered as part of what's maintained by the architecture
maintainers.  Add them here.
Signed-off-by: NPhilipp Tomsich <philipp.tomsich@theobroma-systems.com>

Fix my fragments to list all files in the repo.

Also fix path to for Xilinx Zynq SoC (mach-zynq)
It should be the part of
"ARM: zynq: move SoC sources to mach-zynq"
(sha1: 0107f240)

And cover dts files in board MAINTAINERS files.
Reported-by: NHeinrich Schuchardt <xypron.glpk@gmx.de>
Signed-off-by: NMichal Simek <michal.simek@xilinx.com>

ppc4xx support was removed some time ago. Lets remove the now unused
entry in MAINTAINERS as well.
Signed-off-by: NStefan Roese <sr@denx.de>
Cc: Heinrich Schuchardt <xypron.glpk@gmx.de>

add RCC clock driver for STMP32MP157
- base on driver model = UCLASS_CLK
- support ops to enable, disable and get rate
  of all SOC clock needed by U-Boot
Signed-off-by: NPatrick Delaunay <patrick.delaunay@st.com>

Add driver and binding for stm32mp1 ddr controller and phy
Signed-off-by: NPatrick Delaunay <patrick.delaunay@st.com>

- add new arch stm32mp for STM32 MPU/Soc based on Cortex A
- support for stm32mp157 SOC
- SPL is used as first boot stage loader
- using driver model for all the drivers, even in SPL
- all security feature are deactivated (ETZC and TZC)
- reused STM32 MCU drivers when it is possible
Signed-off-by: NPatrick Delaunay <patrick.delaunay@st.com>

Remove a link to a non-existent file.
Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de>
Acked-by: NAndrew F. Davis <afd@ti.com>

Remove non-existing paths.
Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de>

Remove non-existing directories.
Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de>
Acked-by: NMinkyu Kang <mk7.kang@samsung.com>