- 26 6月, 2013 16 次提交
-
-
由 Simon Glass 提交于
Use -finstrument-functions when tracing is enabled (make FTRACE=1). Tracing is not currently supported by SPL even if sufficient memory is available. When tracing is enabled, we #define FTRACE. This can be used by board config files to conditionally enable the tracing options. Signed-off-by: NSimon Glass <sjg@chromium.org>
-
由 Simon Glass 提交于
Add a trace command with sub-commands to start/stop tracing, print out statistics and dump trace information to memory for later upload to a host. Signed-off-by: NSimon Glass <sjg@chromium.org>
-
由 Simon Glass 提交于
Add a library which supports tracing of execution using built-in gcc features and a microsecond timer. This can be used to record a list of function which are executed, along with a timestamp for each. Later this information can be sent to the host for processing. Signed-off-by: NSimon Glass <sjg@chromium.org>
-
由 Simon Glass 提交于
Move bootstage's numbering printing code into a generic place so that it can be used by tracing also. Signed-off-by: NSimon Glass <sjg@chromium.org>
-
由 Simon Glass 提交于
The unstash code is a bit loose with its printf() types, which gives warnings on sandbox. Correct this. Signed-off-by: NSimon Glass <sjg@chromium.org>
-
由 Simon Glass 提交于
When this test fails it is useful to see the output from U-Boot. Add printing of this information on failure. Signed-off-by: NSimon Glass <sjg@chromium.org>
-
由 Simon Glass 提交于
For some reason this does not normally cause a compiler warning, but the code seems to be incorrect. Add the missing return. Signed-off-by: NSimon Glass <sjg@chromium.org>
-
由 Simon Glass 提交于
Enabling FIT produces a compile error. Fix this. Signed-off-by: NSimon Glass <sjg@chromium.org>
-
由 Simon Glass 提交于
I am not sure of the meaning of extern inline, but this gives errors when building with function instrumenting enabled. Change these functions to static inline. Signed-off-by: NSimon Glass <sjg@chromium.org>
-
由 Hung-ying Tyan 提交于
This patch initiates cros-ec in board_init() to enable it for smdk5250. This patch depends on the patch in the MMC series that brings in exynos5-dt.c. Refer to http://patchwork.ozlabs.org/patch/240084. Signed-off-by: NSimon Glass <sjg@chromium.org> Signed-off-by: NVincent Palatin <vpalatin@chromium.org> Signed-off-by: NHung-ying Tyan <tyanh@chromium.org> Acked-by: NSimon Glass <sjg@chromium.org>
-
由 Hung-ying Tyan 提交于
This patch adds cros-ec related device nodes to exynos5250-snow.dts. It also adds a gpio node to exynos5250.dtsi. Signed-off-by: NHung-ying Tyan <tyanh@chromium.org> Acked-by: NSimon Glass <sjg@chromium.org>
-
由 Hung-ying Tyan 提交于
This patch adds the driver for keyboard that's controlled by ChromeOS EC. Signed-off-by: NRandall Spangler <rspangler@chromium.org> Signed-off-by: NSimon Glass <sjg@chromium.org> Signed-off-by: NVincent Palatin <vpalatin@chromium.org> Signed-off-by: NHung-ying Tyan <tyanh@chromium.org> Acked-by: NSimon Glass <sjg@chromium.org>
-
由 Hung-ying Tyan 提交于
This patch adds LPC support for carrying out the cros_ec protocol. Signed-off-by: NRandall Spangler <rspangler@chromium.org> Signed-off-by: NSimon Glass <sjg@chromium.org> Signed-off-by: NHung-ying Tyan <tyanh@chromium.org> Acked-by: NSimon Glass <sjg@chromium.org> Tested-by: NSimon Glass <sjg@chromium.org>
-
由 Hung-ying Tyan 提交于
This patch adds SPI support for carrying out the cros_ec protocol. Signed-off-by: NHung-ying Tyan <tyanh@chromium.org> Signed-off-by: NRandall Spangler <rspangler@chromium.org> Signed-off-by: NSimon Glass <sjg@chromium.org> Acked-by: NSimon Glass <sjg@chromium.org>
