- 28 9月, 2016 2 次提交
-
-
由 Sriram Dash 提交于
Currently the controller by default enables the Receive Detect feature in P3 mode in USB 3.0 PHY. However, USB 3.0 PHY does not reliably support receive detection in P3 mode. Enabling the USB3 controller to configure USB in P2 mode whenever the Receive Detect feature is required. Signed-off-by: NSriram Dash <sriram.dash@nxp.com> Signed-off-by: NRajesh Bhagat <rajesh.bhagat@nxp.com>
-
由 Sriram Dash 提交于
This is required for better performance, and performs below tuning: 1. Enable burst length set, and define it as 4/8/16. 2. Set burst request limit to 16 requests. Signed-off-by: NRajesh Bhagat <rajesh.bhagat@nxp.com> Signed-off-by: NSriram Dash <sriram.dash@nxp.com>
-
- 24 9月, 2016 2 次提交
-
-
由 Masahiro Yamada 提交于
Now, include/linux/errno.h is a wrapper of <asm-generic/errno.h>. Replace all include directives for <asm-generic/errno.h> with <linux/errno.h>. <asm-generic/...> is supposed to be included from <asm/...> when arch-headers fall back into generic implementation. Generally, they should not be directly included from .c files. Signed-off-by: NMasahiro Yamada <yamada.masahiro@socionext.com> [trini: Add drivers/usb/host/xhci-rockchip.c] Signed-off-by: NTom Rini <trini@konsulko.com>
-
由 Masahiro Yamada 提交于
This makes functions much simpler. Signed-off-by: NMasahiro Yamada <yamada.masahiro@socionext.com>
-
- 08 8月, 2016 1 次提交
-
-
由 Rajesh Bhagat 提交于
Adds code to use driver model for USB XHCI FSL driver Signed-off-by: NRajesh Bhagat <rajesh.bhagat@nxp.com>
-
- 13 6月, 2016 1 次提交
-
-
由 Sriram Dash 提交于
This patch is doing the following: 1. Implementing the errata for LS2080. 2. Adding fixup for fdt for LS2080. Signed-off-by: NSriram Dash <sriram.dash@nxp.com> Signed-off-by: NRajesh Bhagat <rajesh.bhagat@nxp.com>
-
- 07 12月, 2015 1 次提交
-
-
由 Rajesh Bhagat 提交于
This patch removes unsued function usb_phy_reset, rather common function dwc3_phy_reset is used. Signed-off-by: NRajesh Bhagat <rajesh.bhagat@freescale.com>
-
- 22 7月, 2015 4 次提交
-
-
由 Nikhil Badola 提交于
Remove LS102XA immap header inclusion from xhci fsl driver. It removes redefinition warnings when built for platforms other than LS102XA Signed-off-by: NNikhil Badola <nikhil.badola@freescale.com>
-
由 Nikhil Badola 提交于
This adjusts (micro)frame length to appropriate value thus avoiding USB devices to time out over a longer run Signed-off-by: NNikhil Badola <nikhil.badola@freescale.com>
-
由 Nikhil Badola 提交于
Replace uint32_t with uintptr_t to remove compilation warnings for 64-bit architectures. Signed-off-by: NNikhil Badola <nikhil.badola@freescale.com>
-
由 Ramneek Mehresh 提交于
Add xhci driver support for all FSL socs Signed-off-by: NRamneek Mehresh <ramneek.mehresh@freescale.com>
-