u-boot is trying to make CONFIG_BLK as a hard requirement
for DM_MMC. But now it's still not.

config BLK
	bool "Support block devices"
	depends on DM
	default y if DM_MMC

When fsl_esdhc driver was reworked for DM_MMC support, DM_MMC
without CONFIG_BLK enabled wasn't considered. This patch is to
fix probe issue without CONFIG_BLK enabled.
Signed-off-by: NYangbo Lu <yangbo.lu@nxp.com>
Signed-off-by: NYinbo Zhu <yinbo.zhu@nxp.com>
Reviewed-by: NPrabhakar Kushwaha <prabhakar.kushwaha@nxp.com>

Layerscape began to use two eSDHC controllers, for example,
LS1028A. They are same IP block with same reference clock.
This patch is to add clock support for the second eSDHC.
Signed-off-by: NYangbo Lu <yangbo.lu@nxp.com>
Signed-off-by: NYinbo Zhu <yinbo.zhu@nxp.com>
Reviewed-by: NPrabhakar Kushwaha <prabhakar.kushwaha@nxp.com>

Change sata node status to enable sata.
Signed-off-by: NPeng Ma <peng.ma@nxp.com>
Reviewed-by: NPrabhakar Kushwaha <prabhakar.kushwaha@nxp.com>

Add other serdes protocal support.
Signed-off-by: NXiaowei Bao <xiaowei.bao@nxp.com>
Reviewed-by: NPrabhakar Kushwaha <prabhakar.kushwaha@nxp.com>

Rx Compliance tests may fail intermittently at high jitter
frequencies using default register values.

So program register USB_PHY_RX_OVRD_IN_HI in certain sequence
to make the Rx compliance test pass.
Signed-off-by: NYinbo Zhu <yinbo.zhu@nxp.com>
Signed-off-by: NRan Wang <ran.wang_1@nxp.com>
Reviewed-by: NPrabhakar Kushwaha <prabhakar.kushwaha@nxp.com>

Enable workaround for USB erratum A-008997. Here PCSTXSWINGFULL
registers has been moved to DSCR as compared to other Layerscape SoCs
where it was in SCFG.
Signed-off-by: NRan Wang <ran.wang_1@nxp.com>
Reviewed-by: NPrabhakar Kushwaha <prabhakar.kushwaha@nxp.com>

when compiling dts file using DTC_FLAG='-@', the device tree compiler
reports these warnings:

Warning (alias_paths): /aliases: aliases property name must include
only lowercase and '-'

Fixed the node aliases to silence these warnings.
Signed-off-by: NPankaj Bansal <pankaj.bansal@nxp.com>
Reviewed-by: NPrabhakar Kushwaha <prabhakar.kushwaha@nxp.com>

Pull request for UEFI sub-system for v2019.07-rc5 (2)

This pull request provides bug fixes for the UEFI sub-system. The most
relevant one concerns the allocation of memory at address 0. It is
needed for booting Linux on several boards via bootefi, e.g. the Asus
TinkerBoard.

An undefined reference bug in disk/part.c related to a division is
resolved.

- SPL size check for Gen5, i2c enablement for S10

- More board removal

- Kconfig migrations of SPL_BOOT_xxx, SYS_LDSCRIPT, IP_DEFRAG,
  TFTP_BLOCKSIZE.
- Typo fixes, other minor corrections.

The setexpr shell command calls cmd_get_data_size() which is only built
when CMD_DATA_SIZE is defined. We need to define CMD_DATA_SIZE if
CONFIG_CMD_SETEXPR is selected or the build will fail if no other
command selecting this option is enabled.
Signed-off-by: NBartosz Golaszewski <bgolaszewski@baylibre.com>

In order to migrate this symbol to Kconfig introduce a new symbol to
guard it, CONFIG_SYS_CUSTOM_LDSCRIPT.  When that is set we can then
provide the exact final location o the script.
Signed-off-by: NTom Rini <trini@konsulko.com>

A number of boards set CONFIG_SYS_LDSCRIPT and then end up using one of
the default searched LDSCRIPT paths.  Remove these customizations.
Signed-off-by: NTom Rini <trini@konsulko.com>

The non-CONFIG_SPL_FRAMEWORK SPL used on some PowerPC platforms have a
choice between CONFIG_SPL_NAND_BOOT, CONFIG_SPL_MMC_BOOT and
CONFIG_SPL_SPI_BOOT.  Migrate this to Kconfig
Signed-off-by: NTom Rini <trini@konsulko.com>

Signed-off-by: NAndy Shevchenko <andriy.shevchenko@linux.intel.com>

This tool has just been added but it seems I forgot to add it to
the ignore list. So to prevent the built binary being marked as
unversioned, add it to the ignore list.
Signed-off-by: NSimon Goldschmidt <simon.k.r.goldschmidt@gmail.com>

Convert CONFIG_TFTP_BLOCKSIZE to Kconfig, update defconfigs,
headers and whitelist.
Signed-off-by: NMarek Vasut <marek.vasut+renesas@gmail.com>
Cc: Christian Gmeiner <christian.gmeiner@gmail.com>
Cc: Joe Hershberger <joe.hershberger@ni.com>

Convert CONFIG_IP_DEFRAG to Kconfig, update defconfigs, headers
and whitelist. This patch is a follow-up on a patch by Christian
Gmeiner with the added config/header/whitelist updates.
Signed-off-by: NMarek Vasut <marek.vasut+renesas@gmail.com>
Reported-by: NChristian Gmeiner <christian.gmeiner@gmail.com>
Cc: Joe Hershberger <joe.hershberger@ni.com>

The SetAttribute() service and the Reset() service of the simple text
output protocol must update the attribute value in the mode information.
Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de>

Correct the check of the mode number in SetMode() service of the simple
text output protocol.