-
由 Hung-ying Tyan 提交于
This patch adds I2C support for carrying out the cros_ec protocol. Signed-off-by: NRandall Spangler <rspangler@chromium.org> Signed-off-by: NSimon Glass <sjg@chromium.org> Signed-off-by: NHung-ying Tyan <tyanh@chromium.org> Acked-by: NSimon Glass <sjg@chromium.org> Tested-by: NSimon Glass <sjg@chromium.org>
-
由 Hung-ying Tyan 提交于
This patch adds the cros_ec driver that implements the protocol for communicating with Google's ChromeOS embedded controller. Signed-off-by: NBernie Thompson <bhthompson@chromium.org> Signed-off-by: NBill Richardson <wfrichar@chromium.org> Signed-off-by: NChe-Liang Chiou <clchiou@chromium.org> Signed-off-by: NDoug Anderson <dianders@chromium.org> Signed-off-by: NGabe Black <gabeblack@chromium.org> Signed-off-by: NHung-ying Tyan <tyanh@chromium.org> Signed-off-by: NLouis Yung-Chieh Lo <yjlou@chromium.org> Signed-off-by: NRandall Spangler <rspangler@chromium.org> Signed-off-by: NSean Paul <seanpaul@chromium.org> Signed-off-by: NSimon Glass <sjg@chromium.org> Signed-off-by: NVincent Palatin <vpalatin@chromium.org> Acked-by: NSimon Glass <sjg@chromium.org> Tested-by: NSimon Glass <sjg@chromium.org>
-
- 25 6月, 2013 24 次提交
-
-
-
由 Heiko Schocher 提交于
add atheros ar803x phy, used on the upcoming siemens boards. Signed-off-by: NHeiko Schocher <hs@denx.de> Cc: Andy Fleming <afleming@freescale.com> Cc: Joe Hershberger <joe.hershberger@gmail.com>
-
由 Heiko Schocher 提交于
add natsemi dp83630 phy, used on the upcoming siemens boards. Signed-off-by: NHeiko Schocher <hs@denx.de> Cc: Andy Fleming <afleming@freescale.com> Cc: Joe Hershberger <joe.hershberger@gmail.com>
-
由 Kuo-Jung Su 提交于
Signed-off-by: NKuo-Jung Su <dantesu@faraday-tech.com> CC: Joe Hershberger <joe.hershberger@gmail.com> CC: Tom Rini <trini@ti.com>
-
由 Kuo-Jung Su 提交于
Faraday FTMAC110 10/100Mbps supports half-word data transfer for Linux. However it has a weird DMA alignment issue: (1) Tx DMA Buffer Address: 1 bytes aligned: Invalid 2 bytes aligned: O.K 4 bytes aligned: O.K (2) Rx DMA Buffer Address: 1 bytes aligned: Invalid 2 bytes aligned: O.K 4 bytes aligned: Invalid!!! Signed-off-by: NKuo-Jung Su <dantesu@faraday-tech.com> Cc: Joe Hershberger <joe.hershberger@gmail.com> Cc: Tom Rini <trini@ti.com>
-
由 SARTRE Leo 提交于
Add function ksz9031_phy_extended_write and ksz9031_phy_extended_read Signed-off-by: NLeo Sartre <lsartre@adeneo-embedded.com>
-
由 Bo Shen 提交于
Add gigabit MAC support in macb driver - using IP version to distinguish whether MAC is GMAC Signed-off-by: NBo Shen <voice.shen@atmel.com>
-
由 Bo Shen 提交于
using phylib to configure phy device in macb driver Signed-off-by: NBo Shen <voice.shen@atmel.com>
-
由 Bo Shen 提交于
Using CONFIG_AT91FAMILY replace #ifdeferry for atmel SoC Signed-off-by: NBo Shen <voice.shen@atmel.com> Acked-by: NAndreas Bießmann <andreas.devel@googlemail.com>
-
由 Bo Shen 提交于
add network support with ksz8851_16mll on at91sam9n12ek board Signed-off-by: NBo Shen <voice.shen@atmel.com> Acked-by: NAndreas Bießmann <andreas.devel@googlemail.com>
-
由 Roberto Cerati 提交于
The device interface is 16 bits wide. All the available packets are read from the incoming fifo. Signed-off-by: NRoberto Cerati <roberto.cerati@bticino.it> Signed-off-by: NRaffaele Recalcati <raffaele.recalcati@bticino.it> [voice.shen@atmel.com: address comments from review results] [voice.shen@atmel.com: clean up for submit] Signed-off-by: NBo Shen <voice.shen@atmel.com> Tested-by: NRaffaele Recalcati <raffaele.recalcati@bticino.it>
