- 28 8月, 2013 1 次提交
-
-
由 Tom Rini 提交于
Signed-off-by: NTom Rini <trini@ti.com>
-
- 16 8月, 2013 1 次提交
-
-
由 Tom Rini 提交于
Update omap5_common.h to use ti_armv7_common.h, and in turn update dra7xx_evm.h and omap5_uevm.h slightly. The biggest changes here are that IP blocks which exist on the platform, and had clocks enabled, now have the drivers being built as well. Signed-off-by: NTom Rini <trini@ti.com>
-
- 27 7月, 2013 1 次提交
-
-
由 Mugunthan V N 提交于
Enabling CPSW Ethernet support in DRA7xx EVM. Signed-off-by: NMugunthan V N <mugunthanvnm@ti.com>
-
- 24 7月, 2013 1 次提交
-
-
由 Wolfgang Denk 提交于
Signed-off-by: NWolfgang Denk <wd@denx.de> [trini: Fixup common/cmd_io.c] Signed-off-by: NTom Rini <trini@ti.com>
-
- 18 6月, 2013 1 次提交
-
-
由 Dan Murphy 提交于
Update the EXTRA_ENV_SETTING for the dra7xx. The console needs to be set to ttyO0 and the findfdt needs to be updated to load the dra7xx-evm.dtb file. Signed-off-by: NDan Murphy <dmurphy@ti.com> Reviewed-by: NTom Rini <trini@ti.com>
-
- 10 6月, 2013 3 次提交
-
-
由 Lokesh Vutla 提交于
Update PLL values. SYS_CLKSEL value for 20MHz is changed to 2. In other platforms SYS_CLKSEL value 2 represents reserved. But in sys_clk array ind 1 is used for 13Mhz. Since other platforms are not using 13Mhz, reusing index 1 for 20MHz. Signed-off-by: NLokesh Vutla <lokeshvutla@ti.com> Signed-off-by: NSricharan R <r.sricharan@ti.com>
-
由 Sricharan R 提交于
Serial UART is connected to UART1. So add the change for the same. Signed-off-by: NSricharan R <r.sricharan@ti.com>
-
由 Lokesh Vutla 提交于
The registers that are used for device identification are changed from OMAP5 to DRA7xx. Using the correct registers for DRA7xx. Signed-off-by: NLokesh Vutla <lokeshvutla@ti.com>
-
- 08 4月, 2013 1 次提交
-
-
由 Tom Rini 提交于
The omap5_uevm platform has eMMC, and it makes sense to say that our default env storage shall reside there. Other platforms may not, so move this choice to the EVM config. In addition, we should provide some way to partition the flash for later usage, so take advantage of the GPT partition table support code and allow that to be setup with some reasonable defaults. Cc: Sricharan R <r.sricharan@ti.com> Signed-off-by: NTom Rini <trini@ti.com>
-
- 11 3月, 2013 1 次提交
-
-
由 Lokesh Vutla 提交于
Adding the build support for dra7xx_evm. Reusing omap5_evm.h config by moving it to omap5_common.h Signed-off-by: NLokesh Vutla <lokeshvutla@ti.com> Signed-off-by: NR Sricharan <r.sricharan@ti.com>
-
- 13 4月, 2010 1 次提交
-
-
由 Peter Tyser 提交于
Now that the other architecture-specific lib directories have been moved out of the top-level directory there's not much reason to have the '_generic' suffix on the common lib directory. Signed-off-by: NPeter Tyser <ptyser@xes-inc.com>
-
- 22 7月, 2009 1 次提交
-
-
由 Luigi 'Comio' Mantellini 提交于
Signed-off-by: NLuigi 'Comio' Mantellini <luigi.mantellini@idf-hit.com>
-
- 13 9月, 2008 1 次提交
-
-
由 Luigi 'Comio' Mantellini 提交于
Signed-off-by: NLuigi 'Comio' Mantellini <luigi.mantellini@idf-hit.com> Signed-off-by: NJean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
-
- 31 10月, 2002 1 次提交
-
-
由 wdenk 提交于
-
- 09 9月, 2002 1 次提交
-
-
由 wdenk 提交于
-
- 14 12月, 2000 1 次提交
-
-
由 wdenk 提交于
-
- 13 11月, 2000 1 次提交
-
-
由 wdenk 提交于
-