Clear the screen in SetMode().
Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de>

If the GetTime() runtime service is not supported, EFI_UNSUPPORTED has to
be returned.
Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de>

This variable is defined in UEFI specification 2.8, section 8.1.
Its value should be updated whenever we add any usable runtime services
function.

Currently we only support SetVirtualAddress() for all systems and
ResetSystem() for some.
Signed-off-by: NAKASHI Takahiro <takahiro.akashi@linaro.org>
Reviewed-by: NHeinrich Schuchardt <xypron.glpk@gmx.de>

Return EFI_INVALID_PARAMETER if the variable name has zero length or the
variable has runtime access but not boottime access.
Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de>

When compiling with FTRACE=1 an error

ld.bfd: disk/built-in.o: in function `lba512_muldiv':
disk/part.c:114: undefined reference to `__udivmoddi4

occurred.

Use '>> 11' instead of '/ 2048' to avoid the division.
Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de>

The UEFI specification does not specify if the characters that have to be
replaced by underscore in function StrToFat() of the Unicode collation
protocol are those forbidden in FAT long names or those in FAT short names.
EDK2 and UEFI SCT assume it is those forbidden in FAT 8.3 short names.

Adjust the list of forbidden characters.
Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de>

The MetaiMatch() service of the UnicodeCollationProtocol2 must be case
insensitive.
Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de>

It must be possible to allocate memory at address 0 with AllocatePages().

Move a NULL pointer check.
Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de>

Always use EFI_EXIT() to return from the function.
Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de>

If an image already has been started, return EFI_INVALID_PARAMETER when
StartImage() is called for the same handle again.
Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de>

If the file path does not relate to an existing file, LoadImage() must
return EFI_NOT_FOUND.
Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de>

If both SourceBuffer and DevicePath are NULL, LoadImage() must return
EFI_INVALID_PARAMETER.
Signed-off-by: NHeinrich Schuchardt <xypron.glpk@gmx.de>

Change my email address, too many mails
gets to my private mail, created specific email
account just for developmement.
Signed-off-by: NRamon Fried <ramon.fried@gmail.com>

Last change to this board was done in 2016, has no prospects of
ever being converted to DM, drop it.
Signed-off-by: NMarek Vasut <marek.vasut+renesas@gmail.com>
Cc: Chris Brandt <chris.brandt@renesas.com>
Cc: Nobuhiro Iwamatsu <iwamatsu@nigauri.org>
Cc: Vladimir Zapolskiy <vz@mleia.com>
Cc: Yoshihiro Shimoda <shimoda.yoshihiro.uh@renesas.com>

Last change to this board was done in 2016, has no prospects of
ever being converted to DM, drop it.
Signed-off-by: NMarek Vasut <marek.vasut+renesas@gmail.com>
Cc: Chris Brandt <chris.brandt@renesas.com>
Cc: Nobuhiro Iwamatsu <iwamatsu@nigauri.org>
Cc: Vladimir Zapolskiy <vz@mleia.com>
Cc: Yoshihiro Shimoda <shimoda.yoshihiro.uh@renesas.com>

Last change to this board was done in 2016, has no prospects of
ever being converted to DM, drop it.
Signed-off-by: NMarek Vasut <marek.vasut+renesas@gmail.com>
Cc: Chris Brandt <chris.brandt@renesas.com>
Cc: Nobuhiro Iwamatsu <iwamatsu@nigauri.org>
Cc: Vladimir Zapolskiy <vz@mleia.com>
Cc: Yoshihiro Shimoda <shimoda.yoshihiro.uh@renesas.com>

Last change to this board was done in 2016, has no prospects of
ever being converted to DM, drop it.
Signed-off-by: NMarek Vasut <marek.vasut+renesas@gmail.com>
Cc: Chris Brandt <chris.brandt@renesas.com>
Cc: Nobuhiro Iwamatsu <iwamatsu@nigauri.org>
Cc: Vladimir Zapolskiy <vz@mleia.com>
Cc: Yoshihiro Shimoda <shimoda.yoshihiro.uh@renesas.com>

Last change to this board was done in 2016, has no prospects of
ever being converted to DM, drop it.
Signed-off-by: NMarek Vasut <marek.vasut+renesas@gmail.com>
Cc: Chris Brandt <chris.brandt@renesas.com>
Cc: Nobuhiro Iwamatsu <iwamatsu@nigauri.org>
Cc: Vladimir Zapolskiy <vz@mleia.com>
Cc: Yoshihiro Shimoda <shimoda.yoshihiro.uh@renesas.com>

Last change to this board was done in 2016, has no prospects of
ever being converted to DM, drop it.
Signed-off-by: NMarek Vasut <marek.vasut+renesas@gmail.com>
Cc: Chris Brandt <chris.brandt@renesas.com>
Cc: Nobuhiro Iwamatsu <iwamatsu@nigauri.org>
Cc: Vladimir Zapolskiy <vz@mleia.com>
Cc: Yoshihiro Shimoda <shimoda.yoshihiro.uh@renesas.com>

This provides an SPL_SIZE_LIMIT that makes the build check that the SPL
binary loaded from flash fits into the SRAM (64 KiB) and leaves enough
room for global data, heap  and stack (512 bytes assumed stack usage).
Signed-off-by: NSimon Goldschmidt <simon.k.r.goldschmidt@gmail.com>