-
由 Xie Xiaobo 提交于
Signed-off-by: NXie Xiaobo <X.Xie@freescale.com>
-
由 Charles Coldwell 提交于
commit 39695029bc15041c809df3db4ba19bd729c447fa Author: Charles Coldwell <coldwell@ll.mit.edu> Date: Tue Feb 19 08:27:33 2013 -0500 Changes to support the Xilinx 1000BASE-X phy (GTX/MGT) Signed-off-by: NCharles Coldwell <coldwell@ll.mit.edu>
-
由 Joe Hershberger 提交于
Make the link-local code conform more completely with the RFC. This will prevent ARP queries for the target (such as while it is rebooting) from causing the device to choose a different link-local address, thinking that its address is in use by another machine. Signed-off-by: NJoe Hershberger <joe.hershberger@ni.com>
-
由 David Andrey 提交于
Add support for Micrel PHY KSZ9031 in phylib, including small rework for KSZ9021 to avoid code duplication Signed-off-by: NDavid Andrey <david.andrey@netmodule.com> Cc: Troy Kisky <troy.kisky@boundarydevices.com> Cc: Joe Herschberger <joe.hershberger@gmail.com> Cc: Andy Fleming <afleming@freescale.com> Acked-by: NStefan Roese <sr@denx.de>
-
由 Kim Phillips 提交于
tftp.c:464:17: warning: cast to restricted __be16 tftp.c:552:29: warning: cast to restricted __be16 tftp.c:640:33: warning: cast to restricted __be16 tftp.c:642:25: warning: cast to restricted __be16 Signed-off-by: NKim Phillips <kim.phillips@freescale.com> Cc: Joe Hershberger <joe.hershberger@gmail.com>
-
由 Kim Phillips 提交于
for use with sparse. Signed-off-by: NKim Phillips <kim.phillips@freescale.com> Cc: Joe Hershberger <joe.hershberger@gmail.com>
-
由 Joe Hershberger 提交于
The added weak symbol must not be static. This was introduced in 416ce623Signed-off-by: NJoe Hershberger <joe.hershberger@ni.com>
-
由 Shiraz Hashim 提交于
SPEAr310 and SPEAr320 Ethernet interfaces share same MDIO lines to control their respective phys. Currently there is a fixed configuration in which only a particular MAC can use the MDIO lines. Call an arch specific function to take control of specific mdio lines at runtime. Signed-off-by: NShiraz Hashim <shiraz.hashim@st.com> Signed-off-by: NVipin Kumar <vipin.kumar@st.com> Acked-by: NStefan Roese <sr@denx.de>
-
由 Vipin Kumar 提交于
Do not select MIIPORT for RGMII interface Signed-off-by: NVipin Kumar <vipin.kumar@st.com> Acked-by: NStefan Roese <sr@denx.de>
-
由 Matthias Brugger 提交于
This patch tackles the time out problem which leads to break the boot process, when loading file over nfs. The patch does two things. First of all, we just ignore messages that arrive with a rpc_id smaller then the client id. We just interpret this messages as answers to formaly timed out messages. Second, when a time out occurs we double the time to wait, so that we do not stress the server resending the last message. Signed-off-by: NMatthias Brugger <matthias.bgg@gmail.com> Tested-by: NEnric Balletbo i Serra <eballetbo@gmail.com>
-
由 Sebastian Hesselbarth 提交于
Marvell Dove also uses mvgbe as ethernet driver, therefore add support for Dove to reuse the current driver. Signed-off-by: NSebastian Hesselbarth <sebastian.hesselbarth@gmail.com>
-
由 Sebastian Hesselbarth 提交于
This add phylib support to the Marvell GBE driver. Signed-off-by: NSebastian Hesselbarth <sebastian.hesselbarth@gmail.com>
-
由 Sebastian Hesselbarth 提交于
This adds PHY initialization for Marvell Alaska 88E1310 PHY. Signed-off-by: NSebastian Hesselbarth <sebastian.hesselbarth@gmail.com>
-